Home
last modified time | relevance | path

Searched refs:e_warn (Results 1 – 13 of 13) sorted by relevance

/drivers/net/ethernet/intel/ixgbe/
Dixgbe_sriov.c58 e_warn(probe, "SRIOV is not supported with XDP\n"); in __ixgbe_enable_sriov()
955 e_warn(drv, "VF %d attempted to set invalid mac\n", vf); in ixgbe_set_vf_mac_addr()
961 e_warn(drv, in ixgbe_set_vf_mac_addr()
979 e_warn(drv, in ixgbe_set_vf_vlan_msg()
1003 e_warn(drv, in ixgbe_set_vf_macvlan_msg()
1012 e_warn(drv, "VF %d attempted to set invalid mac\n", vf); in ixgbe_set_vf_macvlan_msg()
1030 e_warn(drv, in ixgbe_set_vf_macvlan_msg()
1210 e_warn(drv, in ixgbe_update_vf_xcast_mode()
Dixgbe_fcoe.c158 e_warn(drv, "xid=0x%x out-of-range\n", xid); in ixgbe_fcoe_ddp_setup()
178 e_warn(drv, "No ddp_pool resources allocated\n"); in ixgbe_fcoe_ddp_setup()
184 e_warn(drv, "xid=0x%x no ddp pool for fcoe\n", xid); in ixgbe_fcoe_ddp_setup()
851 e_warn(probe, "Enabling FCoE on PF will disable legacy VFs\n"); in ixgbe_fcoe_enable()
Dixgbe_ptp.c759 e_warn(drv, "clearing RX Timestamp hang\n"); in ixgbe_ptp_rx_hang()
806 e_warn(drv, "clearing Tx timestamp hang\n"); in ixgbe_ptp_tx_hang()
875 e_warn(drv, "clearing Tx Timestamp hang\n"); in ixgbe_ptp_tx_hwtstamp_work()
Dixgbe_common.h202 #define e_warn(msglvl, format, arg...) \ macro
Dixgbe_phy.c1646 …e_warn(drv, "WARNING: Intel (R) Network Connections are quality tested using Intel (R) Ethernet Op… in ixgbe_identify_sfp_module_generic()
1825 …e_warn(drv, "WARNING: Intel (R) Network Connections are quality tested using Intel (R) Ethernet Op… in ixgbe_identify_qsfp_module_generic()
Dixgbe_main.c357 e_warn(hw, "register writes incomplete %08x\n", value); in ixgbe_read_reg()
1069 e_warn(drv, "initiating reset due to tx timeout\n"); in ixgbe_tx_timeout_reset()
5152 e_warn(drv, "Packet Buffer(%i) can not provide enough" in ixgbe_hpbthresh()
6809 e_warn(probe, "Requested MTU size is not supported with XDP\n"); in ixgbe_change_mtu()
6822 e_warn(probe, "Setting MTU > 1500 will disable legacy VFs\n"); in ixgbe_change_mtu()
7689 e_warn(drv, "initiating reset to clear Tx work after link loss\n"); in ixgbe_watchdog_flush_tx()
7773 e_warn(drv, "%u Spoofed packets detected\n", ssvpc); in ixgbe_spoof_check()
9267 e_warn(probe, "DCB is not supported with XDP\n"); in ixgbe_setup_tc()
10095 e_warn(probe, "L2FW offload is not supported with XDP\n"); in ixgbe_fwd_add()
Dixgbe_ipsec.c898 e_warn(drv, "VF %d attempted to add an IPsec SA\n", vf); in ixgbe_ipsec_vf_add_sa()
Dixgbe_ethtool.c3005 e_warn(drv, "enabling UDP RSS: fragmented packets may arrive out of order to the stack above\n"); in ixgbe_set_rss_hash_opt()
/drivers/net/ethernet/intel/e1000/
De1000.h321 #define e_warn(msglvl, format, arg...) \ macro
De1000_main.c2788 e_warn(drv, "checksum_partial proto=%x!\n", in e1000_tx_csum()
/drivers/net/ethernet/intel/e1000e/
De1000.h36 #define e_warn(format, arg...) \ macro
Dnetdev.c1199 e_warn("clearing Tx timestamp hang\n"); in e1000e_tx_hwtstamp_work()
2909 e_warn("Unable to create IPMI pass-through filter\n"); in e1000_init_manageability_pt()
5066 e_warn("Error reading PHY register\n"); in e1000_phy_read_status()
5524 e_warn("checksum_partial proto=%x!\n", in e1000_tx_csum()
6499 e_warn("DPG_EXIT_DONE took %d msec. This is a firmware bug\n", in e1000e_s0ix_exit_flow()
Dich8lan.c305 e_warn("Failed to disable ULP\n"); in e1000_init_phy_workarounds_pchlan()
1284 e_warn("ULP_CONFIG_DONE took %d msec. This is a firmware bug\n", in e1000_disable_ulp_lpt_lp()