Searched full:put (Results 1 – 25 of 256) sorted by relevance
1234567891011
| /Documentation/power/ |
| D | pci.rst | 34 Usually, a device is put into a low-power state when it is underutilized or
36 again, it has to be put back into the "fully functional" state (full-power
41 PCI devices may be put into low-power states in two ways, by using the device
53 to put the device that sent it into the full-power state. However, the PCI Bus
111 programmatically put into D0. Thus the kernel can switch the device back and
169 set of power resources that have to be enabled for the device to be put into
174 To put a device into the ACPI power state Dx (where x is a number between 0 and
178 is going to be put into a low-power state (D1-D3) and is supposed to generate
184 only be put into D0 this way.
190 determines the highest power (lowest number) state the device can be put
[all …]
|
| /Documentation/vm/ |
| D | cleancache.rst | 18 put the data contained in that page into "transcendent memory", memory
79 Note that cleancache must enforce put-put-get coherency and get-get
81 with different data, say AAA by the first put and BBB by the second, a
84 never succeed unless preceded by a successful put with that handle.
198 of the pageframe) before the cleancache get/put call returns,
209 the page can be "put" immediately following the "get". If
210 put-after-get for inclusive becomes common, the interface could
|
| /Documentation/devicetree/bindings/i2c/ |
| D | i2c-gpio.yaml | 57 description: this means that something outside of our control has put
64 description: this means that something outside of our control has put the
|
| /Documentation/admin-guide/acpi/ |
| D | initrd_table_override.rst | 70 # They must be put into a /kernel/firmware/acpi directory inside the cpio
71 # archive. Note that if the table put here matches a platform table
74 # this table. If the table put here doesn't match a platform table
|
| /Documentation/cdrom/ |
| D | packet-writing.rst | 34 the so called "restricted overwrite" mode. To put a disc in restricted
50 that it should be possible to put any filesystem with a block size >=
92 device with a 2KB block size, you can put any filesystem you like on
|
| /Documentation/devicetree/bindings/net/ |
| D | smsc-lan91c111.txt | 16 - pxa-u16-align4 : Boolean, put in place the workaround the force all
|
| /Documentation/admin-guide/pm/ |
| D | sleep-states.rst | 79 energy savings as everything in the system is put into a low-power state, except
89 suspended and put into low-power states. In many cases, all peripheral buses
118 It takes three system state changes to put it into hibernation and two system
204 Put the system into a special low-power state (e.g. ACPI S4) to
210 mechanism to put the system to sleep after creating a
221 Hybrid system suspend. Put the system into the suspend sleep
|
| D | suspend-flows.rst | 65 put into uninterruptible sleep until the end of the subsequent system resume
71 to be frozen and to put themselves into uninterruptible sleep if so. [Note,
101 When all devices have been suspended, CPUs enter the idle loop and are put
188 devices have been put into low-power states. On those platforms,
|
| /Documentation/filesystems/nfs/ |
| D | pnfs.rst | 24 Each header is also (when non-empty) put on a list associated with
25 struct nfs_client (cl_layouts). Being put on this list does not bump
|
| /Documentation/driver-api/pm/ |
| D | devices.rst | 31 Drivers will use one or both of these models to put devices into low-power
55 Devices may also be put into low-power states while the system is
61 operations on the device for this purpose. Devices put into low power
74 have been put into low-power states (at runtime), the effect may be very similar
76 synergies exist, so that several drivers using runtime PM might put the system
188 they should be put into the full-power state. Those interrupts may or may not
215 majority of cases should and will) be put into a low-power state during a
329 should not put the device into a low-power state. Moreover, if the
370 performing I/O. They also may save the device registers and put it into
397 and finally put the device into the appropriate low-power state.
[all …]
|
| /Documentation/admin-guide/blockdev/ |
| D | ramdisk.rst | 117 e) Put the kernel onto the floppy::
121 f) Put the RAM disk image onto the floppy, after the kernel. Use an offset
122 that is slightly larger than the kernel, so that you can put another
|
| D | nbd.rst | 14 Unlike NFS, it is possible to put any filesystem on it, etc.
|
| /Documentation/driver-api/dmaengine/ |
| D | pxa_dma.rst | 154 - a driver submitted an unaligned tx4 => tx4 is put in submitted queue,
157 - a driver issued tx4 => tx4 is put in issued queue, not chained
159 - a driver submitted an aligned tx5 => tx5 is put in submitted queue, not
162 - a driver submitted an aligned tx6 => tx6 is put in submitted queue,
|
| /Documentation/admin-guide/aoe/ |
| D | status.sh | 14 # Suse 9.1 Pro doesn't put /sys in /etc/mtab
|
| /Documentation/process/ |
| D | license-rules.rst | 141 project and permission has been given to put it in the kernel, but the
200 for the SPDX license identifiers as they should be put into source
213 To use this license in source code, put one of the following SPDX
228 To use this license in source code, put the following SPDX
275 To use this license in source code, put the following SPDX
324 To use the Mozilla Public License version 1.1 put the following SPDX
381 examples for the SPDX license identifiers as they should be put into
|
| D | index.rst | 51 These are some overall technical guides that have been put here for now for
|
| /Documentation/devicetree/bindings/serial/ |
| D | sirf-uart.txt | 27 On the board-specific dts, we can put rts-gpios and cts-gpios like
|
| /Documentation/driver-api/fpga/ |
| D | fpga-region.rst | 60 * fpga_mgr_put() — Put an FPGA manager
73 * fpga_bridges_put() — Given a list of bridges, put them
|
| /Documentation/devicetree/bindings/leds/backlight/ |
| D | common.yaml | 30 property is not required. This property is used to put a software limit
|
| /Documentation/devicetree/bindings/clock/ti/ |
| D | autoidle.txt | 6 clock which can be put to idle automatically by hardware based on the usage
|
| /Documentation/userspace-api/media/cec/ |
| D | cec-ioc-g-mode.rst | 148 receive CEC messages for processing. In addition it will put the
160 - Put the file descriptor into pin monitoring mode. Can only be used in
174 - Put the file descriptor into monitor mode. Can only be used in
187 - Put the file descriptor into 'monitor all' mode. Can only be used
|
| /Documentation/translations/zh_CN/process/ |
| D | license-rules.rst | 185 To use this license in source code, put one of the following SPDX
200 To use this license in source code, put the following SPDX
240 To use this license in source code, put the following SPDX
|
| /Documentation/scsi/ |
| D | wd719x.rst | 15 d719x-wcs.bin files. Put them in /lib/firmware/::
|
| /Documentation/leds/ |
| D | ledtrig-oneshot.rst | 6 no clear trap points to put standard led-on and led-off settings. Using this
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | qcom,pmic-mpp.txt | 115 Definition: The specified pins will put in high-Z mode and disabled.
120 Definition: The specified pins are put in input mode, i.e. their input
|
1234567891011