Searched full:requires (Results 1 – 25 of 480) sorted by relevance
12345678910>>...20
98 The device requires 3-wire mode.103 The device requires shifted clock phase (CPHA) mode.108 The device requires inverse clock polarity (CPOL) mode.113 The device requires the chip select active high.118 The device requires the LSB first mode.
185 - EACCES Access denied: requires CAP_SYS_ADMIN235 - EACCES Access denied: requires CAP_SYS_ADMIN359 - EACCES Access denied: requires CAP_SYS_ADMIN487 - EACCES Access denied: requires CAP_SYS_ADMIN596 - EACCES Access denied: requires CAP_SYS_ADMIN622 - EACCES Access denied: requires CAP_SYS_RAWIO658 - EACCES Access denied: requires CAP_SYS_ADMIN681 registers of the drive. Requires ADMIN and RAWIO access947 - EACCES Access denied: requires CAP_SYS_RAWIO1016 - EACCES Access denied: requires CAP_SYS_RAWIO[all …]
24 The CS4271 requires its LRCLK and MCLK to be stable before its RESET26 without putting the chip back into hardware reset, which also requires
18 future. Requires a separate RTC_AIE_ON call to enable the33 Requires a separate RTC_PIE_ON call to enable the periodic
16 Also note that toggling this value on type 1 devices, requires125 Note that toggling this value requires a reboot for changes to174 Note that toggling this value requires a reboot for changes to188 Note that toggling this value requires a reboot for changes to201 Note that toggling this value requires a reboot for changes to
8 Note that debug output requires that the module be compiled
6 output device. Reads return current status. Requires that the
3 Requires node properties:
4 Requires node properties:
6 Requires node properties:
250 implementation. It requires an initialized struct autofs_dev_ioctl as an260 by loaded module. This call requires an initialized struct autofs_dev_ioctl271 path. The open call requires an initialized struct autofs_dev_ioctl with275 shown in /proc/mounts. The close call requires an initialized struct305 The call requires an initialized struct autofs_dev_ioctl with the320 The call requires an initialized struct autofs_dev_ioctl with the329 The call requires an initialized struct autofs_dev_ioctl with the339 The call requires an initialized struct autofs_dev_ioctl with the path357 The call requires an initialized struct autofs_dev_ioctl with the375 The call requires an initialized struct autofs_dev_ioctl with the[all …]
11 dlmfs is built with OCFS2 as it requires most of its infrastructure.47 dlmfs requires that the OCFS2 cluster infrastructure be in53 ocfs2_hb_ctl (distributed with ocfs2-tools). Right now it requires
49 - This call requires read/write access to the device.64 - This call only requires read-only access to the device.
31 Exynos emulation mode requires synchronous of value changing and39 Disabling emulation mode only requires writing value 0 to sysfs node.
7 * NOTE: This requires herd7 7.56 or later which supports "(void)expr".
5 the NETCP modules) requires a PLL Controller to manage the various clock
7 Requires node properties:
3 The proximity detector sensor requires power supply
6 requires the use of interrupts. Without interrupts, only the simple reading
12 libibverbs also requires appropriate device-dependent kernel and50 Direct userspace I/O requires that memory regions that are potential
83 * Add compatibility support. Now requires a 2.1.x, 2.2.x or 2.3.x kernel.89 * Requires kernel 2.3.14-pre1 or later.
8 - clocks: Array of clocks required for SDHCI; requires at least one for
11 requires passing phandle to the USB PHY reference clock.
20 The driver now requires a 2.6.12 (if pre-release, 2.6.12-rc1) or later71 At this time, the driver requires the 2.6.12 (if pre-release, 2.6.12-rc1)