Searched full:optionally (Results 1 – 25 of 194) sorted by relevance
12345678
| /Documentation/devicetree/bindings/spi/ |
| D | spi-fsl-dspi.txt | 7 "fsl,ls1012a-dspi" (optionally followed by "fsl,ls1021a-v1.0-dspi"),
9 "fsl,ls1043a-dspi" (optionally followed by "fsl,ls1021a-v1.0-dspi"),
10 "fsl,ls1046a-dspi" (optionally followed by "fsl,ls1021a-v1.0-dspi"),
11 "fsl,ls1088a-dspi" (optionally followed by "fsl,ls1021a-v1.0-dspi"),
12 "fsl,ls2080a-dspi" (optionally followed by "fsl,ls2085a-dspi"),
|
| D | spi-orion.txt | 12 This property can optionally have additional entries to configure
43 Example with SPI direct mode support (optionally):
|
| /Documentation/networking/devlink/ |
| D | devlink-region.rst | 15 Regions may optionally support triggering snapshots on demand.
27 Regions may optionally support capturing a snapshot on demand via the
34 Regions may optionally allow directly reading from their contents without a
|
| /Documentation/w1/slaves/ |
| D | w1_ds28e04.rst | 21 during memory accesses can optionally be enabled/disabled via the device
22 attribute "crccheck". The strong pull-up can optionally be enabled/disabled
|
| /Documentation/devicetree/bindings/serial/ |
| D | brcm,bcm7271-uart.yaml | 32 description: The UART register block and optionally the DMA register blocks.
54 description: The UART interrupt and optionally the DMA interrupt.
|
| /Documentation/firmware-guide/acpi/ |
| D | extcon-intel-int3496.rst | 10 USB-otg port, as well as how it optionally can enable Vbus output on the
11 otg port and how it can optionally control the muxing of the data pins
|
| /Documentation/devicetree/bindings/mtd/ |
| D | atmel-dataflash.txt | 6 The device tree may optionally contain sub-nodes describing partitions of the
|
| D | flctl-nand.txt | 17 The device tree may optionally contain sub-nodes describing partitions of the
|
| D | orion-nand.txt | 15 The device tree may optionally contain sub-nodes describing partitions of the
|
| D | samsung-s3c2410.txt | 20 Each child device node may optionally contain a 'partitions' sub-node,
|
| D | hisi504-nand.txt | 24 Flash chip may optionally contain additional sub-nodes describing partitions of
|
| D | nxp-spifi.txt | 24 Optionally it can also contain the following properties.
|
| /Documentation/devicetree/bindings/timer/ |
| D | snps,arc-timer.txt | 3 - Can be optionally programmed to interrupt on Limit
|
| D | faraday,fttmr010.txt | 20 Optionally required properties:
|
| /Documentation/devicetree/bindings/arm/keystone/ |
| D | ti,sci.yaml | 26 This parent node may optionally have additional children nodes which describe
46 Specifies the debug messages memory mapped region that is optionally
|
| /Documentation/devicetree/bindings/gpio/ |
| D | gpio-adnp.txt | 13 The GPIO expander can optionally be used as an interrupt controller, in
|
| /Documentation/devicetree/bindings/crypto/ |
| D | fsl-dcp.yaml | 29 must be supplied, optionally Secure IRQ can be present, but is currently
|
| /Documentation/devicetree/bindings/rtc/ |
| D | brcm,brcmstb-waketimer.yaml | 15 optionally generate RTC alarm interrupts.
|
| /Documentation/devicetree/bindings/clock/ti/ |
| D | divider.txt | 45 unless the divider array is provided, min and max dividers. Optionally
49 This binding can also optionally provide support to the hardware autoidle
|
| /Documentation/devicetree/bindings/power/supply/ |
| D | adc-battery.yaml | 14 via ADC channels and optionally indicate that the battery is full by
|
| /Documentation/filesystems/ext4/ |
| D | verity.rst | 27 with optionally appended signature blob.
|
| /Documentation/devicetree/bindings/mfd/ |
| D | brcm,twd.yaml | 15 registers layout). This block consists of: timers, watchdog and optionally a
|
| /Documentation/userspace-api/media/v4l/ |
| D | vidioc-prepare-buf.rst | 34 Applications can optionally call the :ref:`VIDIOC_PREPARE_BUF` ioctl to
|
| /Documentation/devicetree/bindings/media/cec/ |
| D | cec-gpio.yaml | 14 hooked up to a pull-up GPIO line and - optionally - the HPD line is hooked up
|
| /Documentation/arch/loongarch/ |
| D | booting.rst | 14 to the kernel includes the memmap, the initrd, the command line, optionally
|
12345678