Searched full:signaling (Results 1 – 25 of 41) sorted by relevance
12
| /Documentation/devicetree/bindings/arm/tegra/ |
| D | nvidia,tegra186-pmc.txt | 46 used to set pad power state and signaling voltage. A pad can be either
47 in active or power down mode. The support for power state and signaling
49 1.8 V signaling voltages are supported on pins where software
50 controllable signaling voltage switching is available.
77 TEGRA_IO_PAD_VOLTAGE_3V3 to select between signaling voltages.
82 for ao-hv. Following pads have software configurable signaling
|
| D | nvidia,tegra20-pmc.yaml | 247 and signaling voltage. A pad can be either in active or power down mode.
248 The support for power state and signaling voltage configuration varies
249 depending on the pad in question. 3.3V and 1.8V signaling voltages
250 are supported on pins where software controllable signaling voltage
287 TEGRA_IO_PAD_VOLTAGE_3V3 to select between signaling voltages.
291 pads. None of the Tegra124 or Tegra132 pads support signaling
294 state configuration. Signaling voltage switching is supported
|
| /Documentation/driver-api/gpio/ |
| D | intro.rst | 51 other value (notably, "open drain" signaling).
55 cases (to support bidirectional signaling). GPIO controllers may have
96 driven) signaling. That term applies to CMOS transistors; "open collector" is
105 don't. When you need open drain signaling but your hardware doesn't directly
115 The same logic can be applied to emulate open source signaling, by driving the
123 delays the rising edge of SCK, and the I2C master adjusts its signaling rate
|
| D | legacy.rst | 35 for the other value (notably, "open drain" signaling).
39 cases (to support bidirectional signaling). GPIO controllers may have
180 issues including open-drain signaling and output latencies.
416 Sometimes shared signals need to use "open drain" signaling, where only the
426 you need open drain signaling but your hardware doesn't directly support it,
441 signaling rate accordingly.
|
| /Documentation/devicetree/bindings/mailbox/ |
| D | st,stm32-ipcc.yaml | 10 The IPCC block provides a non blocking signaling mechanism to post and
12 It provides the signaling for N bidirectionnal channels. The number of
|
| /Documentation/devicetree/bindings/mmc/ |
| D | nvidia,tegra20-sdhci.txt | 64 calibration offsets for 3.3 V signaling modes.
67 calibration offsets for 1.8 V signaling modes.
71 out on a 3.3 V signaling mode.
75 out on a 1.8 V signaling mode.
|
| /Documentation/ABI/testing/ |
| D | sysfs-devices-power_resources_wakeup | 7 require ACPI power resources for wakeup signaling.
|
| D | evm | 66 be possible to enable metadata modification. Signaling that an
79 INTEGRITY_UNKNOWN. Loading keys and signaling EVM
|
| D | sysfs-platform-chipidea-usb-otg | 10 be set to 1 by kernel in response to remote wakeup signaling
|
| /Documentation/devicetree/bindings/net/ |
| D | sff,sfp.txt | 28 - rate-select0-gpios : GPIO phandle and a specifier of the Rx Signaling Rate
32 - rate-select1-gpios : GPIO phandle and a specifier of the Tx Signaling Rate
|
| /Documentation/scheduler/ |
| D | completion.rst | 40 - the signaling side through a call to complete() or complete_all().
43 Note that while initialization must happen first, the waiting and signaling
243 Signaling completions:
256 The signaling will work as expected even if completions are signaled before
271 Signaling completion from IRQ context is fine as it will appropriately
|
| /Documentation/devicetree/bindings/i2c/ |
| D | i2c-arb-gpio-challenge.txt | 24 - OUR_CLAIM: output from us signaling to other hosts that we want the bus
25 - THEIR_CLAIMS: output from others signaling that they want the bus
|
| /Documentation/power/ |
| D | pci.rst | 200 1.4. Wakeup Signaling
217 capable of signaling wakeup. The information on the connections between GPEs
239 a PCI device signaling wakeup). The GPEs used for notifying the kernel of
261 In principle the native PCI Express PME signaling may also be used on ACPI-based
266 the native PCI Express PME signaling cannot be used by the kernel in that case.
318 unsigned int pme_interrupt:1;/* Is native PCIe PME signaling used? */
351 device from signaling wakeup.
372 PCI Express PME signaling and the ACPI GPE-based wakeup signaling described in
385 state from which it can signal wakeup. The exact method of signaling wakeup is
388 device for signaling wakeup and put it into the selected low-power state, the
[all …]
|
| /Documentation/devicetree/bindings/misc/ |
| D | ifm-csi.txt | 7 of the interrupt line signaling frame valid events
|
| /Documentation/leds/ |
| D | ledtrig-oneshot.rst | 5 This is a LED trigger useful for signaling the user of an event where there are
|
| /Documentation/driver-api/ |
| D | i2c.rst | 12 I2C is a multi-master bus; open drain signaling is used to arbitrate
|
| /Documentation/devicetree/bindings/display/ |
| D | arm,malidp.txt | 41 levels of DP500's QoS signaling.
|
| /Documentation/devicetree/bindings/soc/qcom/ |
| D | qcom,smd.txt | 35 signaling the remote processor:
|
| D | qcom,smsm.txt | 19 signaling the N:th remote processor
|
| D | qcom,smp2p.txt | 30 signaling the remote end of the smp2p edge:
|
| /Documentation/i2c/ |
| D | summary.rst | 19 a subset of I2C protocols and signaling. Many I2C devices will work on an
|
| /Documentation/infiniband/ |
| D | ipoib.rst | 76 IPoIB doesn't use events for TX completion signaling so only RX
|
| /Documentation/virt/ |
| D | ne_overview.rst | 57 uses eventfd for signaling. The enclave VM sees the usual interfaces - local
|
| /Documentation/target/ |
| D | tcmu-design.rst | 112 userspace to determine how large the shared region is) and signaling
156 then signaling userspace via uio_event_notify(). Once the command is
|
| /Documentation/ABI/stable/ |
| D | sysfs-bus-vmbus | 77 Description: Channel signaling latency. This file is available only for
|
12