Searched full:reliable (Results 1 – 25 of 86) sorted by relevance
1234
| /Documentation/firmware-guide/acpi/ |
| D | acpi-lid.rst | 21 reliable. However, there are exceptions. In order to work with these
36 with cached value, the initial returning value is likely not reliable.
47 tested, it is reliable from all AML tables.
58 the previous explanation, it is not reliable enough on some platforms. So
81 of the _LID control method is reliable but the initial lid state
93 control method is not reliable and the initial lid state notification is
103 ensure that the reliable "closed" notifications can always be delivered
|
| /Documentation/networking/ |
| D | tcp-thin.rst | 7 A wide range of Internet-based services that use reliable transport
51 reliable transport"
|
| D | x25-iface.rst | 79 The X.25 packet layer protocol depends on a reliable datalink service.
80 The LAPB protocol provides such reliable service. But this reliability
95 Thus, driver authors should make netif_rx() as reliable as possible:
|
| D | sctp.rst | 11 reliable transport protocol, with congestion control, support for
|
| D | rds.rst | 19 RDS provides reliable, ordered datagram delivery by using a single
20 reliable connection between any two nodes in the cluster. This allows
40 reliable IB connection; the IP address is used exclusively to
101 transparently establish the underlying reliable connection
226 One might think that with reliable IB connections you wouldn't need
|
| D | x25.rst | 32 the Internet using TCP/IP as a reliable link layer. RFC1613 specifies the
|
| /Documentation/devicetree/bindings/hwmon/ |
| D | ina3221.txt | 12 more reliable and suitable for hardware monitor type device,
|
| /Documentation/devicetree/bindings/iio/light/ |
| D | us5182d.txt | 24 reliable. If this property is specified the continuous
|
| /Documentation/ABI/testing/ |
| D | sysfs-platform-kim | 19 The maximum reliable baud-rate the host can support.
|
| D | dev-kmsg | 90 readable context of the message, for reliable processing in
|
| /Documentation/devicetree/bindings/mtd/ |
| D | jedec,spi-nor.txt | 80 denote the absence of a reliable reset mechanism.
|
| /Documentation/hwmon/ |
| D | ads7828.rst | 63 There is no reliable way to identify this chip, so the driver will not scan
|
| D | w83627hf.rst | 45 This driver supports ISA accesses, which should be more reliable
|
| /Documentation/core-api/irq/ |
| D | irqflags-tracing.rst | 48 turn itself off. I.e. the lock validator will still be reliable. There
|
| /Documentation/core-api/ |
| D | timekeeping.rst | 20 Useful for reliable timestamps and measuring short time intervals
128 on most modern machines with a reliable cycle counter, but
|
| /Documentation/devicetree/bindings/gpio/ |
| D | gpio-pcf857x.txt | 9 of reset (if any). The only reliable solution for setting up line direction is
|
| /Documentation/scsi/ |
| D | qlogicfas.rst | 53 if you have reliable hardware and connections it may be more useful to
|
| D | dc395x.rst | 115 reliable driver, there is a chance, that it will kill your valuable data.
|
| /Documentation/driver-api/ |
| D | pti_intel_mid.rst | 27 a stable, reliable connection that will not break unless
|
| D | connector.rst | 102 Netlink itself is not a reliable protocol. That means that messages can
|
| /Documentation/driver-api/mmc/ |
| D | mmc-dev-attrs.rst | 37 rel_sectors Reliable write sector count
|
| /Documentation/x86/ |
| D | entry_64.rst | 88 use the faster check: the stack will be a reliable indicator of
|
| /Documentation/infiniband/ |
| D | ipoib.rst | 45 In connected mode, the IB RC (Reliable Connected) transport is used.
|
| /Documentation/userspace-api/media/v4l/ |
| D | dev-raw-vbi.rst | 144 drivers can return start values 0 if the hardware cannot reliable
288 semantics depending on the field number. These cannot be reliable
|
| /Documentation/arm64/ |
| D | elf_hwcaps.rst | 36 behaviour, and is not guaranteed to result in any reliable indication
|
1234