| /drivers/gpu/drm/nouveau/nvkm/subdev/pmu/fuc/ |
| D | i2c_.fuc | 142 */ not b32 $r5 /*
175 bra not $p1 #i2c_start_rep
177 bra not $p1 #i2c_start_rep
183 bra not $p1 #i2c_start_out
210 bra not $p1 #i2c_bitw_out
225 bra not $p1 #i2c_bitr_done
240 bra not $p1 #i2c_get_byte_done
255 bra not $p1 #i2c_put_byte_done
259 bra not $p1 #i2c_put_byte_done
269 bra not $p1 #i2c_addr_done
[all …]
|
| /drivers/block/paride/ |
| D | Transition-notes | 7 Consider the sequnce of these events. A can not be preceded by
11 IOW, the sequence is A?(BA|BC|B)*. OTOH, number of B can not exceed
16 since at any time number of B can not exceed the number of these
17 moments which, in turn, can not exceed the number of A and C.
58 Proof: consider the first moment when the above is not true.
60 (1) can become not true if some thread enters that area while another is there.
63 the thread was holding pd_lock and found pd_busy not set, which would
64 mean that (2) was already not true.
70 (3) was already not true.
79 pd.c. It means that (4) was already not true.
[all …]
|
| /drivers/char/mwave/ |
| D | README | 5 are not saved by the BIOS and so do not persist after unload and reload.
18 If the dsp irq has not been setup and stored in bios by the
23 If the dsp io range has not been setup and stored in bios by the
28 If the mwave's uart irq has not been setup and stored in bios by the
33 If the uart io range has not been setup and stored in bios by the
|
| /drivers/leds/ |
| D | TODO | 11 Calls that may and that may not block are mixed in same structure, and
13 not sleep.) Review the requirements for any bugs and document them
23 LEDs not on the list?
36 RGB, and not even RGB-White or RGB-Yellow variants emerged.
38 Multicolor is not a good fit for RGB LED. It does not really know
42 color", which not all multicolor LEDs can.
57 /sys interface is not really suitable to use by hand, should we have
|
| /drivers/gpu/drm/i915/selftests/ |
| D | i915_sw_fence.c | 661 struct i915_sw_fence *timeout = NULL, *not = NULL; in test_dma_fence() local
677 not = wrap_dma_fence(dma, 0); in test_dma_fence()
678 if (IS_ERR(not)) { in test_dma_fence()
679 err = PTR_ERR(not); in test_dma_fence()
684 if (i915_sw_fence_done(timeout) || i915_sw_fence_done(not)) { in test_dma_fence()
700 if (i915_sw_fence_done(timeout) || i915_sw_fence_done(not)) { in test_dma_fence()
712 if (i915_sw_fence_done(not)) { in test_dma_fence()
720 if (!i915_sw_fence_done(timeout) || !i915_sw_fence_done(not)) { in test_dma_fence()
725 free_fence(not); in test_dma_fence()
735 if (!IS_ERR_OR_NULL(not)) in test_dma_fence()
[all …]
|
| /drivers/net/wireless/intersil/orinoco/ |
| D | Kconfig | 18 Apple Airport (not a PCMCIA card), WavelanIEEE/Orinoco,
39 would not support WPA or firmware download for Prism chipset.
41 If you are not sure, say N.
56 If you are not sure, say Y.
67 This driver does not support the Airport Extreme (802.11b/g). Use
76 adaptors are not a full PCMCIA controller but act as a more limited
87 adaptors are not a full PCMCIA controller but act as a more limited
97 adaptors are not full PCMCIA controllers, but act as a more limited
105 the Prism 2.5 chipset. These are true PCI cards, not the 802.11b
|
| /drivers/net/ethernet/chelsio/cxgb4/ |
| D | t4_pci_id_tbl.h | 64 #error CH_PCI_DEVICE_ID_FUNCTION not defined!
67 #error CH_PCI_ID_TABLE_ENTRY not defined!
70 #error CH_PCI_DEVICE_ID_TABLE_DEFINE_END not defined!
|
| /drivers/bcma/ |
| D | README | 8 1) Broadcom specific AMBA device. It is put on AMBA bus, but can not be treated
11 and PIDs (0x103BB369), but we do not use that info for anything. One of that
14 Addresses of AMBA devices are not hardcoded in driver and have to be read from
|
| /drivers/staging/ks7010/ |
| D | TODO | 17 First a few words what not to do (at least not blindly):
25 that you are not only silencing the warning but really fixing code. You
|
| /drivers/of/unittest-data/ |
| D | overlay_base.dts | 8 * Do not add any properties in node "/".
9 * Do not add any nodes other than "/testcase-data-2" in node "/".
10 * Do not add anything that would result in dtc creating node "/__fixups__".
|
| D | overlay_bad_add_dup_prop.dts | 14 * The previous version of this test did not include the extra
22 * memory leak and thus people who use kmemleak will not
|
| /drivers/media/pci/ivtv/ |
| D | Kconfig | 39 Those ioctls were not needed for a long time, as IVTV implements
79 With PAT enabled, the cx23415 framebuffer driver does not
82 when initializied on a kernel with PAT enabled (i.e. not
85 The driver is not easily upgradable to the PAT-aware
|
| /drivers/staging/media/meson/vdec/ |
| D | TODO | 4 It is at the moment not guaranteed to work properly with a userspace
6 with compression standards like MPEG1/2 where the driver does not support
|
| /drivers/staging/iio/Documentation/ |
| D | sysfs-bus-iio-dds | 19 registers Y is not present. It is also possible X is not present
49 Y is not present. It is also possible X is not present if
|
| /drivers/mtd/ |
| D | Kconfig | 24 test. Do not use these tests unless you really know what you do.
58 You do not need this option for use with the DiskOnChip devices. For
70 You do not need this option for use with the DiskOnChip devices. For
88 not use it.
105 not use it.
130 not use it.
189 suitable for swapping. The mapping of written blocks is not saved.
199 several partitions are present, but not both. The concern was that
|
| /drivers/media/usb/pvrusb2/ |
| D | Kconfig | 28 This is not generally needed for v4l applications,
51 If your device does not support digital television, this
63 You do not need to select this option unless you plan
|
| /drivers/staging/unisys/visorinput/ |
| D | Kconfig | 13 GOP protocol, so If this driver is not present, the Linux guest should
15 and mouse interaction will not be available.
|
| /drivers/staging/unisys/visornic/ |
| D | Kconfig | 14 s-Par switches will not work if this driver is not selected.
|
| /drivers/media/pci/tw686x/ |
| D | Kconfig | 14 - TW6865 (4 video channels, not tested, second generation chip),
16 built-in video decoder are supported, not tested),
|
| /drivers/mtd/ubi/ |
| D | Kconfig | 29 to 128 or 256, although it does not have to be power of 2).
38 flash does not admit of bad eraseblocks (e.g. NOR flash), this value
49 will be 1.9% of eraseblocks on the entire NAND chip, not just the MTD
72 attaching by scanning takes long. UBI will not automatically install
88 work on top of UBI. Do not enable this unless you use legacy
|
| /drivers/net/wireless/intel/ipw2x00/ |
| D | Kconfig | 64 If you are not trying to debug or develop the IPW2100 driver, you
134 If you do not specify 'rtap_iface=1' as a module parameter then
135 the rtap interface will not be created and you will need to turn
153 will typically not need this high verbosity debug information.
155 If you are not sure, say N here.
194 If you are not trying to debug or develop the libipw
|
| /drivers/usb/ |
| D | Kconfig | 68 do not have USB 2.0 support. It doesn't normally hurt to select
69 them all if you are not certain.
92 will not be built in the USB driver.
149 Manual mode is not limited to printers, any parallel port
153 applications might not work.
|
| /drivers/base/ |
| D | Kconfig | 12 This should not be used today, because usual systems create
55 This option does not affect initramfs based booting, here
76 driver firmware at kernel build time. These drivers do not use the
82 Firmware should not be being built as part of kernel, these days
103 not; if disabled, the mechanism will be omitted even if drivers that
106 to ever access the information to not have the code, nor keep any
|
| /drivers/accessibility/speakup/ |
| D | TODO | 12 gets garbled because a lock is not set. This bug happens regularly, but no one
18 not want to subscribe to a mailing list, send your email to all of the
|
| /drivers/misc/sgi-xp/ |
| D | xp_uv.c | 114 #error not a supported configuration in xp_expand_memprotect_uv()
144 #error not a supported configuration in xp_restrict_memprotect_uv()
|