| /drivers/net/wireless/broadcom/brcm80211/brcmfmac/ |
| D | pcie.c | 577 brcmf_dbg(PCIE, "config offset 0x%04x, value 0x%04x\n", in brcmf_pcie_reset_device()
648 brcmf_dbg(PCIE, "MB transaction is already pending 0x%04x\n", in brcmf_pcie_send_mb_data()
687 brcmf_dbg(PCIE, "D2H_MB_DATA: 0x%04x\n", dtoh_mb_data); in brcmf_pcie_handle_mb_data()
689 brcmf_dbg(PCIE, "D2H_MB_DATA: DEEP SLEEP REQ\n"); in brcmf_pcie_handle_mb_data()
691 brcmf_dbg(PCIE, "D2H_MB_DATA: sent DEEP SLEEP ACK\n"); in brcmf_pcie_handle_mb_data()
694 brcmf_dbg(PCIE, "D2H_MB_DATA: DEEP SLEEP EXIT\n"); in brcmf_pcie_handle_mb_data()
696 brcmf_dbg(PCIE, "D2H_MB_DATA: D3 ACK\n"); in brcmf_pcie_handle_mb_data()
701 brcmf_dbg(PCIE, "D2H_MB_DATA: FW HALT\n"); in brcmf_pcie_handle_mb_data()
805 brcmf_dbg(PCIE, "Enter\n"); in brcmf_pcie_quick_check_isr()
819 brcmf_dbg(PCIE, "Enter %x\n", status); in brcmf_pcie_isr_thread()
[all …]
|
| D | Kconfig | 41 bool "PCIE bus interface support for FullMAC driver"
47 This option enables the PCIE bus interface support for Broadcom
49 use the driver for an PCIE wireless card.
|
| /drivers/phy/amlogic/ |
| D | Kconfig | 42 tristate "Meson G12A USB3+PCIE Combo PHY driver"
48 Enable this to support the Meson USB3 + PCIE Combo PHY found
53 tristate "Meson AXG PCIE PHY driver"
59 Enable this to support the Meson MIPI + PCIE PHY found
64 tristate "Meson AXG MIPI + PCIE analog PHY driver"
71 Enable this to support the Meson MIPI + PCIE analog PHY
|
| /drivers/infiniband/hw/hfi1/ |
| D | chip_registers.h | 20 #define PCIE 0 macro
584 #define PCI_CFG_MSIX0 (PCIE + 0x0000000000B0)
585 #define PCI_CFG_REG1 (PCIE + 0x000000000004)
586 #define PCI_CFG_REG11 (PCIE + 0x00000000002C)
587 #define PCIE_CFG_SPCIE1 (PCIE + 0x00000000014C)
588 #define PCIE_CFG_SPCIE2 (PCIE + 0x000000000150)
589 #define PCIE_CFG_TPH2 (PCIE + 0x000000000180)
1269 #define PCIE_CFG_REG_PL2 (PCIE + 0x000000000708)
1270 #define PCIE_CFG_REG_PL3 (PCIE + 0x00000000070C)
1273 #define PCIE_CFG_REG_PL102 (PCIE + 0x000000000898)
[all …]
|
| /drivers/phy/st/ |
| D | phy-spear1340-miphy.c | 76 PCIE, enumerator
163 else if (priv->mode == PCIE) in spear1340_miphy_init()
176 else if (priv->mode == PCIE) in spear1340_miphy_exit()
233 if (priv->mode != SATA && priv->mode != PCIE) { in spear1340_miphy_xlate()
|
| D | phy-spear1310-miphy.c | 97 PCIE, enumerator
155 if (priv->mode == PCIE) in spear1310_miphy_init()
166 if (priv->mode == PCIE) in spear1310_miphy_exit()
196 if (priv->mode != SATA && priv->mode != PCIE) { in spear1310_miphy_xlate()
|
| D | Kconfig | 10 Enable this to support the miphy transceiver (for SATA/PCIE/USB3)
|
| /drivers/net/ethernet/huawei/hinic/ |
| D | Kconfig | 7 tristate "Huawei Intelligent PCIE Network Interface Card"
11 This driver supports HiNIC PCIE Ethernet cards.
|
| /drivers/staging/gs_fpgaboot/ |
| D | README | 51 doesn't talk to any of Linux interfaces (such as PCIE).
58 any of linux interfaces (such as PCIE)
|
| /drivers/net/can/sja1000/ |
| D | Kconfig | 25 tristate "Fintek F81601 PCIE to 2 CAN Controller"
28 This driver adds support for Fintek F81601 PCIE to 2 CAN
|
| /drivers/pinctrl/tegra/ |
| D | pinctrl-tegra30.c | 2404 …PINGROUP(pex_l2_rst_n_pcc6, PCIE, HDA, RSVD3, RSVD4, 0x33d8, N, …
2405 …PINGROUP(pex_l2_clkreq_n_pcc7, PCIE, HDA, RSVD3, RSVD4, 0x33dc, N, …
2406 …PINGROUP(pex_l0_prsnt_n_pdd0, PCIE, HDA, RSVD3, RSVD4, 0x33b8, N, …
2407 …PINGROUP(pex_l0_rst_n_pdd1, PCIE, HDA, RSVD3, RSVD4, 0x33bc, N, …
2408 …PINGROUP(pex_l0_clkreq_n_pdd2, PCIE, HDA, RSVD3, RSVD4, 0x33c0, N, …
2409 …PINGROUP(pex_wake_n_pdd3, PCIE, HDA, RSVD3, RSVD4, 0x33c4, N, …
2410 …PINGROUP(pex_l1_prsnt_n_pdd4, PCIE, HDA, RSVD3, RSVD4, 0x33c8, N, …
2411 …PINGROUP(pex_l1_rst_n_pdd5, PCIE, HDA, RSVD3, RSVD4, 0x33cc, N, …
2412 …PINGROUP(pex_l1_clkreq_n_pdd6, PCIE, HDA, RSVD3, RSVD4, 0x33d0, N, …
2413 …PINGROUP(pex_l2_prsnt_n_pdd7, PCIE, HDA, RSVD3, RSVD4, 0x33d4, N, …
|
| D | pinctrl-tegra20.c | 2076 MUX_PG(gpv, PCIE, RSVD2, RSVD3, RSVD4, 0x14, 17, 0x8c, 2, 0xa0, 30),
2135 MUX_PG(slxa, PCIE, SPI4, SDIO3, SPI2, 0x18, 3, 0x84, 6, 0xa4, 22),
2138 MUX_PG(slxk, PCIE, SPI4, SDIO3, SPI2, 0x18, 7, 0x84, 14, 0xa4, 30),
|
| /drivers/net/wireless/marvell/mwifiex/ |
| D | Kconfig | 25 tristate "Marvell WiFi-Ex Driver for PCIE 8766/8897/8997"
|
| /drivers/net/wireless/ath/ath11k/ |
| D | Kconfig | 28 This module adds support for PCIE bus
|
| /drivers/tty/serial/8250/ |
| D | 8250_exar.c | 886 EXAR_DEVICE(COMMTECH, 4222PCIE, pbn_fastcom35x_2),
887 EXAR_DEVICE(COMMTECH, 4224PCIE, pbn_fastcom35x_4),
888 EXAR_DEVICE(COMMTECH, 4228PCIE, pbn_fastcom35x_8),
|
| /drivers/net/wireless/ath/ath10k/ |
| D | Kconfig | 22 This module adds support for PCIE bus
|
| /drivers/phy/ti/ |
| D | Kconfig | 60 additional register to power on USB3 PHY/SATA PHY/PCIE PHY
|
| /drivers/pinctrl/spear/ |
| D | pinctrl-spear1310.c | 226 PCIE##x##_CFG_AUX_CLK_EN | \
227 PCIE##x##_CFG_CORE_CLK_EN | \
228 PCIE##x##_CFG_POWERUP_RESET | \
229 PCIE##x##_CFG_DEVICE_PRESENT)
|
| /drivers/scsi/megaraid/ |
| D | megaraid_sas.h | 944 u8 PCIE:1; member
|
| /drivers/scsi/ |
| D | Kconfig | 1509 This driver supports PMC-Sierra PCIE SAS/SATA 8x6G SPC 8001 chip
|