Home
last modified time | relevance | path

Searched +full:rgmii +full:- +full:txid (Results 1 – 11 of 11) sorted by relevance

/Documentation/devicetree/bindings/net/
Dcpsw.txt2 ------------------------------------------------------
5 - compatible : Should be one of the below:-
7 "ti,am335x-cpsw" for AM335x controllers
8 "ti,am4372-cpsw" for AM437x controllers
9 "ti,dra7-cpsw" for DRA7x controllers
10 - reg : physical base address and size of the cpsw
12 - interrupts : property with a value describing the interrupt
14 - cpdma_channels : Specifies number of channels in CPDMA
15 - ale_entries : Specifies No of entries ALE can hold
16 - bd_ram_size : Specifies internal descriptor RAM size
[all …]
Dadi,adin.yaml1 # SPDX-License-Identifier: GPL-2.0+
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Alexandru Tachici <alexandru.tachici@analog.com>
16 - $ref: ethernet-phy.yaml#
19 adi,rx-internal-delay-ps:
21 RGMII RX Clock Delay used only when PHY operates in RGMII mode with
22 internal delay (phy-mode is 'rgmii-id' or 'rgmii-rxid') in pico-seconds.
26 adi,tx-internal-delay-ps:
28 RGMII TX Clock Delay used only when PHY operates in RGMII mode with
[all …]
Dethernet-controller.yaml1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/net/ethernet-controller.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - David S. Miller <davem@davemloft.net>
20 local-mac-address:
23 $ref: /schemas/types.yaml#/definitions/uint8-array
27 mac-address:
32 local-mac-address property.
33 $ref: /schemas/types.yaml#/definitions/uint8-array
[all …]
Damlogic,meson-dwmac.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
4 ---
5 $id: http://devicetree.org/schemas/net/amlogic,meson-dwmac.yaml#
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 - Neil Armstrong <neil.armstrong@linaro.org>
12 - Martin Blumenstingl <martin.blumenstingl@googlemail.com>
20 - amlogic,meson6-dwmac
21 - amlogic,meson8b-dwmac
22 - amlogic,meson8m2-dwmac
23 - amlogic,meson-gxbb-dwmac
[all …]
Dmotorcomm,yt8xxx.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Frank Sae <frank.sae@motor-comm.com>
13 - $ref: ethernet-phy.yaml#
18 - ethernet-phy-id4f51.e91a
19 - ethernet-phy-id4f51.e91b
21 rx-internal-delay-ps:
23 RGMII RX Clock Delay used only when PHY operates in RGMII mode with
24 internal delay (phy-mode is 'rgmii-id' or 'rgmii-rxid') in pico-seconds.
[all …]
/Documentation/ABI/testing/
Dsysfs-class-net-phydev24 This attribute contains the 32-bit PHY Identifier as reported
41 <empty> (not available), mii, gmii, sgmii, tbi, rev-mii,
42 rmii, rgmii, rgmii-id, rgmii-rxid, rgmii-txid, rtbi, smii
43 xgmii, moca, qsgmii, trgmii, 1000base-x, 2500base-x, rxaui,
44 xaui, 10gbase-kr, unknown
60 32-bit hexadecimal number representing a bit mask of the
/Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe/
Ducc.txt4 - device_type : should be "network", "hldc", "uart", "transparent"
6 - compatible : could be "ucc_geth" or "fsl_atm" and so on.
7 - cell-index : the ucc number(1-8), corresponding to UCCx in UM.
8 - reg : Offset and length of the register set for the device
9 - interrupts : <a b> where a is the interrupt number and b is a
14 - pio-handle : The phandle for the Parallel I/O port configuration.
15 - port-number : for UART drivers, the port number to use, between 0 and 3.
18 CPM UART driver, the port-number is required for the QE UART driver.
19 - soft-uart : for UART drivers, if specified this means the QE UART device
20 driver should use "Soft-UART" mode, which is needed on some SOCs that have
[all …]
/Documentation/devicetree/bindings/net/dsa/
Dmicrochip,lan937x.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - UNGLinuxDriver@microchip.com
13 - $ref: dsa.yaml#/$defs/ethernet-ports
18 - microchip,lan9370
19 - microchip,lan9371
20 - microchip,lan9372
21 - microchip,lan9373
22 - microchip,lan9374
[all …]
Dnxp,sja1105.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 The SJA1105 SPI interface requires a CS-to-CLK time (t2 in UM10944.pdf) of at
16 - Vladimir Oltean <vladimir.oltean@nxp.com>
21 - nxp,sja1105e
22 - nxp,sja1105t
23 - nxp,sja1105p
24 - nxp,sja1105q
25 - nxp,sja1105r
[all …]
Dbrcm,b53.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Florian Fainelli <f.fainelli@gmail.com>
18 - const: brcm,bcm5325
19 - const: brcm,bcm53115
20 - const: brcm,bcm53125
21 - const: brcm,bcm53128
22 - const: brcm,bcm53134
23 - const: brcm,bcm5365
[all …]
Dmediatek,mt7530.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Arınç ÜNAL <arinc.unal@arinc9.com>
11 - Landen Chao <Landen.Chao@mediatek.com>
12 - DENG Qingfang <dqfext@gmail.com>
13 - Sean Wang <sean.wang@mediatek.com>
14 - Daniel Golle <daniel@makrotopia.org>
17 There are three versions of MT7530, standalone, in a multi-chip module and
18 built-into a SoC.
[all …]