Searched full:refer (Results 1 – 25 of 716) sorted by relevance
12345678910>>...29
| /Documentation/devicetree/bindings/sound/ |
| D | marvell,pxa2xx-ac97.txt | 12 - clocks: input clock of the AC97 IP, refer to clock-bindings.txt
15 - pinctrl-names, pinctrl-0: refer to pinctrl-bindings.txt
16 - reset-gpios: gpio used for AC97 reset, refer to gpio.txt
|
| D | amlogic,axg-sound-card.txt | 11 - audio-widgets : Please refer to widgets.txt.
34 - dai-tdm-slot-num : Please refer to tdm-slot.txt.
37 - dai-tdm-slot-width : Please refer to tdm-slot.txt. default to 32 if omitted.
53 - dai-tdm-slot-tx-mask : Please refer to tdm-slot.txt.
54 - dai-tdm-slot-rx-mask : Please refer to tdm-slot.txt.
|
| D | atmel_ac97c.txt | 7 - ac97-gpios: Please refer to soc-ac97link.txt, only ac97-reset is used
9 - pinctrl-names, pinctrl-0: Please refer to pinctrl-bindings.txt
|
| /Documentation/devicetree/bindings/iio/health/ |
| D | afe4403.txt | 8 connected to. For details refer to,
13 For details refer to, ../../gpio/gpio.txt.
16 please refer to ../../spi/spi-bus.txt.
|
| D | afe4404.txt | 8 connected to. For details refer to,
13 For details refer to, ../gpio/gpio.txt.
|
| D | max30100.txt | 10 Refer to interrupt-controller/interrupts.txt for generic
18 Refer to the datasheet for the allowed current values.
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | fsl,imx50-pinctrl.txt | 3 Please refer to fsl,imx-pinctrl.txt in this directory for common binding part
11 pull-up for this pin. Please refer to imx50 datasheet for the valid pad
31 Refer to imx50-pinfunc.h in device tree source folder for all available
|
| D | fsl,imx53-pinctrl.txt | 3 Please refer to fsl,imx-pinctrl.txt in this directory for common binding part
11 pull-up for this pin. Please refer to imx53 datasheet for the valid pad
31 Refer to imx53-pinfunc.h in device tree source folder for all available
|
| D | fsl,imx51-pinctrl.txt | 3 Please refer to fsl,imx-pinctrl.txt in this directory for common binding part
11 pull-up for this pin. Please refer to imx51 datasheet for the valid pad
31 Refer to imx51-pinfunc.h in device tree source folder for all available
|
| D | fsl,imx35-pinctrl.txt | 3 Please refer to fsl,imx-pinctrl.txt in this directory for common binding part
11 pull-up for this pin. Please refer to imx35 datasheet for the valid pad
32 Refer to imx35-pinfunc.h in device tree source folder for all available
|
| D | fsl,imx6q-pinctrl.txt | 3 Please refer to fsl,imx-pinctrl.txt in this directory for common binding part
11 pull-up for this pin. Please refer to imx6q datasheet for the valid pad
37 Refer to imx6q-pinfunc.h in device tree source folder for all available
|
| D | fsl,imx6dl-pinctrl.txt | 3 Please refer to fsl,imx-pinctrl.txt in this directory for common binding part
11 pull-up for this pin. Please refer to imx6dl datasheet for the valid pad
37 Refer to imx6dl-pinfunc.h in device tree source folder for all available
|
| D | fsl,vf610-pinctrl.txt | 3 Please refer to fsl,imx-pinctrl.txt in this directory for common binding part
11 such as pull-up, speed, ode for this pin. Please refer to Vybrid VF610
40 Please refer to vf610-pinfunc.h in device tree source folder
|
| D | fsl,imx6sl-pinctrl.txt | 3 Please refer to fsl,imx-pinctrl.txt in this directory for common binding part
11 pull-up for this pin. Please refer to imx6sl datasheet for the valid pad
38 Refer to imx6sl-pinfunc.h in device tree source folder for all available
|
| D | fsl,imx6sll-pinctrl.txt | 3 Please refer to fsl,imx-pinctrl.txt in this directory for common binding part
12 the pad setting value like pull-up on this pin. Please refer to i.MX6SLL
39 Refer to imx6sll-pinfunc.h in device tree source folder for all available
|
| D | fsl,imx-pinctrl.txt | 10 Please refer to pinctrl-bindings.txt in this directory for details of the
22 Please refer to each fsl,<soc>-pinctrl.txt binding doc for supported SoCs.
41 Please refer to each fsl,<soc>-pinctrl,txt binding doc for SoC specific part
90 Refer to the IOMUXC controller chapter in imx6q datasheet,
93 User should refer to each SoC spec to set the correct value.
|
| D | marvell,mvebu-pinctrl.txt | 7 Please refer to pinctrl-bindings.txt in this directory for details of the
17 Please refer to each marvell,<soc>-pinctrl.txt binding doc for supported SoCs.
23 common for all marvell,pins. Please refer to marvell,<soc>-pinctrl.txt for
|
| D | fsl,imx25-pinctrl.txt | 3 Please refer to fsl,imx-pinctrl.txt in this directory for common binding part
22 Refer to imx25-pinfunc.h in device tree source folder for all available
|
| /Documentation/devicetree/bindings/iio/proximity/ |
| D | as3935.txt | 7 - spi-cpha: SPI Mode 1. Refer to spi/spi-bus.txt for generic SPI
11 Refer to interrupt-controller/interrupts.txt for generic
20 MCU board, and possibly the local environment. Refer to the
|
| /Documentation/devicetree/bindings/thermal/ |
| D | max77620_thermal.txt | 11 #thermal-sensor-cells: For more details, please refer to
15 For more details, please refer generic thermal DT binding document
18 Please refer <devicetree/bindings/mfd/max77620.txt> for mfd DT binding
|
| /Documentation/devicetree/bindings/ata/ |
| D | ahci-fsl-qoriq.txt | 7 - clocks: Input clock specifier. Refer to common clock bindings.
8 - interrupts: Interrupt specifier. Refer to interrupt binding.
|
| /Documentation/devicetree/bindings/media/ |
| D | atmel-isc.txt | 14 Please refer to clock-bindings.txt.
22 Please refer to pinctrl-bindings.txt.
25 'port' child node with child 'endpoint' node. Please refer to the bindings
|
| /Documentation/devicetree/bindings/mfd/ |
| D | lp3943.txt | 9 For the LP3943 GPIO properties please refer to:
12 For the LP3943 PWM properties please refer to:
|
| /Documentation/ABI/testing/ |
| D | sysfs-class-led-multicolor | 11 For additional details please refer to
23 For additional details please refer to
|
| /Documentation/devicetree/bindings/iio/humidity/ |
| D | hts221.txt | 15 Refer to pinctrl/pinctrl-bindings.txt for the property description.
20 Refer to interrupt-controller/interrupts.txt for generic interrupt
|
12345678910>>...29