Home
last modified time | relevance | path

Searched full:endpoints (Results 1 – 25 of 95) sorted by relevance

1234

/Documentation/devicetree/bindings/usb/
Dgr-udc.txt21 - epobufsizes : Array of buffer sizes for OUT endpoints when they differ
25 only for as many endpoints as the array contains.
27 - epibufsizes : Array of buffer sizes for IN endpoints when they differ
31 only for as many endpoints as the array contains.
Daspeed,usb-vhub.yaml18 Supported number of devices and endpoints vary depending on hardware
20 and 15 generic endpoints, while AST2600 Virtual Hub supports 7 downstream
21 devices and 21 generic endpoints.
46 aspeed,vhub-generic-endpoints:
47 description: Number of generic endpoints supported by the Virtual Hub
108 - aspeed,vhub-generic-endpoints
121 aspeed,vhub-generic-endpoints = <15>;
Dda8xx-usb.txt24 and "txN" for transmit endpoints. N specifies the endpoint number.
37 channel number (0 … 3 for endpoints 1 … 4).
39 - dma-channels: should be set to 4 representing the 4 endpoints.
Daspeed,ast2600-udc.yaml15 4 generic endpoints for AST260x.
18 Supports 32/256 stages descriptor mode for all generic endpoints.
Dam33xx-usb.txt41 - mentor,num-eps: Specifies the number of endpoints. This is also a
49 and "txN" for transmit endpoints. N specifies the endpoint number.
61 endpoint number (0 … 14 for endpoints 1 … 15 on instance 0 and 15 … 29
62 for endpoints 1 … 15 on instance 1). The second number is 0 for RX and
64 - dma-channels: should be set to 30 representing the 15 endpoints for
/Documentation/devicetree/bindings/dma/
Dstericsson,dma40.yaml38 16: USB OTG in/out endpoints 7 & 15
39 17: USB OTG in/out endpoints 6 & 14
40 18: USB OTG in/out endpoints 5 & 13
41 19: USB OTG in/out endpoints 4 & 12
58 36: USB OTG in/out endpoints 3 & 11
59 37: USB OTG in/out endpoints 2 & 10
60 38: USB OTG in/out endpoints 1 & 9
61 39: USB OTG in/out endpoints 8
/Documentation/usb/
Draw-gadget.rst37 4. Raw Gadget explicitly exposes information about endpoints addresses and
60 Note that some UDC drivers have fixed addresses assigned to endpoints, and
65 endpoints that the UDC driver has. Based on that, userspace must choose UDC
66 endpoints for the gadget and assign addresses in the endpoint descriptors
91 enabling endpoints; allow providing ``stream_id`` for bulk transfers).
Dfunctionfs.rst18 to worry about endpoints, interfaces or strings numbers but
20 only one (endpoints and strings numbers starting from one and
68 closes its endpoints.
/Documentation/driver-api/cxl/
Dmemory-devices.rst25 multiple Host Bridges and endpoints while another may opt for fault tolerance
30 dictates which endpoints can participate in which Host Bridge decode regimes.
40 Ports. Each of those Root Ports are connected to 2-way switches with endpoints
41 connected to those downstream ports for a total of 8 endpoints::
55 "endpoints:port8":[
85 "endpoints:port12":[
121 "endpoints:port6":[
151 "endpoints:port10":[
186 decodes them to "ports", "ports" decode to "endpoints", and "endpoints"
/Documentation/driver-api/
Dinterconnect.rst65 Interconnect endpoints are the first or the last element of the path. Every
68 Interconnect path is everything between two endpoints including all the nodes
91 get paths between endpoints and set their bandwidth/latency/QoS requirements
124 # Configure node endpoints for the path from CPU to DDR on
130 # necessary after updating the node endpoints.
139 # process for different nodes endpoints.
/Documentation/driver-api/usb/
Dbulk-streams.rst41 ID for the bulk IN and OUT endpoints used in a Bi-directional command sequence.
43 The return value is an error condition (if one of the endpoints doesn't support
51 Do NOT call this function if you have URBs enqueued for any of the endpoints
Dgadget.rst20 - Handles devices with dozens of endpoints just as well as ones with
93 driver is often configured at compile time to work with endpoints
97 involved in supporting new hardware, by *autoconfiguring* endpoints
107 enabling and configuring endpoints
113 - managing IN and OUT transfers on all currently enabled endpoints
164 endpoints is now automated, and many drivers now use autoconfiguration
165 to choose hardware endpoints and initialize their descriptors. A
215 detection of capabilities, through naming conventions for endpoints.
218 autoconfiguration logic that scans the hardware's list of endpoints to
266 host issues a ``set_configuration`` call. It enables all endpoints used
[all …]
Dwriting_musb_glue_layer.rst388 - ``MUSB_INTRTX``: indicates which of the interrupts for TX endpoints are
391 - ``MUSB_INTRRX``: indicates which of the interrupts for TX endpoints are
547 endpoints of the controller hardware, including endpoint 0: here we have
548 3 endpoints + endpoint 0. Next is ``ram_bits`` (line 7) which is the width
551 configure endpoints by reading the relevant controller hardware
554 about device quirks: ``fifo_cfg`` points to the USB endpoints configuration
609 for USB endpoints configuration.
612 endpoints configuration from the hardware, so we use line 12 instruction
614 hard-coded table that describes the endpoints configuration instead::
622 Looking at the configuration table above, we see that each endpoints is
/Documentation/devicetree/bindings/display/
Dst,stm32-ltdc.yaml40 ltdc has one video port with up to 2 endpoints:
43 Note: These 2 endpoints cannot be activated simultaneously.
Dallwinner,sun9i-a80-deu.yaml49 Input endpoints of the controller.
54 Output endpoints of the controller.
Dallwinner,sun6i-a31-drc.yaml55 Input endpoints of the controller.
60 Output endpoints of the controller.
Dallwinner,sun8i-a83t-de2-mixer.yaml54 Input endpoints of the controller.
59 Output endpoints of the controller.
Dallwinner,sun4i-a10-display-frontend.yaml66 Input endpoints of the controller.
71 Output endpoints of the controller.
/Documentation/devicetree/bindings/interconnect/
Dinterconnect.txt14 etc. The consumer drivers set constraints on interconnect path (or endpoints)
49 to both endpoints and in such cases, this information will be passed
/Documentation/driver-api/rapidio/
Drapidio.rst27 A typical RapidIO network is a combination of endpoints and switches.
134 that all discovering endpoints are started before the enumerating endpoint
146 endpoints have been successfully booted, an enumeration process shall be
148 completed a discovery process can be started on all remaining endpoints.
209 This configuration requires synchronized start of all RapidIO endpoints that
210 form a network which will be enumerated/discovered. Discovering endpoints have
222 requirement for synchronized start of all endpoints.
278 For both endpoints and switches the enumerator writes a unique component tag
/Documentation/devicetree/bindings/display/bridge/
Dthine,thc63lvd1024.yaml35 port@1, and both port@0 and port@1 shall contain endpoints.
40 port@3 shall contain endpoints.
/Documentation/sound/soc/
Djack.rst14 - Integration with DAPM, allowing DAPM endpoints to be updated
20 snd_soc_jack_pins representing DAPM endpoints to update and blocks of
/Documentation/devicetree/bindings/display/armada/
Dmarvell,dove-lcd.txt7 - port: video output port with endpoints, as described by graph.txt
/Documentation/devicetree/bindings/pci/
Dpci.txt29 GPIO and apply fundamental reset to endpoints.
68 When present, the port is external-facing. All bridges and endpoints
/Documentation/devicetree/bindings/sound/
Datmel-sam9x5-wm8731-audio.txt12 Available audio endpoints for the audio-routing table:

1234