Home
last modified time | relevance | path

Searched refs:pairs (Results 1 – 10 of 10) sorted by relevance

/drivers/gpu/drm/vmwgfx/
Dvmwgfx_ioctl.c35 SVGA3dCapPair pairs[SVGA3D_DEVCAP_MAX]; member
154 size_t pair_offset = offsetof(struct svga_3d_compat_cap, pairs); in vmw_fill_compat_cap()
172 compat_cap->pairs[i][0] = i; in vmw_fill_compat_cap()
173 compat_cap->pairs[i][1] = vmw_mask_legacy_multisample in vmw_fill_compat_cap()
/drivers/memory/tegra/
Dtegra186-emc.c216 emc->dvfs[i].rate = response.pairs[i].freq * 1000; in tegra186_emc_probe()
217 emc->dvfs[i].latency = response.pairs[i].latency; in tegra186_emc_probe()
/drivers/opp/
DKconfig7 voltage pairs that the device will support per voltage domain. This
/drivers/gpu/drm/i2c/
DKconfig20 when used in pairs) TMDS transmitters, used in some nVidia
/drivers/firmware/broadcom/
DKconfig9 pairs.
/drivers/net/ethernet/intel/iavf/
Diavf_virtchnl.c245 int pairs = adapter->num_active_queues; in iavf_configure_queues() local
259 len = struct_size(vqci, qpair, pairs); in iavf_configure_queues()
270 vqci->num_queue_pairs = pairs; in iavf_configure_queues()
275 for (i = 0; i < pairs; i++) { in iavf_configure_queues()
Diavf_main.c1176 int pairs = 0; in iavf_set_interrupt_capability() local
1183 pairs = adapter->num_active_queues; in iavf_set_interrupt_capability()
1190 v_budget = min_t(int, pairs + NONQ_VECS, in iavf_set_interrupt_capability()
1206 netif_set_real_num_rx_queues(adapter->netdev, pairs); in iavf_set_interrupt_capability()
1207 netif_set_real_num_tx_queues(adapter->netdev, pairs); in iavf_set_interrupt_capability()
/drivers/mtd/chips/
DKconfig138 If your flash chips are interleaved in pairs - i.e. you have two
/drivers/usb/misc/
DKconfig200 VID/PID pairs. This driver then initiates a corresponding test mode on
/drivers/net/
DKconfig389 This device is a local ethernet tunnel. Devices are created in pairs.