Home
last modified time | relevance | path

Searched +full:0 +full:x140 (Results 1 – 10 of 10) sorted by relevance

/Documentation/devicetree/bindings/arm/amlogic/
Damlogic,meson-gx-ao-secure.yaml52 reg = <0x140 0x140>;
/Documentation/devicetree/bindings/pinctrl/
Dfsl,imx8m-pinctrl.yaml81 reg = <0x30330000 0x10000>;
85 <0x23C 0x4A4 0x4FC 0x0 0x0 0x140>,
86 <0x240 0x4A8 0x000 0x0 0x0 0x140>;
/Documentation/devicetree/bindings/mfd/
Dbrcm,cru.yaml61 reg = <0x1800c100 0x1d0>;
69 reg = <0x100 0x14>;
77 reg = <0x140 0x24>;
85 reg = <0x164 0x4>;
89 #phy-cells = <0>;
94 reg = <0x180 0x4>;
99 reg = <0x1c0 0x24>;
105 reg = <0x2c0 0x10>;
106 #thermal-sensor-cells = <0>;
/Documentation/devicetree/bindings/regulator/
Danatop-regulator.yaml84 anatop-reg-offset = <0x140>;
87 anatop-delay-reg-offset = <0x170>;
/Documentation/RCU/
Dlockdep-splat.rst30 rcu_scheduler_active = 1, debug_locks = 0
32 #0: (&shost->scan_mutex){+.+.}, at: [<ffffffff8145efca>]
33 scsi_scan_host_selected+0x5a/0x150
35 elevator_exit+0x22/0x60
37 cfq_exit_queue+0x43/0x190
40 Pid: 1552, comm: scsi_scan_6 Not tainted 3.0.0-rc5 #17
42 [<ffffffff810abb9b>] lockdep_rcu_dereference+0xbb/0xc0
43 [<ffffffff812b6139>] __cfq_exit_single_io_context+0xe9/0x120
44 [<ffffffff812b626c>] cfq_exit_queue+0x7c/0x190
45 [<ffffffff812a5046>] elevator_exit+0x36/0x60
[all …]
/Documentation/devicetree/bindings/interrupt-controller/
Dbrcm,bcm7120-l2-intc.yaml36 0 -----[ MUX ] ------------|==========> GIC interrupt 75
136 reg = <0xf0406800 0x8>;
138 interrupts = <0x0 0x42 0x0>, <0x0 0x40 0x0>;
139 brcm,int-map-mask = <0xeb8>, <0x140>;
140 brcm,int-fwd-mask = <0x7>;
146 reg = <0x10000024 0x4>, <0x1000002c 0x4>,
147 <0x10000020 0x4>, <0x10000028 0x4>;
/Documentation/scsi/
Daha152x.rst26 IOPORT base io address (0x340/0x140)
28 SCSI_ID scsi id of controller (0-7; default 7)
29 RECONNECT allow targets to disconnect from the bus (0/1; default 1 [on])
30 PARITY enable parity checking (0/1; default 1 [on])
31 SYNCHRONOUS enable synchronous transfers (0/1; default 1 [on])
33 EXT_TRANS: enable extended translation (0/1: default 0 [off])
/Documentation/admin-guide/
Dpstore-blk.rst59 with no leading 0x, for example b302.
97 */sys/fs/pstore/pmsg-pstore-blk-0*.
108 available in */sys/fs/pstore/console-pstore-blk-0*.
121 combined and available in */sys/fs/pstore/ftrace-pstore-blk-0*.
132 # tail /sys/fs/pstore/ftrace-pstore-blk-0
133 CPU:0 ts:5914676 c0063828 c0063b94 call_cpuidle <- cpu_startup_entry+0x1b8/0x1e0
134 CPU:0 ts:5914678 c039ecdc c006385c cpuidle_enter_state <- call_cpuidle+0x44/0x48
135 CPU:0 ts:5914680 c039e9a0 c039ecf0 cpuidle_enter_freeze <- cpuidle_enter_state+0x304/0x314
136 CPU:0 ts:5914681 c0063870 c039ea30 sched_idle_set_state <- cpuidle_enter_state+0x44/0x314
137 CPU:1 ts:5916720 c0160f59 c015ee04 kernfs_unmap_bin_file <- __kernfs_remove+0x140/0x204
[all …]
/Documentation/usb/
Dusbip_protocol.rst125 | (seqnum = q+1, status = 0) |
136 version in message headers is 0x0111.
149 | 0 | 2 | | USBIP version |
151 | 2 | 2 | 0x8005 | Command code: Retrieve the list of exported USB |
154 | 4 | 4 | 0x00000000 | Status: unused, shall be set to 0 |
163 | 0 | 2 | | USBIP version |
165 | 2 | 2 | 0x0005 | Reply code: The list of exported USB devices. |
167 | 4 | 4 | 0x00000000 | Status: 0 for OK |
169 | 8 | 4 | n | Number of exported devices: 0 means no exported |
172 | 0x0C | | | From now on the exported n devices are described, |
[all …]
/Documentation/trace/
Dhistogram.rst226 field:unsigned short common_type; offset:0; size:2; signed:0;
227 field:unsigned char common_flags; offset:2; size:1; signed:0;
228 field:unsigned char common_preempt_count; offset:3; size:1; signed:0;
231 field:unsigned long call_site; offset:8; size:8; signed:0;
232 field:const void * ptr; offset:16; size:8; signed:0;
233 field:size_t bytes_req; offset:24; size:8; signed:0;
234 field:size_t bytes_alloc; offset:32; size:8; signed:0;
235 field:gfp_t gfp_flags; offset:40; size:4; signed:0;
288 Dropped: 0
305 allowed for the table (normally 0, but if not a hint that you may
[all …]