Searched refs:custom (Results 1 – 19 of 19) sorted by relevance
26 #define custom amiga_custom macro90 custom.aud[2].audlc = snd_data; in amiga_mksound()91 custom.aud[2].audlen = sizeof(sine_data)/2; in amiga_mksound()92 custom.aud[2].audper = (unsigned short)period; in amiga_mksound()93 custom.aud[2].audvol = 32; /* 50% of maxvol */ in amiga_mksound()101 custom.dmacon = DMAF_SETCLR | DMAF_AUD2; in amiga_mksound()113 custom.dmacon = DMAF_AUD2; in nosound()115 custom.aud[2].audper = amiga_audio_period; in nosound()
103 bool "Byteswap custom instruction"105 Use the byteswap (endian converter) Nios II custom instruction provided110 int "Byteswap custom instruction number" if NIOS2_CI_SWAB_SUPPORT
32 which do not need custom platform specific setup.
145 bool "Set custom kernel MMU region base address"159 bool "Set custom kernel region base address"171 bool "Set custom I/O region base address"
57 /* Note: HW flow control is broken, hence using custom CTS/RTS gpios */
197 * point by default. Higher frequencies must be enabled for custom boards with
45 #error Your custom IO space is getting a bit large !!
14 do not need a custom platform specific setup. Such boards are
107 // 8-bit custom Anybus Module on LocalPlus Bus CS3
178 custom OMAP boards. Say Y here if you have a custom
180 bool "Set custom kernel base address"195 bool "Set custom user task size"
19 * This can be bypassed by patching the bootloader from a custom HYP firmware,
91 The Q40 custom chip is programmable to provide 2 periodic timers:
781 bool "Set custom data alignment"1150 bool "Set custom page offset address"1164 bool "Set custom kernel base address"1202 bool "Set custom user task size"
1380 clrl L(custom)2838 lea %pc@(L(custom)),%a03000 movel %pc@(L(custom)),%a03751 L(custom):
240 unwinding kernel stack traces. It uses a custom data format which is
121 Select this variant to use a custom Xtensa processor configuration.129 Provide the name of a custom Xtensa processor variant.
857 A custom interval value (in seconds) can be written to
1333 and may fail with non-standard SMM or custom software models.1340 This option selects UART0 at 0x10009000. Except for custom models,