Searched full:top (Results 1 – 25 of 396) sorted by relevance
12345678910>>...16
| /Documentation/devicetree/bindings/arm/amlogic/ |
| D | analog-top.txt | 1 Amlogic Meson8 and Meson8b "analog top" registers:
4 The analog top registers contain information about the so-called
8 - reg: the register range of the analog top registers
10 - "amlogic,meson8-analog-top"
11 - "amlogic,meson8b-analog-top"
17 analog_top: analog-top@81a8 {
18 compatible = "amlogic,meson8-analog-top", "syscon";
|
| /Documentation/userspace-api/media/v4l/ |
| D | field-order.rst | 29 combine to frames. We distinguish between top (aka odd) and bottom (aka
30 even) fields, the *spatial order*: The first line of the top field is
35 whether a frame commences with the top or bottom field is pointless. Any
36 two successive top and bottom, or bottom and top fields yield a valid
41 Counter to intuition the top field is not necessarily the older field.
42 Whether the older field contains the top or bottom lines is a convention
48 bus in the same order they were captured, so if the top field was
49 captured first (is the older field), the top field is also transmitted
92 - Images consist of the top (aka odd) field only.
102 order of the fields (whether the top or bottom field is older)
[all …]
|
| D | selection-api-configuration.rst | 30 The range of coordinates of the top left corner, width and height of
32 target. It is recommended for the driver developers to put the top/left
36 The top left corner, width and height of the source rectangle, that is
51 coordinates are expressed in pixels. The rectangle's top/left corner
91 All coordinates are expressed in pixels. The top/left corner is always
95 The top left corner, width and height of the source rectangle, that is
117 the driver developers to put the top/left corner at position ``(0,0)``.
|
| D | pixfmt-intro.rst | 27 are always arranged in memory from left to right, and from top to
30 immediately to its right, and so on until the end of the top row of
34 leftmost pixel of the second row from the top, and so on. The last row
|
| D | ext-ctrls-detect.rst | 58 top-left of the grid.
64 top-left of the grid.
|
| D | vidioc-cropcap.rst | 108 - Horizontal offset of the top, left corner of the rectangle, in
111 - ``top``
112 - Vertical offset of the top, left corner of the rectangle, in
|
| /Documentation/devicetree/bindings/display/ |
| D | allwinner,sun8i-r40-tcon-top.yaml | 4 $id: http://devicetree.org/schemas/display/allwinner,sun8i-r40-tcon-top.yaml#
7 title: Allwinner R40 TCON TOP Device Tree Bindings
26 TCON-TOP
29 | TCON-TOP - HDMI
33 Note that both TCON TOP references same physical unit. Both mixers
34 can be connected to any TCON. Not all TCON TOP variants support all
43 - allwinner,sun8i-r40-tcon-top
44 - allwinner,sun50i-h6-tcon-top
53 - description: The TCON TOP interface clock
54 - description: The TCON TOP TV0 clock
[all …]
|
| D | amlogic,meson-dw-hdmi.yaml | 19 - A TOP control block controlling the Clocks and PHY
22 | HDMI TOP |<= HPD
29 The HDMI TOP block only supports HPD sensing.
31 TOP Block interrupt.
32 Communication to the TOP Block and the Synopsys HDMI Controller is done
40 The VENC uses a DVI encoder on top of the ENCI or ENCP encoders to generate
|
| /Documentation/admin-guide/cifs/ |
| D | winucase_convert.pl | 28 $top[$firstchar][$secondchar] = $uppercase;
32 next if (!$top[$i]);
41 printf("0x%4.4x,", $top[$i][$j] ? $top[$i][$j] : 0);
50 } elsif ($top[$i]) {
56 if ($top[$i]) {
|
| /Documentation/devicetree/bindings/sound/ |
| D | img,pistachio-internal-dac.txt | 7 - img,cr-top : Must contain a phandle to the top level control syscon
16 img,cr-top = <&cr_top>;
|
| /Documentation/devicetree/bindings/clock/ |
| D | pistachio-clock.txt | 5 general control, and top general control) which are instantiated individually
31 top-level general control.
99 Top-level general control:
102 The top-level general control block contains miscellaneous control registers and
106 - compatible: Must include "img,pistachio-cr-top" and "syscon".
107 - reg: Must contain the base address and length of the top-level
117 compatible = "img,pistachio-cr-top", "syscon";
|
| /Documentation/sound/designs/ |
| D | channel-mapping-api.rst | 108 SNDRV_CHMAP_TC, /* top center */
109 SNDRV_CHMAP_TFL, /* top front left */
110 SNDRV_CHMAP_TFR, /* top front right */
111 SNDRV_CHMAP_TFC, /* top front center */
112 SNDRV_CHMAP_TRL, /* top rear left */
113 SNDRV_CHMAP_TRR, /* top rear right */
114 SNDRV_CHMAP_TRC, /* top rear center */
|
| /Documentation/devicetree/bindings/pwm/ |
| D | pwm-mediatek.txt | 17 - "top": the top clock generator
43 clock-names = "top", "main", "pwm1", "pwm2",
|
| /Documentation/sphinx/ |
| D | parallel-wrapper.sh | 6 # the "auto" parallelism when "-jN" is not specified at the top-level
14 # If no parallelism is specified at the top-level make, then
|
| /Documentation/devicetree/bindings/mmc/ |
| D | sdhci-st.txt | 26 contain the FlashSS Top register for TX/RX delay used by the driver
31 - reg-names: Should be "mmc" and "top-mmc-delay". "top-mmc-delay" is optional
96 reg-names = "mmc", "top-mmc-delay";
|
| /Documentation/devicetree/bindings/ata/ |
| D | brcm,sata-brcm.txt | 15 - reg-names : "ahci" and "top-ctrl"
31 reg-names = "ahci", "top-ctrl";
|
| /Documentation/devicetree/bindings/phy/ |
| D | pistachio-usb-phy.txt | 11 - img,cr-top: Must constain a phandle to the CR_TOP syscon node.
27 img,cr-top = <&cr_top>;
|
| /Documentation/driver-api/media/drivers/ |
| D | sh_mobile_ceu_camera.rst | 51 S_CROP(left / top = (5) - (1), width / height = (5') - (5))
57 (1) to (2) - sensor cropped left or top
60 (3) to (4) - CEU cropped left or top
63 (2) to (5) - reverse sensor scale applied to CEU cropped left or top
|
| /Documentation/userspace-api/media/drivers/ |
| D | cx2341x-uapi.rst | 21 and from top to bottom. Each block is transmitted in turn, line-by-line.
23 So the first 16 bytes are the first line of the top-left block, the
24 second 16 bytes are the second line of the top-left block, etc. After
29 to right, top to bottom. Each block is transmitted in turn, line-by-line.
31 So the first 16 bytes are the first line of the top-left block and
33 second line of 8 UV pairs of the top-left block, etc. After transmitting
|
| /Documentation/locking/ |
| D | rt-mutex-design.rst | 116 top waiter
119 top pi waiter
173 also call it the Top of the chain) must be equal to or higher in priority
209 a tree of all top waiters of the mutexes that are owned by the process.
210 Note that this tree only holds the top waiters and not all waiters that are
213 The top of the task's PI tree is always the highest priority task that
216 at the top of this tree.
358 the pi_waiters of a task holds an order by priority of all the top waiters
359 of all the mutexes that the task owns, we simply need to compare the top
377 by the task, so we only need to compare the priority of that top pi waiter
[all …]
|
| D | rt-mutex.rst | 34 rtmutex, only the top priority waiter is enqueued into the owner's
36 the top priority waiter of a task changes (for example it timed out or
56 NULL 1 lock is free and has waiters and the top waiter
|
| /Documentation/ABI/testing/ |
| D | sysfs-platform-brcmstb-gisb-arb | 7 Broadcom Set Top Box internal GISB bus arbiter. Minimum value
|
| /Documentation/driver-api/iio/ |
| D | triggered-buffers.rst | 56 * **sensor_iio_pollfunc**, the function that will be used as top half of poll
65 top half.
|
| /Documentation/devicetree/bindings/watchdog/ |
| D | snps,dw-wdt.yaml | 46 Each TOP is a number loaded into the watchdog counter at the moment of
50 DW APB Watchdog IP-core might be synthesized with fixed TOP values,
|
| /Documentation/devicetree/bindings/media/i2c/ |
| D | ths8200.txt | 4 recorders, set-top boxes.
|
12345678910>>...16