Searched full:transmitter (Results 1 – 25 of 86) sorted by relevance
1234
| /Documentation/driver-api/media/ |
| D | csi2.rst | 19 Transmitter drivers
22 CSI-2 transmitter, such as a sensor or a TV tuner, drivers need to
28 CSI-2 transmitter.
33 rate the transmitter uses. The
58 The transmitter drivers must, if possible, configure the CSI-2
59 transmitter to *LP-11 mode* whenever the transmitter is powered on but
61 on should the transmitter activate the clock on the clock lane and
68 Stopping the transmitter
71 A transmitter stops sending the stream of images as a result of
81 Before the receiver driver may enable the CSI-2 transmitter by using
[all …]
|
| /Documentation/ABI/stable/ |
| D | sysfs-class-rfkill | 49 Description: Current state of the transmitter.
60 transmitter is turned off by software
62 transmitter is (potentially) active
64 transmitter is forced off by something outside of
76 The transmitter is (potentially) active.
78 The transmitter is forced off by something outside of
90 The transmitter is (potentially) active.
93 The transmitter is turned off by software.
|
| /Documentation/devicetree/bindings/sound/ |
| D | spdif-transmitter.txt | 1 Device-Tree bindings for dummy spdif transmitter
8 codec: spdif-transmitter {
|
| D | fsl-sai.txt | 40 with Rx) which means both the transmitter and the
46 means both transmitter and receiver will send and
63 transmitter and receiver will send and receive data by following clocks
64 of transmitter.
|
| D | xlnx,i2s.txt | 6 - compatible: "xlnx,i2s-transmitter-1.0" for playback and
24 compatible = "xlnx,i2s-transmitter-1.0";
|
| D | ak4104.txt | 1 AK4104 S/PDIF transmitter
|
| /Documentation/userspace-api/media/v4l/ |
| D | ext-ctrls-dv.rst | 14 the receiver or transmitter subdevice that implements them, so they are
44 hotplug pin as seen by the transmitter. Each bit corresponds to an
45 output pad on the transmitter. If an output pad does not have an
53 transmitter can sense that the receiver is ready to receive video).
54 Each bit corresponds to an output pad on the transmitter. If an
60 When the transmitter sees the hotplug signal from the receiver it
61 will attempt to read the EDID. If set, then the transmitter has read
63 output pad on the transmitter. If an output pad does not support
|
| D | ext-ctrls-fm-tx.rst | 6 FM Transmitter Control Reference
9 The FM Transmitter (FM_TX) class includes controls for common features
89 broadcasts speech. If the transmitter doesn't make this distinction,
|
| D | vidioc-g-edid.rst | 13 …- VIDIOC_SUBDEV_G_EDID - VIDIOC_SUBDEV_S_EDID - Get or set the EDID of a video receiver/transmitter
47 from a receiver or an output of a transmitter device. They can be used
88 receivers as it makes no sense for a transmitter.
|
| /Documentation/devicetree/bindings/media/ |
| D | si4713.txt | 1 * Silicon Labs FM Radio transmitter
3 The Silicon Labs Si4713 is an FM radio transmitter with receive power scan
|
| D | cec-gpio.txt | 16 If the CEC line is associated with an HDMI receiver/transmitter, then the
21 If the CEC line is not associated with an HDMI receiver/transmitter, then
|
| /Documentation/networking/device_drivers/hamradio/ |
| D | z8530drv.rst | 414 TxUnder number of transmitter underruns
416 TxInts number of transmitter interrupts
472 transmitter, until the first byte is sent. This is usually
476 MODEM and/or transmitter, that asserts CTS when the
477 transmitter is ready for data.
483 This is the probability that the transmitter will be keyed
499 The time the transmitter will remain keyed after the last
502 SCC before the transmitter is keyed down. The value depends
515 1: Fullduplex mode, i.e. the transmitter will be keyed at
518 2: Like 1, but the transmitter will remain keyed, also
[all …]
|
| /Documentation/admin-guide/media/ |
| D | radio-cardlist.rst | 12 si4713 Silicon Labs Si4713 FM Radio Transmitter
38 radio-keene Keene FM Transmitter USB
43 radio-usb-si4713 Silicon Labs Si4713 FM Radio Transmitter support with USB
|
| /Documentation/devicetree/bindings/hsi/ |
| D | client-devices.txt | 10 - hsi-tx-mode: Transmitter Bit transmission mode ("stream" or "frame")
13 transmitter
|
| /Documentation/input/devices/ |
| D | walkera0701.rst | 2 Walkera WK-0701 transmitter
5 Walkera WK-0701 transmitter is supplied with a ready to fly Walkera
7 this transmitter as joystick
19 At back side of transmitter S-video connector can be found. Modulation
|
| /Documentation/userspace-api/media/rc/ |
| D | lirc-set-transmitter-mask.rst | 35 :ref:`LIRC_CAN_SET_TRANSMITTER_MASK <LIRC-CAN-SET-TRANSMITTER-MASK>` is
39 This ioctl enables the given set of transmitters. The first transmitter is
|
| D | lirc-func.rst | 24 lirc-set-transmitter-mask
|
| D | rc-intro.rst | 19 device, as the IR receiver (and/or transmitter) can be used in
|
| /Documentation/driver-api/ |
| D | rfkill.rst | 13 transmitter in the system. When a transmitter is blocked, it shall not
48 transmitter with the kernel, methods for turning it on and off, and letting
73 a way to turn on/off the transmitter(s).
|
| /Documentation/devicetree/bindings/display/bridge/ |
| D | anx6345.yaml | 7 title: Analogix ANX6345 eDP Transmitter Device Tree Bindings
13 The ANX6345 is an ultra-low power Full-HD eDP transmitter designed for
|
| /Documentation/devicetree/bindings/leds/irled/ |
| D | pwm-ir-tx.txt | 2 remote controller transmitter.
|
| D | gpio-ir-tx.txt | 2 remote controller transmitter.
|
| /Documentation/devicetree/bindings/serial/ |
| D | cavium-uart.txt | 1 * Universal Asynchronous Receiver/Transmitter (UART)
|
| D | microchip,pic32-uart.txt | 1 * Microchip Universal Asynchronous Receiver Transmitter (UART)
|
| /Documentation/devicetree/bindings/net/ |
| D | sff,sfp.txt | 22 - tx-fault-gpios : GPIO phandle and a specifier of the Module Transmitter
25 - tx-disable-gpios : GPIO phandle and a specifier of the Transmitter Disable
|
1234