Home
last modified time | relevance | path

Searched +full:short +full:- +full:press +full:- +full:ms (Results 1 – 6 of 6) sorted by relevance

/Documentation/devicetree/bindings/mfd/
Drohm,bd71847-pmic.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/mfd/rohm,bd71847-pmic.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com>
14 single-core, dual-core, and quad-core SoCs such as NXP-i.MX 8M. It is
18 …/www.rohm.com/products/power-management/power-management-ic-for-system/industrial-consumer-applica…
19 …//www.rohm.com/products/power-management/power-management-ic-for-system/industrial-consumer-applic…
24 - rohm,bd71847
25 - rohm,bd71850
[all …]
Drohm,bd71837-pmic.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/mfd/rohm,bd71837-pmic.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com>
13 BD71837MWV is programmable Power Management ICs for powering single-core,
14 dual-core, and quad-core SoCs such as NXP-i.MX 8M. It is optimized for low
18 …/www.rohm.com/products/power-management/power-management-ic-for-system/industrial-consumer-applica…
35 "#clock-cells":
48 # crucial regulators must have the regulator-always-on and regulator-boot-on
[all …]
/Documentation/devicetree/bindings/sound/
Dcs42l42.txt5 - compatible : "cirrus,cs42l42"
7 - reg : the I2C address of the device for I2C.
9 - VP-supply, VCP-supply, VD_FILT-supply, VL-supply, VA-supply :
15 - reset-gpios : a GPIO spec for the reset pin. If specified, it will be
18 - interrupts : IRQ line info CS42L42.
19 (See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
22 - cirrus,ts-inv : Boolean property. For jacks that invert the tip sense
23 polarity. Normal jacks will short tip sense pin to HS1 when headphones are
25 short tip sense when unplugged and float when plugged in.
27 0 = (Default) Non-inverted
[all …]
Dnau8824.txt6 - compatible : Must be "nuvoton,nau8824"
8 - reg : the I2C address of the device. This is either 0x1a (CSB=0) or 0x1b (CSB=1).
11 - nuvoton,jkdet-polarity: JKDET pin polarity. 0 - active high, 1 - active low.
13 - nuvoton,vref-impedance: VREF Impedance selection
14 0 - Open
15 1 - 25 kOhm
16 2 - 125 kOhm
17 3 - 2.5 kOhm
19 - nuvoton,micbias-voltage: Micbias voltage level.
20 0 - VDDA
[all …]
Dnau8825.txt6 - compatible : Must be "nuvoton,nau8825"
8 - reg : the I2C address of the device. This is either 0x1a (CSB=0) or 0x1b (CSB=1).
11 - nuvoton,jkdet-enable: Enable jack detection via JKDET pin.
12 - nuvoton,jkdet-pull-enable: Enable JKDET pin pull. If set - pin pull enabled,
14 - nuvoton,jkdet-pull-up: Pull-up JKDET pin. If set then JKDET pin is pull up, otherwise pull down.
15 - nuvoton,jkdet-polarity: JKDET pin polarity. 0 - active high, 1 - active low.
17 - nuvoton,vref-impedance: VREF Impedance selection
18 0 - Open
19 1 - 25 kOhm
20 2 - 125 kOhm
[all …]
/Documentation/admin-guide/media/
Dbttv.rst1 .. SPDX-License-Identifier: GPL-2.0
8 ----------------------
12 ./scripts/config -e PCI
13 ./scripts/config -m I2C
14 ./scripts/config -m INPUT
15 ./scripts/config -m MEDIA_SUPPORT
16 ./scripts/config -e MEDIA_PCI_SUPPORT
17 ./scripts/config -e MEDIA_ANALOG_TV_SUPPORT
18 ./scripts/config -e MEDIA_DIGITAL_TV_SUPPORT
19 ./scripts/config -e MEDIA_RADIO_SUPPORT
[all …]