1// SPDX-License-Identifier: GPL-2.0+ OR MIT 2// 3// Copyright 2015 Freescale Semiconductor, Inc. 4// Copyright 2016 Toradex AG 5 6#include "imx7s.dtsi" 7#include <dt-bindings/reset/imx7-reset.h> 8 9/ { 10 aliases { 11 usb0 = &usbotg1; 12 usb1 = &usbotg2; 13 usb2 = &usbh; 14 }; 15 16 cpus { 17 cpu0: cpu@0 { 18 clock-frequency = <996000000>; 19 operating-points-v2 = <&cpu0_opp_table>; 20 #cooling-cells = <2>; 21 nvmem-cells = <&fuse_grade>; 22 nvmem-cell-names = "speed_grade"; 23 }; 24 25 cpu1: cpu@1 { 26 compatible = "arm,cortex-a7"; 27 device_type = "cpu"; 28 reg = <1>; 29 clock-frequency = <996000000>; 30 operating-points-v2 = <&cpu0_opp_table>; 31 #cooling-cells = <2>; 32 cpu-idle-states = <&cpu_sleep_wait>; 33 }; 34 }; 35 36 timer { 37 compatible = "arm,armv7-timer"; 38 interrupt-parent = <&intc>; 39 interrupts = <GIC_PPI 13 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>, 40 <GIC_PPI 14 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>, 41 <GIC_PPI 11 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>, 42 <GIC_PPI 10 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>; 43 }; 44 45 cpu0_opp_table: opp-table { 46 compatible = "operating-points-v2"; 47 opp-shared; 48 49 opp-792000000 { 50 opp-hz = /bits/ 64 <792000000>; 51 opp-microvolt = <1000000>; 52 clock-latency-ns = <150000>; 53 opp-supported-hw = <0xd>, <0x7>; 54 opp-suspend; 55 }; 56 57 opp-996000000 { 58 opp-hz = /bits/ 64 <996000000>; 59 opp-microvolt = <1100000>; 60 clock-latency-ns = <150000>; 61 opp-supported-hw = <0xc>, <0x7>; 62 opp-suspend; 63 }; 64 65 opp-1200000000 { 66 opp-hz = /bits/ 64 <1200000000>; 67 opp-microvolt = <1225000>; 68 clock-latency-ns = <150000>; 69 opp-supported-hw = <0x8>, <0x3>; 70 opp-suspend; 71 }; 72 }; 73 74 usbphynop2: usbphynop2 { 75 compatible = "usb-nop-xceiv"; 76 clocks = <&clks IMX7D_USB_PHY2_CLK>; 77 clock-names = "main_clk"; 78 #phy-cells = <0>; 79 }; 80 81 soc { 82 etm@3007d000 { 83 compatible = "arm,coresight-etm3x", "arm,primecell"; 84 reg = <0x3007d000 0x1000>; 85 86 /* 87 * System will hang if added nosmp in kernel command line 88 * without arm,primecell-periphid because amba bus try to 89 * read id and core1 power off at this time. 90 */ 91 arm,primecell-periphid = <0xbb956>; 92 cpu = <&cpu1>; 93 clocks = <&clks IMX7D_MAIN_AXI_ROOT_CLK>; 94 clock-names = "apb_pclk"; 95 96 out-ports { 97 port { 98 etm1_out_port: endpoint { 99 remote-endpoint = <&ca_funnel_in_port1>; 100 }; 101 }; 102 }; 103 }; 104 105 intc: interrupt-controller@31001000 { 106 compatible = "arm,cortex-a7-gic"; 107 interrupts = <GIC_PPI 9 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_HIGH)>; 108 #interrupt-cells = <3>; 109 interrupt-controller; 110 interrupt-parent = <&intc>; 111 reg = <0x31001000 0x1000>, 112 <0x31002000 0x2000>, 113 <0x31004000 0x2000>, 114 <0x31006000 0x2000>; 115 }; 116 }; 117}; 118 119&aips2 { 120 pcie_phy: pcie-phy@306d0000 { 121 compatible = "fsl,imx7d-pcie-phy"; 122 reg = <0x306d0000 0x10000>; 123 status = "disabled"; 124 }; 125}; 126 127&aips3 { 128 usbotg2: usb@30b20000 { 129 compatible = "fsl,imx7d-usb", "fsl,imx27-usb"; 130 reg = <0x30b20000 0x200>; 131 interrupts = <GIC_SPI 42 IRQ_TYPE_LEVEL_HIGH>; 132 clocks = <&clks IMX7D_USB_CTRL_CLK>; 133 fsl,usbphy = <&usbphynop2>; 134 fsl,usbmisc = <&usbmisc2 0>; 135 phy-clkgate-delay-us = <400>; 136 status = "disabled"; 137 }; 138 139 usbmisc2: usbmisc@30b20200 { 140 #index-cells = <1>; 141 compatible = "fsl,imx7d-usbmisc", "fsl,imx6q-usbmisc"; 142 reg = <0x30b20200 0x200>; 143 }; 144 145 fec2: ethernet@30bf0000 { 146 compatible = "fsl,imx7d-fec", "fsl,imx6sx-fec"; 147 reg = <0x30bf0000 0x10000>; 148 interrupt-names = "int0", "int1", "int2", "pps"; 149 interrupts = <GIC_SPI 102 IRQ_TYPE_LEVEL_HIGH>, 150 <GIC_SPI 100 IRQ_TYPE_LEVEL_HIGH>, 151 <GIC_SPI 101 IRQ_TYPE_LEVEL_HIGH>, 152 <GIC_SPI 103 IRQ_TYPE_LEVEL_HIGH>; 153 clocks = <&clks IMX7D_ENET2_IPG_ROOT_CLK>, 154 <&clks IMX7D_ENET_AXI_ROOT_CLK>, 155 <&clks IMX7D_ENET2_TIME_ROOT_CLK>, 156 <&clks IMX7D_PLL_ENET_MAIN_125M_CLK>, 157 <&clks IMX7D_ENET_PHY_REF_ROOT_CLK>; 158 clock-names = "ipg", "ahb", "ptp", 159 "enet_clk_ref", "enet_out"; 160 fsl,num-tx-queues = <3>; 161 fsl,num-rx-queues = <3>; 162 fsl,stop-mode = <&gpr 0x10 4>; 163 status = "disabled"; 164 }; 165 166 pcie: pcie@33800000 { 167 compatible = "fsl,imx7d-pcie", "snps,dw-pcie"; 168 reg = <0x33800000 0x4000>, 169 <0x4ff00000 0x80000>; 170 reg-names = "dbi", "config"; 171 #address-cells = <3>; 172 #size-cells = <2>; 173 device_type = "pci"; 174 bus-range = <0x00 0xff>; 175 ranges = <0x81000000 0 0 0x4ff80000 0 0x00010000 /* downstream I/O */ 176 0x82000000 0 0x40000000 0x40000000 0 0x0ff00000>; /* non-prefetchable memory */ 177 num-lanes = <1>; 178 num-viewport = <4>; 179 interrupts = <GIC_SPI 122 IRQ_TYPE_LEVEL_HIGH>; 180 interrupt-names = "msi"; 181 #interrupt-cells = <1>; 182 interrupt-map-mask = <0 0 0 0x7>; 183 /* 184 * Reference manual lists pci irqs incorrectly 185 * Real hardware ordering is same as imx6: D+MSI, C, B, A 186 */ 187 interrupt-map = <0 0 0 1 &intc GIC_SPI 125 IRQ_TYPE_LEVEL_HIGH>, 188 <0 0 0 2 &intc GIC_SPI 124 IRQ_TYPE_LEVEL_HIGH>, 189 <0 0 0 3 &intc GIC_SPI 123 IRQ_TYPE_LEVEL_HIGH>, 190 <0 0 0 4 &intc GIC_SPI 122 IRQ_TYPE_LEVEL_HIGH>; 191 clocks = <&clks IMX7D_PCIE_CTRL_ROOT_CLK>, 192 <&clks IMX7D_PLL_ENET_MAIN_100M_CLK>, 193 <&clks IMX7D_PCIE_PHY_ROOT_CLK>; 194 clock-names = "pcie", "pcie_bus", "pcie_phy"; 195 assigned-clocks = <&clks IMX7D_PCIE_CTRL_ROOT_SRC>, 196 <&clks IMX7D_PCIE_PHY_ROOT_SRC>; 197 assigned-clock-parents = <&clks IMX7D_PLL_ENET_MAIN_250M_CLK>, 198 <&clks IMX7D_PLL_ENET_MAIN_100M_CLK>; 199 200 fsl,max-link-speed = <2>; 201 power-domains = <&pgc_pcie_phy>; 202 resets = <&src IMX7_RESET_PCIEPHY>, 203 <&src IMX7_RESET_PCIE_CTRL_APPS_EN>, 204 <&src IMX7_RESET_PCIE_CTRL_APPS_TURNOFF>; 205 reset-names = "pciephy", "apps", "turnoff"; 206 fsl,imx7d-pcie-phy = <&pcie_phy>; 207 status = "disabled"; 208 }; 209}; 210 211&ca_funnel_in_ports { 212 port@1 { 213 reg = <1>; 214 ca_funnel_in_port1: endpoint { 215 remote-endpoint = <&etm1_out_port>; 216 }; 217 }; 218}; 219