Searched full:shutdown (Results 1 – 25 of 172) sorted by relevance
1234567
| /Documentation/devicetree/bindings/clock/ |
| D | idt,versaclock5.yaml | 33 The idt,shutdown and idt,output-enable-active properties control the
34 SH (en_global_shutdown) and SP bits of the Primary Source and Shutdown
42 1 0 Active/Shutdown
43 1 1 Inactive/Shutdown
83 idt,shutdown:
87 If 1, this enables the shutdown functionality: the chip will be
89 shutdown functionality: the chip will never be shut down based on
91 bit of the Primary Source and Shutdown Register.
101 Shutdown Register.
129 - idt,shutdown
[all …]
|
| /Documentation/devicetree/bindings/sound/ |
| D | maxim,max9759.yaml | 16 shutdown-gpios:
18 description: the gpio connected to the shutdown pin
30 - shutdown-gpios
41 shutdown-gpios = <&gpio3 20 GPIO_ACTIVE_LOW>;
|
| D | adi,ssm2305.txt | 6 - shutdown-gpios : The gpio connected to the shutdown pin.
13 shutdown-gpios = <&gpio3 20 GPIO_ACTIVE_LOW>;
|
| D | tas27xx.yaml | 37 shutdown-gpios:
76 shutdown-gpios = <&gpio1 15 0>;
|
| /Documentation/devicetree/bindings/fpga/ |
| D | xlnx,pr-decoupler.yaml | 7 title: Xilinx LogiCORE Partial Reconfig Decoupler/AXI shutdown manager Softcore
18 Xilinx LogiCORE Dynamic Function eXchange(DFX) AXI shutdown manager Softcore
20 eXchange AXI shutdown manager prevents AXI traffic from passing through the
35 - const: xlnx,dfx-axi-shutdown-manager-1.00
36 - const: xlnx,dfx-axi-shutdown-manager
|
| /Documentation/devicetree/bindings/net/ |
| D | rfkill-gpio.yaml | 32 shutdown-gpios:
38 - shutdown-gpios
50 shutdown-gpios = <&gpio2 25 GPIO_ACTIVE_HIGH>;
|
| D | broadcom-bluetooth.yaml | 32 shutdown-gpios:
124 brcm,requires-autobaud-mode: [ shutdown-gpios ]
153 shutdown-gpios = <&gpio 30 GPIO_ACTIVE_HIGH>;
|
| /Documentation/ABI/testing/ |
| D | sysfs-class-mic | 50 the card was previously shutdown during OSPM
69 "shutdown" Initiates card OS shutdown.
78 OS can shutdown because of various reasons. When read, this
79 entry provides the status on why the card OS was shutdown.
83 "nop" shutdown status is not applicable, when the card OS
85 "crashed" Shutdown because of a HW or SW crash.
86 "halted" Shutdown because of a halt command.
87 "poweroff" Shutdown because of a poweroff command.
88 "restart" Shutdown because of a restart command.
|
| D | sysfs-driver-input-axp-pek | 7 What: /sys/class/input/input(x)/device/shutdown
10 Description: Shutdown time in us. Board is powered off if the button is pressed
|
| D | sysfs-class-chromeos | 27 - "at-shutdown": Reboot after an AP shutdown.
|
| /Documentation/sound/soc/ |
| D | pops-clicks.rst | 23 shutdown and follows some basic rules:-
28 Shutdown Order :- Digital Mute --> Output PGA --> Mixers --> DAC
40 startup or shutdown.
45 Shutdown Order - ADC --> Mixers --> Input PGA
|
| /Documentation/devicetree/bindings/leds/backlight/ |
| D | mediatek,mt6370-backlight.yaml | 57 mediatek,bled-ovp-shutdown:
59 Enable the backlight shutdown when OVP level triggered
67 mediatek,bled-ocp-shutdown:
69 Enable the backlight shutdown when OCP level triggered.
|
| /Documentation/devicetree/bindings/regulator/ |
| D | tps65217.txt | 15 - ti,pmic-shutdown-controller: Telling the PMIC to shutdown on PWR_EN toggle.
26 ti,pmic-shutdown-controller;
|
| /Documentation/hwmon/ |
| D | max31827.rst | 59 the temperature drops below the TH_HYST value or when shutdown mode is entered.
61 or when shutdown mode is entered.
63 Putting the MAX31827 into shutdown mode also resets the OT/UT status bits. Note
75 (default) 140ms. When chip is in shutdown mode and a read operation is
|
| /Documentation/devicetree/bindings/mfd/ |
| D | max77620.txt | 74 power off (shutdown).
91 -maxim,shutdown-fps-time-period-us: u32, FPS time period in microseconds
92 when system enters in to shutdown
148 maxim,shutdown-fps-time-period-us = <1280>;
153 maxim,shutdown-fps-time-period-us = <1280>;
158 maxim,shutdown-fps-time-period-us = <1280>;
|
| /Documentation/devicetree/bindings/power/reset/ |
| D | restart-handler.yaml | 7 title: Restart and shutdown handler Common Properties
13 Restart and shutdown handler device is responsible for powering off the
|
| D | atmel,at91sam9260-shdwc.yaml | 7 title: Microchip AT91 SHDWC Shutdown Controller
13 Microchip AT91 SHDWC shutdown controller controls the power supplies VDDIO
|
| /Documentation/driver-api/md/ |
| D | raid5-ppl.rst | 6 addressed by PPL is that after a dirty shutdown, parity of a particular stripe
11 that have not been touched by a write request during the unclean shutdown can
22 unclean shutdown and all disks are available, eliminating the need to resync
|
| D | raid5-cache.rst | 26 shutdown can cause data in some stripes to not be in consistent state, eg, data
29 unclean shutdown. We call an array degraded if it has inconsistent data. MD
37 shutdown even the array is degraded. Thus the cache can close the 'write hole'.
105 After an unclean shutdown, MD does recovery. MD reads all meta data and data
|
| /Documentation/devicetree/bindings/display/bridge/ |
| D | toshiba,tc358767.yaml | 42 shutdown-gpios:
45 OF device-tree gpio specification for SD pin(active high shutdown input)
130 shutdown-gpios = <&gpio3 23 GPIO_ACTIVE_HIGH>;
167 shutdown-gpios = <&gpio3 23 GPIO_ACTIVE_HIGH>;
|
| /Documentation/admin-guide/nfs/ |
| D | nfsd-admin-interfaces.rst | 28 Between startup and shutdown, the number of threads may be adjusted up
39 removal of listening sockets, and startup and shutdown of the server.
|
| /Documentation/devicetree/bindings/iio/adc/ |
| D | maxim,max1241.yaml | 35 shutdown-gpios:
66 shutdown-gpios = <&gpio 26 1>;
|
| /Documentation/devicetree/bindings/remoteproc/ |
| D | qcom,pas-common.yaml | 35 - description: Shutdown acknowledge interrupt
45 - const: shutdown-ack
|
| /Documentation/devicetree/bindings/hwmon/ |
| D | adi,adm1177.yaml | 33 adi,shutdown-threshold-microamp:
63 adi,shutdown-threshold-microamp = <1059000>; /* 1.059 A */
|
| /Documentation/devicetree/bindings/leds/ |
| D | leds-gpio.yaml | 38 retain-state-shutdown:
40 Retain the state of the LED on shutdown. Useful in BMC systems, for
|
1234567