Searched full:receives (Results 1 – 25 of 101) sorted by relevance
12345
| /Documentation/userspace-api/media/v4l/ |
| D | vidioc-g-tuner.rst | 310 - The tuner receives a mono audio signal.
313 - The tuner receives a stereo audio signal.
316 - The tuner receives the primary language of a bilingual audio
321 - The tuner receives the secondary language of a bilingual audio
325 - The tuner receives a Second Audio Program.
334 - The tuner receives an RDS channel.
348 - Play mono audio. When the tuner receives a stereo signal this a
349 down-mix of the left and right channel. When the tuner receives a
353 - Play stereo audio. When the tuner receives bilingual audio it may
360 When the tuner receives no stereo signal or does not support
[all …]
|
| D | ext-ctrls-rf-tuner.rst | 13 demodulator. It receives radio frequency (RF) from the antenna and
|
| /Documentation/userspace-api/media/dvb/ |
| D | fe-diseqc-recv-slave-reply.rst | 13 FE_DISEQC_RECV_SLAVE_REPLY - Receives reply from a DiSEqC 2.0 command
34 Receives reply from a DiSEqC 2.0 command.
|
| D | ca-get-msg.rst | 34 Receives a message via a CI CA module.
|
| /Documentation/driver-api/media/ |
| D | rc-core.rst | 52 of time it receives *PULSE/SPACE* events.
68 When the RC core receives events produced by ``RC_DRIVER_IR_RAW`` IR
73 When the RC code receives a scan code (either directly, by a driver
|
| D | dtv-demux.rst | 17 When the demux client allocates a resource via the demux kABI, it receives
20 Each demux receives its TS input from a DVB front-end or from memory, as
|
| /Documentation/devicetree/bindings/interrupt-controller/ |
| D | aspeed,ast2xxx-scu-ic.txt | 9 - interrupt-controller : indicates that the controller receives and
|
| D | aspeed,ast2400-i2c-ic.txt | 12 - interrupt-controller : denotes that the controller receives and fires
|
| D | marvell,sei.txt | 5 aggregator. It receives interrupts from several sources and aggregates
|
| /Documentation/networking/ |
| D | snmp_counter.rst | 85 This counter means the packet is dropped when the IP stack receives a
194 straightforward. The 'In' counter means kernel receives such a packet
234 receives an ICMP packet, kernel follows below logic:
296 It means the TCP layer receives a SYN, replies a SYN+ACK, come into
344 When kernel receives a SYN from a client, and if the TCP accept queue
400 The socket receives a RST packet in Establish or CloseWait state.
417 When kernel receives a TCP packet, it has two paths to handler the
446 receives packets.
620 1,2,4,5,3. When the sender receives the ACK of packet 3 (which will
634 receives SACK for packet 4 and the sender doesn't retransmit the
[all …]
|
| /Documentation/networking/devlink/ |
| D | sja1105.rst | 42 switch receives frames with such VIDs, it will
|
| /Documentation/devicetree/ |
| D | changesets.rst | 17 receives the notifier.
|
| /Documentation/admin-guide/media/ |
| D | rkisp1.rst | 31 - rkisp1_params: a metadata output device that receives parameters
71 receives the frames using the CSI-2 protocol. It is responsible of configuring
96 The rkisp1_params video node receives a set of parameters from userspace
|
| D | remote-controller.rst | 13 them have a microprocessor that receives the IR carriers, convert into
|
| /Documentation/admin-guide/mm/ |
| D | userfaultfd.rst | 30 resolve the userfaults it receives via 1) or to manage the virtual
224 the ``userfaultfd`` and receives the fault address (or ``-EAGAIN`` in case the
230 into the socket. The QEMU source node receives the information and
266 receives ``UFFD_EVENT_FORK`` with file descriptor of the new
|
| /Documentation/mhi/ |
| D | topology.rst | 46 driver sends and receives the upper-layer protocol packets like IP packets,
|
| /Documentation/crypto/ |
| D | crypto_engine.rst | 63 When your driver receives a crypto_request, you must to transfer it to
|
| /Documentation/driver-api/ |
| D | io_ordering.rst | 31 In the case above, the device may receive newval2 before it receives newval,
|
| D | sync_file.rst | 39 On the other hand if the driver receives fence(s) through a sync_file from
|
| /Documentation/userspace-api/media/cec/ |
| D | cec-ioc-g-mode.rst | 43 follower is the filehandle that receives messages sent to the CEC
178 device transmits and all messages it receives (both broadcast
190 this CEC device transmits and all messages it receives, including
|
| /Documentation/devicetree/bindings/sound/ |
| D | nvidia,tegra210-admaif.yaml | 11 that sends/receives data to/from AHUB must interface through an
|
| /Documentation/driver-api/serial/ |
| D | serial-iso7816.rst | 33 callback receives a pointer to struct serial_iso7816.
|
| /Documentation/infiniband/ |
| D | tag_matching.rst | 6 source send operations to destination receives. The following parameters must
|
| /Documentation/admin-guide/device-mapper/ |
| D | dm-log.rst | 44 logging requests to userspace, where a daemon receives and processes the
|
| /Documentation/bpf/ |
| D | prog_sk_lookup.rst | 81 receives information about the packet that triggered the socket lookup. Namely:
|
12345