Searched refs:Add (Results 1 – 25 of 38) sorted by relevance
12
10 Add an FDT blob for XLP EVP boards into the kernel.20 Add an FDT blob for XLP VP boards into the kernel.30 Add an FDT blob for XLP FVP board into the kernel.40 Add an FDT blob for XLP GVP board into the kernel.49 Add an FDT blob for XLP RVP board into the kernel.59 Add support for boards with 2 or 4 XLPs connected over ICI.
65 #gpio-cells = <2>; // Add 'gpio-controller;' to enable gpio mode73 #gpio-cells = <2>; // Add 'gpio-controller;' to enable gpio mode80 #gpio-cells = <2>; // Add 'gpio-controller;' to enable gpio mode87 #gpio-cells = <2>; // Add 'gpio-controller;' to enable gpio mode94 #gpio-cells = <2>; // Add 'gpio-controller;' to enable gpio mode101 #gpio-cells = <2>; // Add 'gpio-controller;' to enable gpio mode108 #gpio-cells = <2>; // Add 'gpio-controller;' to enable gpio mode115 #gpio-cells = <2>; // Add 'gpio-controller;' to enable gpio mode
19 Add support for old Broadcom BCM47xx boards with Sonics Silicon Backplane support.36 Add support for new Broadcom BCM47xx boards with Broadcom specific Advanced Microcontroller Bus.
20 Add extra files to (debugfs)/ras/cec to test the correctable error
57 * Add the phy clock here, so the phy can be accessed to read its
15 * REVISIT: Add timing support from slls644g.pdf
174 * Add SPI CS pins for clearfog:
156 /* Add legacy interrupts for SATA devices only */
230 * Add SPI CS pins for clearfog:
144 /* Add pullup to DATA line */
101 * Add some discrete steps to help throttling system deal
503 /* Add the DAT31 pin even if it is not really used */
35 | A5. Add using the carry the 64-bit quantities in d2:d3 and d4:d5102 | A5. Add mul by 8 to mul by 2. D1 contains the digit formed.
93 | Source is positive. Add the src to the dest exponent.142 | Source is negative. Add the src to the dest exponent.
82 addq v0, a2, v0 # E : Add in the bit number from above
101 bool "Add PCI control unit support of NEC VR4100 series"
72 Add -Werror to the build flags for KVM.
11 * fpa11.h - Add documentation
117 # Add reg to mem using reg-mem add and store229 # Add three components, w[t-16], w[t-7] and sigma0295 # Add sigma1 to the other compunents to get w[16] and w[17]351 # Add the sigma0 + w[t-7] + w[t-16] for w[18] and w[19]
59 Add a number of spare GPIO entries between each bank for debugging
1381 #define MDCNFG_RowAdd(Add) /* Row Address count [9..12] */ \ argument1382 (((Add) - 9) << FShft (MDCNFG_DRAC))
114 Add several files to the debugfs to test spinlock speed.
120 Add /lib (and /lib64 for 64-bit) to the linux binary's rpath
8 # Add 1024 to <number> will get the actual system call number
261 orr r3, r8, r7 @ Add the MMU flags