| /drivers/mtd/lpddr/ |
| D | lpddr_cmds.c | 78 shared[i].writing = shared[i].erasing = NULL; in lpddr_cmdset()
227 contender = shared->writing; in get_chip()
281 shared->writing = chip; in get_chip()
353 if (shared->writing == chip && chip->oldstate == FL_READY) { in put_chip()
355 shared->writing = shared->erasing; in put_chip()
356 if (shared->writing && shared->writing != chip) { in put_chip()
358 struct flchip *loaner = shared->writing; in put_chip()
369 shared->writing = NULL; in put_chip()
370 } else if (shared->erasing == chip && shared->writing != chip) { in put_chip()
|
| /drivers/firmware/google/ |
| D | Kconfig | 17 platforms. This provides an interface for writing to and
19 driver provides an interface for reading and writing NVRAM
|
| /drivers/staging/iio/Documentation/ |
| D | sysfs-bus-iio-dds | 10 can control the desired active tuning word by writing Y to the
41 accumulator output by writing Y to the phase_en file.
|
| /drivers/block/ |
| D | Kconfig | 157 Synchronous operation (i.e. always writing data to the host's disk
184 writing them to floppy. Furthermore, some Linux distributions avoid
312 tristate "Packet writing on CD/DVD media (DEPRECATED)"
320 If you have a CDROM/DVD drive that supports packet writing, say
325 Currently only writing to CD-RW, DVD-RW, DVD+RW and DVDRAM discs
329 See the file <file:Documentation/cdrom/packet-writing.rst>
344 a disc is opened for writing.
|
| /drivers/staging/fbtft/ |
| D | README | 5 The module 'fbtft' makes writing drivers for some of these displays very easy.
|
| /drivers/ata/ |
| D | pata_hpt3x2n.c | 300 static int hpt3x2n_use_dpll(struct ata_port *ap, int writing) in hpt3x2n_use_dpll() argument
305 if (writing) in hpt3x2n_use_dpll()
|
| /drivers/staging/greybus/Documentation/ |
| D | sysfs-bus-greybus | 110 If the value read is "off", then writing "on" (or '1', 'y',
115 If the value read is "on", then writing "off" (or '0', 'n',
259 file will disable the watchdog, writing 1 will enable it.
|
| /drivers/mtd/chips/ |
| D | cfi_cmdset_0001.c | 796 shared[i].writing = shared[i].erasing = NULL; in cfi_intelext_partition_fixup()
973 contender = shared->writing; in get_chip()
1027 shared->writing = chip; in get_chip()
1046 if (shared->writing == chip && chip->oldstate == FL_READY) { in put_chip()
1048 shared->writing = shared->erasing; in put_chip()
1049 if (shared->writing && shared->writing != chip) { in put_chip()
1051 struct flchip *loaner = shared->writing; in put_chip()
1062 shared->writing = NULL; in put_chip()
1063 } else if (shared->erasing == chip && shared->writing != chip) { in put_chip()
|
| D | Kconfig | 50 data bits when writing the 'magic' commands to the chips. Saying
160 This enables support for reading, writing and locking so called
|
| /drivers/thunderbolt/ |
| D | Kconfig | 24 Enables writing to device configuration registers through
|
| /drivers/scsi/ |
| D | st.h | 44 int writing; member
|
| D | scsi_ioctl.c | 416 int writing = 0; in sg_io() local
433 writing = 1; in sg_io()
443 rq = blk_get_request(sdev->request_queue, writing ? in sg_io()
|
| D | st.c | 670 if (!STbuffer->writing) in write_behind_check()
688 STbuffer->buffer_bytes -= STbuffer->writing; in write_behind_check()
694 STps->drv_block += STbuffer->writing / STp->block_size; in write_behind_check()
712 STbuffer->writing = 0; in write_behind_check()
1296 (STp->buffer)->writing = 0; in st_open()
1779 STbp->writing = transfer; in st_write()
1780 STp->dirty = !(STbp->writing == in st_write()
|
| /drivers/s390/char/ |
| D | Kconfig | 176 prompt "API for writing z/VM monitor service records"
179 Character device driver for writing z/VM monitor service records
|
| /drivers/pnp/pnpbios/ |
| D | Kconfig | 34 not be notified of any resource changes made by writing directly.
|
| /drivers/staging/fieldbus/Documentation/ABI/ |
| D | sysfs-class-fieldbus-dev | 37 Note: this area is accessible by writing to the associated
|
| /drivers/acpi/pmic/ |
| D | Kconfig | 8 to control power rails and sensor reading/writing on the
|
| /drivers/block/drbd/ |
| D | Kconfig | 50 The actual simulation of IO errors is done by writing 3 values to
|
| /drivers/media/dvb-frontends/ |
| D | rtl2832.c | 178 u8 msb, lsb, reading[4], writing[4], len; in rtl2832_wr_demod_reg() local
199 writing[i] = (writing_tmp >> ((len - 1 - i) * 8)) & 0xff; in rtl2832_wr_demod_reg()
201 ret = regmap_bulk_write(dev->regmap, reg_start_addr, writing, len); in rtl2832_wr_demod_reg()
|
| /drivers/mmc/core/ |
| D | Kconfig | 77 in host controllers. The tests are executed by writing to the
|
| /drivers/soc/ti/ |
| D | Kconfig | 18 Packets are queued/de-queued by writing/reading descriptor address
|
| /drivers/net/wireless/marvell/mwifiex/ |
| D | README | 8 # is available by writing to the Free Software Foundation, Inc.,
192 2) For writing value to firmware memory location.
|
| /drivers/xen/ |
| D | Kconfig | 37 could be added by writing proper value to
106 For example, by reading and writing the "xenbus" file, guests
|
| /drivers/md/ |
| D | md-bitmap.c | 1005 int writing = 0; in md_bitmap_unplug() local
1018 if (!writing) { in md_bitmap_unplug()
1026 writing = 1; in md_bitmap_unplug()
1029 if (writing) in md_bitmap_unplug()
|
| /drivers/net/wireless/ralink/rt2x00/ |
| D | Kconfig | 261 These debugfs files support both reading and writing of the
|