Home
last modified time | relevance | path

Searched +full:rx +full:- +full:tx +full:- +full:swap (Results 1 – 8 of 8) sorted by relevance

/Documentation/devicetree/bindings/serial/
Dst,stm32-uart.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/serial/st,stm32-uart.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
8 - Erwan Le Ray <erwan.leray@foss.st.com>
15 - st,stm32-uart
16 - st,stm32f7-uart
17 - st,stm32h7-uart
34 st,hw-flow-ctrl:
38 rx-tx-swap: true
[all …]
Dserial.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Rob Herring <robh@kernel.org>
11 - Greg Kroah-Hartman <gregkh@linuxfoundation.org>
19 where N is the port number (non-negative decimal integer) as printed on the
28 cts-gpios:
34 dcd-gpios:
40 dsr-gpios:
46 dtr-gpios:
[all …]
/Documentation/devicetree/bindings/usb/
Dqcom,pmic-typec.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/usb/qcom,pmic-typec.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Qualcomm PMIC based USB Type-C block
10 - Bryan O'Donoghue <bryan.odonoghue@linaro.org>
13 Qualcomm PMIC Type-C block
18 - qcom,pm8150b-typec
22 $ref: /schemas/connector/usb-connector.yaml#
26 description: Type-C port and pdphy SPMI register base offsets
[all …]
/Documentation/devicetree/bindings/net/
Dethernet-phy.yaml1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/net/ethernet-phy.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Andrew Lunn <andrew@lunn.ch>
11 - Florian Fainelli <f.fainelli@gmail.com>
12 - Heiner Kallweit <hkallweit1@gmail.com>
14 # The dt-schema tools will generate a select statement first by using
21 pattern: "^ethernet-phy(@[a-f0-9]+)?$"
24 - $nodename
[all …]
Dkeystone-netcp.txt6 switch sub-module to send and receive packets. NetCP also includes a packet
13 includes a 3-port Ethernet switch sub-module capable of 10Gb/s and 1Gb/s rates
16 Keystone NetCP driver has a plug-in module architecture where each of the NetCP
17 sub-modules exist as a loadable kernel module which plug in to the netcp core.
18 These sub-modules are represented as "netcp-devices" in the dts bindings. It is
19 mandatory to have the ethernet switch sub-module for the ethernet interface to
20 be operational. Any other sub-module like the PA is optional.
24 -----------------------------
26 -----------------------------
28 |-> NetCP Devices -> |
[all …]
/Documentation/devicetree/bindings/mtd/
Dgpmi-nand.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/mtd/gpmi-nand.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Freescale General-Purpose Media Interface (GPMI)
10 - Han Xu <han.xu@nxp.com>
14 flash chips. The device tree may optionally contain sub-nodes
21 - enum:
22 - fsl,imx23-gpmi-nand
23 - fsl,imx28-gpmi-nand
[all …]
/Documentation/networking/
Dpacket_mmap.rst1 .. SPDX-License-Identifier: GPL-2.0
22 - Ulisses Alonso Camaró <uaca@i.hate.spam.alumni.uv.es>
23 - Johann Baudy
67 [setup] socket() -------> creation of the capture socket
68 setsockopt() ---> allocation of the circular buffer (ring)
70 mmap() ---------> mapping of the allocated buffer to the
73 [capture] poll() ---------> to wait for incoming packets
75 [shutdown] close() --------> destruction of the capture socket and
88 supported and a link level pseudo-header is provided
96 allocated RX and TX buffer ring with a single mmap() call.
[all …]
/Documentation/admin-guide/
Dkernel-parameters.txt5 force -- enable ACPI if default was off
6 on -- enable ACPI but allow fallback to DT [arm64,riscv64]
7 off -- disable ACPI if default was on
8 noirq -- do not use ACPI for IRQ routing
9 strict -- Be less tolerant of platforms that are not
11 rsdt -- prefer RSDT over (default) XSDT
12 copy_dsdt -- copy DSDT to memory
26 If set to vendor, prefer vendor-specific driver
58 Documentation/firmware-guide/acpi/debug.rst for more information about
116 Format: <byte> or <bitmap-list>
[all …]