Searched full:roughly (Results 1 – 25 of 46) sorted by relevance
12
| /Documentation/devicetree/bindings/clock/ |
| D | marvell,pxa1928.txt | 5 blocks called APMU, MPMU, and APBC roughly corresponding to internal buses.
|
| /Documentation/devicetree/bindings/iio/resolver/ |
| D | ad2s90.txt | 22 roughly 830000Hz.
|
| /Documentation/devicetree/bindings/iio/light/ |
| D | us5182d.txt | 32 sensor on evaluation board - roughly between 12-32 lux.
|
| /Documentation/admin-guide/ |
| D | init.rst | 7 (listed roughly in order of execution) to load the init binary.
|
| /Documentation/scheduler/ |
| D | sched-bwc.rst | 115 result it is expected that nr_periods roughly equal nr_throttled, and that
116 cpuacct.usage will increase roughly equal to cfs_quota_us in each period.
|
| /Documentation/fb/ |
| D | deferred_io.rst | 25 As can be seen from above, one benefit is roughly to allow bursty framebuffer
|
| /Documentation/vm/ |
| D | page_owner.rst | 53 Although, roughly, 8 KB code is added in total, page_alloc.o increase by
|
| /Documentation/driver-api/media/drivers/ |
| D | cx88-devel.rst | 78 - Setup 4KHz sampling rate (roughly 2x oversampled; good enough for our RC5
|
| D | pvrusb2.rst | 27 roughly:
|
| /Documentation/driver-api/mmc/ |
| D | mmc-async-req.rst | 31 more significant the prepare request time becomes. Roughly the expected
|
| /Documentation/locking/ |
| D | locktorture.rst | 111 to run and pause for (roughly) five-second intervals.
|
| /Documentation/userspace-api/media/v4l/ |
| D | colorspaces-defs.rst | 148 LSB is roughly 1.41 degrees.
|
| /Documentation/input/ |
| D | gamepad.rst | 16 As "gamepad" we define devices which roughly look like this::
|
| /Documentation/admin-guide/sysctl/ |
| D | fs.rst | 381 Each "watch" costs roughly 90 bytes on a 32bit kernel, and roughly 160 bytes
|
| /Documentation/networking/ |
| D | netdev-FAQ.rst | 48 expected. After roughly a week of collecting fixes to the rc1 content,
49 rc2 is released. This repeats on a roughly weekly basis until rc7
|
| D | eql.rst | 109 could argue that MTU should be roughly half the usual size for two
|
| /Documentation/x86/ |
| D | orc-unwinder.rst | 56 that it needs more memory to store the ORC unwind tables: roughly 2-4MB
|
| /Documentation/security/ |
| D | siphash.rst | 186 HalfSipHash is roughly 3 times slower than JenkinsHash. For many replacements,
|
| /Documentation/timers/ |
| D | hrtimers.rst | 120 hrtimer_try_to_cancel() and hrtimer_cancel() [which are roughly
|
| /Documentation/filesystems/ |
| D | xfs-delayed-logging-design.rst | 504 format structure. That is, two vectors totaling roughly 150 bytes. If we modify
508 each, so we in 1.5MB of directory buffers we'd have roughly 400 buffers and a
509 buffer format structure for each buffer - roughly 800 vectors or 1.51MB total
|
| D | seq_file.rst | 78 during a "session" (roughly one read() system call). If the iterator
|
| /Documentation/userspace-api/ |
| D | unshare.rst | 249 etc, had roughly two components. The first component allocated
|
| /Documentation/admin-guide/mm/ |
| D | userfaultfd.rst | 231 roughly "seeks" to that page address and continues sending all
|
| /Documentation/input/devices/ |
| D | alps.rst | 10 Since roughly mid-2010 several new ALPS touchpads have been released and
|
| /Documentation/driver-api/ |
| D | xillybus.rst | 298 an equivalent flush roughly XILLY_RX_TIMEOUT jiffies after the last write().
|
12