/drivers/gpu/drm/radeon/ |
D | radeon_agp.c | 48 /* Intel E7505 Memory Controller Hub / RV350 AR [Radeon 9600XT] Needs AGPMode 4 (deb #515326) */ 50 /* Intel 82865G/PE/P DRAM Controller/Host-Hub / Mobility 9800 Needs AGPMode 4 (deb #462590) */ 52 …/* Intel 82865G/PE/P DRAM Controller/Host-Hub / RV280 [Radeon 9200 SE] Needs AGPMode 4 (lp #300304… 55 /* Intel 82855PM Processor to I/O Controller / Mobility M6 LY Needs AGPMode 1 (deb #467235) */ 58 /* Intel 82855PM host bridge / Mobility 9600 M10 RV350 Needs AGPMode 1 (lp #195051) */ 61 …/* Intel 82855PM host bridge / RV250/M9 GL [Mobility FireGL 9000/Radeon 9000] needs AGPMode 1 (Thi… 64 /* Intel 82855PM host bridge / Mobility M7 needs AGPMode 1 */ 67 /* Intel 82855PM host bridge / FireGL Mobility T2 RV350 Needs AGPMode 2 (fdo #20647) */ 70 /* Intel 82855PM host bridge / Mobility M9+ / VaioPCG-V505DX Needs AGPMode 2 (fdo #17928) */ 73 /* Intel 82855PM Processor to I/O Controller / Mobility M9+ Needs AGPMode 8 (phoronix forum) */ [all …]
|
/drivers/clk/st/ |
D | clk-flexgen.c | 307 /* This clk needs to be on so that memory interface is accessible */ 336 /* This clk needs to be on to keep bus interconnect alive */ 338 /* This clk needs to be on to keep bus interconnect alive */ 343 /* This clk needs to be on to keep A9 running */ 353 /* This clk needs to be on to keep bus interconnect alive */ 356 /* This clk needs to be on to keep bus interconnect alive */ 381 /* This clk needs to be on to keep bus interconnect alive */ 383 /* This clk needs to be on to keep bus interconnect alive */ 388 /* This clk needs to be on to keep A9 running */ 398 /* This clk needs to be on to keep bus interconnect alive */ [all …]
|
/drivers/vhost/ |
D | Kconfig | 6 This option is selected by any driver which needs to support 13 This option is selected by any driver which needs to access 25 This option is selected by any driver which needs to access 41 module itself which needs to be loaded in guest kernel.
|
/drivers/mmc/host/ |
D | sdhci-bcm-kona.c | 72 * Back-to-Back register write needs a delay of 1ms at bootup (min 10uS) in sdhci_bcm_kona_sd_reset() 73 * Back-to-Back writes to same register needs delay when SD bus clock in sdhci_bcm_kona_sd_reset() 97 * Back-to-Back register write needs a delay of 1ms at bootup (min 10uS) in sdhci_bcm_kona_sd_init() 98 * Back-to-Back writes to same register needs delay when SD bus clock in sdhci_bcm_kona_sd_init() 109 * IP to function properly the bit 0 of CORESTAT register needs to be set/reset 119 * Back-to-Back register write needs a delay of min 10uS. in sdhci_bcm_kona_sd_card_emulate() 120 * Back-to-Back writes to same register needs delay when SD bus clock in sdhci_bcm_kona_sd_card_emulate()
|
/drivers/net/wireless/intel/iwlwifi/mvm/ |
D | sta.h | 28 * even if it also needs to send traffic to a sleeping STA1, without being 45 * When a frame for a previously unseen RA/TID comes in, it needs to be deferred 62 * When a RA/TID needs to become aggregated, no new queue is required to be 95 * paths are triggered by the fw, and the driver needs to get a pointer to the 107 * The station holds the sequence number per tid. So this data needs to be 110 * were drained), so it also needs to be accessible from the Tx response flow. 111 * In short, the station needs to be access from sleepable context as well as 112 * from tasklets, so the station itself needs a spinlock. 127 * The FW needs a few internal stations that are not reflected in 173 * not be zeroed and needs to be reinitialized manually. [all …]
|
/drivers/ufs/host/ |
D | Kconfig | 65 UFS host on QCOM needs some vendor specific configuration before 80 UFS host on Mediatek needs some vendor specific configuration before 102 UFS host on Renesas needs some vendor specific configuration before 139 UFS host on Unisoc needs some vendor specific configuration before
|
/drivers/staging/media/atomisp/ |
D | TODO | 51 picture, the exposure/gain needs to be tuned using v4l2-ctl on the sensor 52 subdev. To fix this, support for the atomisp needs to be added to libcamera. 57 means that at least proof-of-concept libcamera integration needs to be 80 * The atomisp code still has a lot of cruft which needs cleaning up
|
/drivers/gpu/drm/ci/ |
D | test.yml | 29 needs: 44 needs: 59 needs: 77 needs: 337 needs:
|
/drivers/gpu/drm/amd/amdgpu/ |
D | psp_v11_0_8.c | 41 /* there might be handshake issue with hardware which needs delay */ in psp_v11_0_8_ring_stop() 50 /* there might be handshake issue with hardware which needs delay */ in psp_v11_0_8_ring_stop() 86 /* there might be handshake issue with hardware which needs delay */ in psp_v11_0_8_ring_create() 116 /* there might be handshake issue with hardware which needs delay */ in psp_v11_0_8_ring_create()
|
D | psp_v13_0_4.c | 185 /* there might be handshake issue with hardware which needs delay */ in psp_v13_0_4_bootloader_load_sos() 204 /* there might be handshake issue with hardware which needs delay */ in psp_v13_0_4_ring_stop() 213 /* there might be handshake issue with hardware which needs delay */ in psp_v13_0_4_ring_stop() 249 /* there might be handshake issue with hardware which needs delay */ in psp_v13_0_4_ring_create() 279 /* there might be handshake issue with hardware which needs delay */ in psp_v13_0_4_ring_create()
|
D | psp_v12_0.c | 102 /* there might be handshake issue with hardware which needs delay */ in psp_v12_0_bootloader_load_sysdrv() 141 /* there might be handshake issue with hardware which needs delay */ in psp_v12_0_bootloader_load_sos() 203 /* there might be handshake issue with hardware which needs delay */ in psp_v12_0_ring_create() 225 /* there might be handshake issue with hardware which needs delay */ in psp_v12_0_ring_create() 250 /* there might be handshake issue with hardware which needs delay */ in psp_v12_0_ring_stop()
|
D | psp_v3_1.c | 108 /* there might be handshake issue with hardware which needs delay */ in psp_v3_1_bootloader_load_sysdrv() 147 /* there might be handshake issue with hardware which needs delay */ in psp_v3_1_bootloader_load_sos() 216 /* there might be hardware handshake issue which needs delay */ in psp_v3_1_ring_create() 239 /* there might be hardware handshake issue which needs delay */ in psp_v3_1_ring_create() 265 /* there might be handshake issue with hardware which needs delay */ in psp_v3_1_ring_stop()
|
/drivers/net/wireless/intel/ipw2x00/ |
D | libipw_geo.c | 35 /* Driver needs to initialize the geography map before using in libipw_is_valid_channel() 64 /* Driver needs to initialize the geography map before using in libipw_channel_to_index() 86 /* Driver needs to initialize the geography map before using in libipw_channel_to_freq() 101 /* Driver needs to initialize the geography map before using in libipw_freq_to_channel()
|
/drivers/staging/greybus/Documentation/firmware/ |
D | firmware-management | 57 and user first needs to identify the character device used for 157 an Interface. The user needs to fill the 'firmware_tag' and 'load_method' 172 second. The user needs to pass the timeout in milliseconds. 195 gb-authenticate-N and user first needs to identify the character device used for 300 an Interface. The user needs to fill the 'auth_type', 'uid', and 'challenge'
|
/drivers/pci/controller/ |
D | pcie-iproc.h | 67 * @rej_unconfig_pf: indicates the root complex needs to detect and reject 74 * @need_ob_cfg: indicates SW needs to configure the outbound mapping window 78 * @need_ib_cfg: indicates SW needs to configure the inbound mapping window
|
/drivers/staging/media/sunxi/cedrus/ |
D | TODO | 2 * The Request API needs to be stabilized; 5 * Userspace support for the Request API needs to be reviewed;
|
/drivers/net/ethernet/intel/iavf/ |
D | iavf.h | 144 u8 remove:1; /* filter needs to be removed */ 145 u8 add:1; /* filter needs to be added */ 160 IAVF_VLAN_ADD, /* filter needs to be added */ 163 IAVF_VLAN_DISABLE, /* filter needs to be deleted by PF, then marked INACTIVE */ 165 IAVF_VLAN_REMOVE, /* filter needs to be removed from list */ 245 bool del; /* filter needs to be deleted */ 246 bool add; /* filter needs to be added */
|
/drivers/staging/pi433/ |
D | TODO | 3 * Some missing data (marked with ###) needs to be added in the documentation 6 -> This configuration needs to be moved to sysfs instead of being done through
|
/drivers/fpga/ |
D | dfl-afu-dma-region.c | 141 * Needs to be called with pdata->lock heold. 183 * Needs to be called with pdata->lock heold. 201 * Needs to be called with pdata->lock heold. 242 * Needs to be called with pdata->lock held. 282 * Needs to be called with pdata->lock held.
|
/drivers/gpu/drm/amd/display/dc/inc/hw/ |
D | dccg.h | 72 //int dtbclk_khz[MAX_PIPES];/* TODO needs to be removed */ 73 //int audio_dtbclk_khz;/* TODO needs to be removed */ 74 //int ref_dtbclk_khz;/* TODO needs to be removed */
|
/drivers/staging/media/meson/vdec/ |
D | vdec.h | 99 * @start: mandatory call when the vdec needs to initialize 100 * @stop: mandatory call when the vdec needs to stop 116 * @start: mandatory call when the codec needs to initialize 117 * @stop: mandatory call when the codec needs to stop
|
/drivers/platform/x86/ |
D | msi-ec.c | 79 .address = MSI_EC_ADDR_UNKNOWN, // 0xd5 needs testing 405 .rt_temp_address = 0x68, // needs testing 406 .rt_fan_speed_address = 0x71, // needs testing 484 .rt_temp_address = 0x68, // needs testing 485 .rt_fan_speed_address = 0x71, // needs testing 612 .address = 0xbf, // needs testing 644 .rt_fan_speed_address = 0xc9, // needs testing
|
/drivers/net/wireless/intel/iwlwifi/mei/ |
D | iwl-mei.h | 40 * bus. Instead, it needs to cache the requests from iwlwifi and fulfill them 45 * iwlwifi needs to unregister from iwlmei. 51 * Since iwlwifi calls iwlmei without any context, iwlmei needs to hold a 56 * iwlmei needs to cache requests from iwlwifi when there is no mei client 109 * the NVM's content that the host driver needs. 184 * by the user space, CSME needs to get the DHCP request. See 424 * @ivlen: the size of the IV that needs to be skipped after the MAC and
|
/drivers/parisc/ |
D | gsc.h | 39 int gsc_alloc_irq(struct gsc_irq *dev); /* dev needs an irq */ 40 int gsc_claim_irq(struct gsc_irq *dev, int irq); /* dev needs this irq */
|
/drivers/watchdog/ |
D | renesas_wdt.c | 130 /* needs to be atomic - no RPM, no usleep_range, no scheduling! */ 183 .data = (void *)1, /* needs single CPU */ 187 .data = (void *)1, /* needs single CPU */ 190 .data = (void *)0, /* needs SMP disabled */
|