| /drivers/scsi/smartpqi/ |
| D | Kconfig | 21 # THE PROGRAM IS PROVIDED ON AN "AS IS" BASIS, WITHOUT WARRANTIES OR
35 # ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR
|
| /drivers/net/wireless/broadcom/brcm80211/include/ |
| D | defs.h | 20 #define ON 1 /* ON = 1 */ macro
|
| /drivers/scsi/mpt3sas/ |
| D | Kconfig | 19 # THE PROGRAM IS PROVIDED ON AN "AS IS" BASIS, WITHOUT WARRANTIES OR
33 # ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR
|
| /drivers/video/fbdev/i810/ |
| D | i810_main.c | 431 i810_dram_off(mmio, ON); in i810_load_regs()
434 i810_screen_off(mmio, ON); in i810_load_regs()
435 i810_protect_regs(mmio, ON); in i810_load_regs()
568 i810_dram_off(mmio, ON); in i810_restore_2d()
598 i810_dram_off(mmio, ON); in i810_restore_vga_state()
600 i810_screen_off(mmio, ON); in i810_restore_vga_state()
601 i810_protect_regs(mmio, ON); in i810_restore_vga_state()
777 temp = (mode == ON) ? temp | CURSOR_ENABLE_MASK : in i810_enable_cursor()
1401 scr_off = ON; in i810fb_blank()
1540 i810_enable_cursor(mmio, ON); in i810fb_cursor()
|
| D | i810.h | 127 #define ON 1 macro
|
| D | i810_accel.c | 455 i810fb_iring_enable(par, ON); in i810fb_init_ringbuffer()
|
| /drivers/leds/trigger/ |
| D | Kconfig | 95 tristate "LED Default ON Trigger"
97 This allows LEDs to be initialised in the ON state.
|
| /drivers/net/caif/ |
| D | caif_serial.c | 34 #define ON 1 macro
261 ser->common.flowctrl(ser->dev, ON); in handle_tx()
|
| D | caif_hsi.c | 64 #define ON 1 macro
383 cfhsi->cfdev.flowctrl(cfhsi->ndev, ON); in cfhsi_tx_done()
|
| /drivers/net/wireless/broadcom/brcm80211/brcmsmac/ |
| D | stf.c | 133 if ((int_val != AUTO) && (int_val != OFF) && (int_val != ON)) in brcms_c_stf_stbc_tx_set()
136 if ((int_val == ON) && (wlc->stf->txstreams == 1)) in brcms_c_stf_stbc_tx_set()
|
| D | main.h | 217 (((wlc)->stf->txstreams > 1) && (((wlc)->band->band_stf_stbc_tx == ON) \
|
| D | main.c | 1758 if (ON == clk) in brcms_b_phyclk_fgc()
1767 if (ON == clk) in brcms_b_macphyclk_set()
1806 brcms_b_core_phy_clk(wlc_hw, ON); in brcms_b_phy_reset()
1808 wlc_phy_anacore(pih, ON); in brcms_b_phy_reset()
1828 brcms_b_core_phy_clk(wlc_hw, ON); in brcms_b_setband()
1940 brcms_b_xtal(wlc_hw, ON); in brcms_b_radio_read_hwdisabled()
3036 brcms_b_xtal(wlc_hw, ON); in brcms_b_pllreq()
3293 brcms_b_macphyclk_set(wlc_hw, ON); in brcms_b_coreinit()
4897 brcms_b_xtal(wlc_hw, ON); in brcms_b_hw_up()
4934 brcms_b_xtal(wlc_hw, ON); in brcms_b_up_prep()
|
| /drivers/mfd/ |
| D | tps65010.c | 454 tps65010_set_led(offset - 3, value ? ON : OFF); in tps65010_gpio_set()
471 tps65010_set_led(offset - 3, value ? ON : OFF); in tps65010_output()
793 case ON: in tps65010_set_led()
|
| D | db8500-prcmu.c | 1199 writeb((enable ? ON : OFF), (tcdm_base + PRCM_REQ_MB3_SYSCLK_MGT)); in request_sysclk()
|
| /drivers/block/ |
| D | swim.c | 198 ON, enumerator
321 if (action == ON) { in swim_motor()
626 swim_motor(base, ON); in floppy_open()
|
| /drivers/misc/mei/ |
| D | init.c | 40 MEI_PG_STATE(ON); in mei_pg_state_str()
|
| /drivers/pinctrl/bcm/ |
| D | Kconfig | 47 the always-ON GPIO controller (CRMU/AON). All 3 GPIO controllers are
|
| /drivers/edac/ |
| D | amd64_edac.h | 101 #define ON true macro
|
| /drivers/input/misc/ |
| D | Kconfig | 226 tristate "MC13783 ON buttons"
229 Support the ON buttons of MC13783 PMIC as an input device
655 tristate "WM831X ON pin"
658 Support the ON pin of WM831X PMICs as an input device
|
| /drivers/net/wireless/broadcom/brcm80211/brcmsmac/phy/ |
| D | phy_cmn.c | 486 wlc_phy_anacore((struct brcms_phy_pub *) pi, ON); in wlc_phy_attach()
763 wlc_phy_anacore(pih, ON); in wlc_phy_init()
771 wlc_phy_switch_radio((struct brcms_phy_pub *) pi, ON); in wlc_phy_init()
1056 wlc_phy_pa_override_nphy(pi, ON); in wlc_phy_do_dummy_tx()
1820 if (start_end == ON) { in wlc_phy_runbist_config()
|
| /drivers/video/fbdev/ |
| D | gbefb.c | 433 SET_GBE_FIELD(FP_DE, ON, outputVal, fp_vbs); in gbefb_setup_flatpanel()
440 SET_GBE_FIELD(FP_VDRV, ON, outputVal, 1); in gbefb_setup_flatpanel()
|
| /drivers/iio/light/ |
| D | Kconfig | 372 tristate "ON Semiconductor NOA1305 ambient light sensor"
376 Say Y here if you want to build support for the ON Semiconductor
|
| /drivers/net/ethernet/emulex/benet/ |
| D | be_main.c | 1511 status = be_cmd_rx_filter(adapter, BE_IF_FLAGS_VLAN_PROMISCUOUS, ON); in be_set_vlan_promisc()
1621 be_cmd_rx_filter(adapter, BE_IF_FLAGS_ALL_PROMISCUOUS, ON); in be_set_all_promisc()
1632 status = be_cmd_rx_filter(adapter, BE_IF_FLAGS_MCAST_PROMISCUOUS, ON); in be_set_mc_promisc()
1644 status = be_cmd_rx_filter(adapter, BE_IF_FLAGS_PROMISCUOUS, ON); in be_set_uc_promisc()
1725 status = be_cmd_rx_filter(adapter, BE_IF_FLAGS_MULTICAST, ON); in be_set_mc_list()
3757 status = be_cmd_rx_filter(adapter, BE_IF_FILT_FLAGS_BASIC, ON); in be_enable_if_filters()
|
| D | be.h | 691 #define ON 1 macro
|
| /drivers/scsi/aic7xxx/ |
| D | aic7xxx.reg | 35 * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT,
|