Home
last modified time | relevance | path

Searched refs:wl1251_error (Results 1 – 13 of 13) sorted by relevance

/drivers/net/wireless/ti/wl1251/
Dcmd.c44 wl1251_error("command complete timeout"); in wl1251_cmd_send()
95 wl1251_error("TEST command answer error: %d", in wl1251_cmd_test()
124 wl1251_error("INTERROGATE command failed"); in wl1251_cmd_interrogate()
133 wl1251_error("INTERROGATE command error: %d", in wl1251_cmd_interrogate()
196 wl1251_error("VBM command failed"); in wl1251_cmd_vbm()
226 wl1251_error("rx %s cmd for channel %d failed", in wl1251_cmd_data_path_rx()
260 wl1251_error("tx %s cmd for channel %d failed", in wl1251_cmd_data_path_tx()
304 wl1251_error("failed to initiate cmd join"); in wl1251_cmd_join()
333 wl1251_error("cmd set_ps_mode failed"); in wl1251_cmd_ps_mode()
362 wl1251_error("read memory command failed: %d", ret); in wl1251_cmd_read_memory()
[all …]
Dspi.c51 wl1251_error("could not allocate cmd for spi reset"); in wl1251_spi_reset()
78 wl1251_error("could not allocate cmd for spi init"); in wl1251_spi_wake()
236 wl1251_error("no platform data"); in wl1251_spi_probe()
258 wl1251_error("spi_setup failed"); in wl1251_spi_probe()
279 wl1251_error("Failed to request gpio: %d\n", ret); in wl1251_spi_probe()
283 wl1251_error("set power gpio missing in platform data"); in wl1251_spi_probe()
290 wl1251_error("irq missing in platform data"); in wl1251_spi_probe()
299 wl1251_error("request_irq() failed: %d", ret); in wl1251_spi_probe()
308 wl1251_error("vio regulator missing: %d", ret); in wl1251_spi_probe()
Dboot.c42 wl1251_error("soft reset timeout"); in wl1251_boot_soft_reset()
220 wl1251_error("chip id doesn't match after firmware boot"); in wl1251_boot_run_firmware()
231 wl1251_error("error reading hardware complete " in wl1251_boot_run_firmware()
244 wl1251_error("timeout waiting for the hardware to " in wl1251_boot_run_firmware()
293 wl1251_error("EVENT mask setting failed"); in wl1251_boot_run_firmware()
322 wl1251_error("firmware length not multiple of four"); in wl1251_boot_upload_firmware()
328 wl1251_error("allocation for firmware upload chunk failed"); in wl1251_boot_upload_firmware()
525 wl1251_error("boot failed, ECPU_CONTROL_HALT not set"); in wl1251_boot()
Dsdio.c60 wl1251_error("sdio read failed (%d)", ret); in wl1251_sdio_read()
73 wl1251_error("sdio write failed (%d)", ret); in wl1251_sdio_write()
94 wl1251_error("sdio_readb failed (%d)", ret); in wl1251_sdio_read_elp()
108 wl1251_error("sdio_writeb failed (%d)", ret); in wl1251_sdio_write_elp()
245 wl1251_error("request_irq() failed: %d", ret); in wl1251_sdio_probe()
339 wl1251_error("failed to register sdio driver: %d", err); in wl1251_sdio_init()
Dmain.c61 wl1251_error("could not get firmware: %d", ret); in wl1251_fetch_firmware()
66 wl1251_error("firmware size is not multiple of 32 bits: %zu", in wl1251_fetch_firmware()
76 wl1251_error("could not allocate memory for the firmware"); in wl1251_fetch_firmware()
100 wl1251_error("could not get nvs file: %d", ret); in wl1251_fetch_nvs()
105 wl1251_error("nvs size is not multiple of 32 bits: %zu", in wl1251_fetch_nvs()
114 wl1251_error("could not allocate memory for the nvs file"); in wl1251_fetch_nvs()
181 wl1251_error("unsupported chip id: 0x%x", wl->chip_id); in wl1251_chip_wakeup()
379 wl1251_error("cannot start because not in off state: %d", in wl1251_op_start()
730 wl1251_error("Out of memory setting filters."); in wl1251_op_prepare_multicast()
859 wl1251_error("Unknown key cipher 0x%x", mac80211_key->cipher); in wl1251_set_key_type()
[all …]
Dinit.c200 wl1251_error("couldn't allocate target memory map"); in wl1251_hw_init_mem_config()
208 wl1251_error("couldn't retrieve firmware memory map"); in wl1251_hw_init_mem_config()
249 wl1251_error("Invalid TX queue id: %d", qid); in wl1251_hw_init_txq_fill()
Dio.c35 wl1251_error("address out of range (%d)", addr); in wl1251_translate_reg_addr()
128 wl1251_error("can not allocate partition buffer"); in wl1251_set_partition()
Devent.c61 wl1251_error("Power save entry failed, giving up"); in wl1251_event_ps_report()
213 wl1251_error("can not allocate mbox buffer"); in wl1251_event_handle()
Dps.c77 wl1251_error("elp wakeup timeout"); in wl1251_ps_elp_wakeup()
Dacx.c32 wl1251_error("Failed to set FW rates and modulation"); in wl1251_acx_frame_rates()
78 wl1251_error("Couldn't set default key"); in wl1251_acx_default_key()
212 wl1251_error("Couldn't set HW encryption"); in wl1251_acx_feature_cfg()
Dtx.c405 wl1251_error("SKB for packet %d is NULL", result->id); in wl1251_tx_packet_cb()
454 wl1251_error("can not allocate result buffer"); in wl1251_tx_complete()
Drx.c161 wl1251_error("Couldn't allocate RX frame"); in wl1251_rx_body()
Dwl1251.h43 #define wl1251_error(fmt, arg...) \ macro