| /drivers/tty/serial/jsm/ |
| D | jsm_tty.c | 210 jsm_dbg(INIT, &channel->ch_bd->pci_dev, in jsm_tty_open()
218 jsm_dbg(INIT, &channel->ch_bd->pci_dev, in jsm_tty_open()
375 jsm_dbg(INIT, &brd->pci_dev, "start\n"); in jsm_tty_init()
428 jsm_dbg(INIT, &brd->pci_dev, "finish\n"); in jsm_tty_init()
440 jsm_dbg(INIT, &brd->pci_dev, "start\n"); in jsm_uart_port_init()
476 jsm_dbg(INIT, &brd->pci_dev, "finish\n"); in jsm_uart_port_init()
488 jsm_dbg(INIT, &brd->pci_dev, "start\n"); in jsm_remove_uart_port()
508 jsm_dbg(INIT, &brd->pci_dev, "finish\n"); in jsm_remove_uart_port()
|
| D | jsm_driver.c | 124 jsm_dbg(INIT, &brd->pci_dev, in jsm_probe_one()
187 jsm_dbg(INIT, &brd->pci_dev, "jsm_found_board - NEO adapter\n"); in jsm_probe_one()
|
| /drivers/scsi/ |
| D | aha1542.h | 12 #define INIT BIT(5) /* Mailbox Initialization Required */ macro
18 #define STATMASK (STST | DIAGF | INIT | IDLE | CDF | DF | INVDCMD)
|
| D | aha1542.c | 212 if (!wait_mask(STATUS(sh->io_port), STATMASK, INIT | IDLE, STST | DIAGF | INVDCMD | DF | CDF, 0)) in aha1542_test_port()
|
| /drivers/scsi/pm8001/ |
| D | pm8001_init.c | 274 pm8001_dbg(pm8001_ha, INIT, "pm8001_alloc: PHY:%x\n", in pm8001_alloc()
460 pm8001_dbg(pm8001_ha, INIT, in pm8001_ioremap()
463 pm8001_dbg(pm8001_ha, INIT, in pm8001_ioremap()
677 pm8001_dbg(pm8001_ha, INIT, "mem alloc fail\n"); in pm8001_init_sas_add()
683 pm8001_dbg(pm8001_ha, INIT, "nvmd failed\n"); in pm8001_init_sas_add()
711 pm8001_dbg(pm8001_ha, INIT, "phy %d sas_addr = %016llx\n", i, in pm8001_init_sas_add()
752 pm8001_dbg(pm8001_ha, INIT, "nvmd failed\n"); in pm8001_get_phy_settings_info()
846 pm8001_dbg(pm8001_ha, INIT, in pm8001_get_phy_mask()
942 pm8001_dbg(pm8001_ha, INIT, in pm8001_setup_msix()
956 pm8001_dbg(pm8001_ha, INIT, in pm8001_request_msix()
[all …]
|
| D | pm80xx_hwi.c | 1141 pm8001_dbg(pm8001_ha, INIT, "Scratchpad 0 PCI BAR: %d\n", pcibar); in init_pci_device_addresses()
1163 pm8001_dbg(pm8001_ha, INIT, "GST OFFSET 0x%x\n", in init_pci_device_addresses()
1165 pm8001_dbg(pm8001_ha, INIT, "INBND OFFSET 0x%x\n", in init_pci_device_addresses()
1167 pm8001_dbg(pm8001_ha, INIT, "OBND OFFSET 0x%x\n", in init_pci_device_addresses()
1169 pm8001_dbg(pm8001_ha, INIT, "IVT OFFSET 0x%x\n", in init_pci_device_addresses()
1171 pm8001_dbg(pm8001_ha, INIT, "PSPA OFFSET 0x%x\n", in init_pci_device_addresses()
1173 pm8001_dbg(pm8001_ha, INIT, "addr - main cfg %p general status %p\n", in init_pci_device_addresses()
1176 pm8001_dbg(pm8001_ha, INIT, "addr - inbnd %p obnd %p\n", in init_pci_device_addresses()
1179 pm8001_dbg(pm8001_ha, INIT, "addr - pspa %p ivt %p\n", in init_pci_device_addresses()
1272 pm8001_dbg(pm8001_ha, INIT, "SASConfigPage.pageCode 0x%08x\n", in pm80xx_set_sas_protocol_timer_config()
[all …]
|
| D | pm8001_hwi.c | 403 pm8001_dbg(pm8001_ha, INIT, in pm8001_bar4_shift()
626 pm8001_dbg(pm8001_ha, INIT, "Scratchpad 0 Offset: %x\n", offset); in init_pci_device_addresses()
629 pm8001_dbg(pm8001_ha, INIT, "Scratchpad 0 PCI BAR: %d\n", pcibar); in init_pci_device_addresses()
686 pm8001_dbg(pm8001_ha, INIT, "MPI initialize successful!\n"); in pm8001_chip_init()
768 pm8001_dbg(pm8001_ha, INIT, "Firmware is ready for reset.\n"); in soft_reset_ready_check()
837 pm8001_dbg(pm8001_ha, INIT, "MBIC - NMI Enable VPE0 (IOP)= 0x%x\n", in pm8001_chip_soft_rst()
848 pm8001_dbg(pm8001_ha, INIT, "MBIC - NMI Enable VPE0 (AAP1)= 0x%x\n", in pm8001_chip_soft_rst()
853 pm8001_dbg(pm8001_ha, INIT, "PCIE -Event Interrupt Enable = 0x%x\n", in pm8001_chip_soft_rst()
858 pm8001_dbg(pm8001_ha, INIT, "PCIE - Event Interrupt = 0x%x\n", in pm8001_chip_soft_rst()
863 pm8001_dbg(pm8001_ha, INIT, "PCIE -Error Interrupt Enable = 0x%x\n", in pm8001_chip_soft_rst()
[all …]
|
| /drivers/net/ethernet/dec/tulip/ |
| D | de4x5.c | 2368 lp->media = INIT; in autoconf_media()
2397 case INIT: in dc21040_autoconf()
2451 lp->media = INIT; in dc21040_autoconf()
2525 lp->media = INIT; in de4x5_suspect_state()
2551 case INIT: in dc21041_autoconf()
2731 lp->media = INIT; in dc21041_autoconf()
2753 case INIT: in dc21140m_autoconf()
2875 lp->media = INIT; in dc21140m_autoconf()
2893 lp->media = INIT; in dc21140m_autoconf()
2906 lp->media = INIT; in dc21140m_autoconf()
[all …]
|
| D | de4x5.h | 830 #define INIT 0x0200 /* Initial state */ macro
|
| /drivers/infiniband/hw/qib/ |
| D | qib_diag.c | 64 enum diag_state { UNUSED = 0, OPENED, INIT, READY }; enumerator
827 dc->state = INIT; in qib_diag_read()
851 ((*off || count != 8) || dc->state != INIT)) in qib_diag_write()
901 if (dc->state == INIT) in qib_diag_write()
|
| /drivers/net/ethernet/mellanox/mlx5/core/ |
| D | en_dcbnl.c | 1087 INIT, enumerator
1110 if (action == INIT) in mlx5e_dcbnl_dscp_app()
1116 priv->dcbx.dscp_app_cnt = (action == INIT) ? MLX5E_MAX_DSCP : 0; in mlx5e_dcbnl_dscp_app()
1121 mlx5e_dcbnl_dscp_app(priv, INIT); in mlx5e_dcbnl_init_app()
|
| /drivers/net/ethernet/amd/ |
| D | ariadne.h | 194 #define INIT 0x0100 /* Initialize */ macro
|
| D | ariadne.c | 257 lance->RDP = csr0 & ~(INEA | TDMD | STOP | STRT | INIT); in ariadne_interrupt()
277 if (csr0 & INIT) in ariadne_interrupt()
|
| /drivers/hsi/clients/ |
| D | ssi_protocol.c | 82 INIT, enumerator
672 case INIT: in ssip_rx_bootinforeq()
|
| /drivers/ata/ |
| D | sata_inic162x.c | 885 { PCI_VDEVICE(INIT, 0x1622), },
|
| /drivers/rapidio/devices/ |
| D | tsi721.c | 2759 tsi_debug(INIT, &pdev->dev, "res%d %pR", in tsi721_probe()
2798 tsi_debug(INIT, &pdev->dev, in tsi721_probe()
2808 tsi_debug(INIT, &pdev->dev, in tsi721_probe()
|
| D | rio_mport_cdev.c | 1891 rmcd_debug(INIT, "%s filp=%p", dev_name(&chdev->dev), filp); in mport_cdev_open()
2615 rmcd_debug(INIT, "Registered class with major=%d", MAJOR(dev_number)); in mport_init()
|
| /drivers/rapidio/ |
| D | rio_cm.c | 1482 riocm_debug(INIT, "by %s(%d) filp=%p ", in riocm_cdev_open()
2314 riocm_debug(INIT, "Registered class with %d major", dev_major); in riocm_init()
|
| /drivers/usb/atm/ |
| D | cxacru.c | 539 CXACRU_ALL_FILES(INIT);
|
| /drivers/dma/ |
| D | pl330.c | 388 INIT, enumerator
1990 pl330->state = INIT; in pl330_add()
|
| /drivers/auxdisplay/ |
| D | Kconfig | 373 Default for the 'RW' pin in custom profile is '16' (INIT).
|