README_en.md
1# Expansion Boards
2
3## **DRV-LV50A-MP1907** Motor Driver Board
4
5(lab_drv_lv50a_mp1907)=
6
7- Connect J12, J7, J6 to HW, HV, HW
8- Connect VCC of J10 to 3V3
9- Connect the three phases of the motor U, V, W and J4
10- Plug the signal cable of the motor into the J14 socket
11- Connect 24V power supply to J3
12
13:::{note}
14
15 1. **Note the direction of the positive and negative power supply**
16 2. **Never operate with electricity**
17 3. **Apply power to the motor driver board and observe whether the current is abnormal**
18 4. **Make sure the motor driver board is powered down before proceeding to the next step**
19:::
20
21- Connecting the HPM6750EVK and DRV-LV50A-MP1907
22
23 - J8 of the HPM6750EVK is connected to J12 of the DRV-LV50A-MP1907。**Be careful to check the silkscreen, do not insert the reverse**
24 - The figure below shows the overall effect, with red boxes marking the locations of the devices that may need to be operated：
25
26 
27
28## **HPM6750EVKMINI-TO-Motor** Motor Expansion Board
29
30(lab_board_hpm6750evkmini-to-motor-220530RevA)=
31
32 - To be used with[DRV-LV50A-MP1907 Motor Driver Board](lab_drv_lv50a_mp1907)
33 - Connected with j2 and j3 plug-ins
34 - The **HPM6750EVKMINI-TO-Motor** motor expansion board, **HPM6750EVKMINI** board and **DRV-LV50A-MP1907** motor driver board are connected as follows:
35
36 
37
38## **LCD-800480W070TC** Display
39
40 (lab_lcd_800480w070tc)=
41- Seven-inch screen, 480*800 resolution
42- Touch operation support, GT911 5-Point Capacitive Touch Controller
43
README_zh.md
1# 扩展电路板
2
3## **DRV-LV50A-MP1907**电机驱动板
4
5(lab_drv_lv50a_mp1907)=
6
7- 使用跳线端子连接J12、J7、J6到HW、HV、HW
8- 使用跳线端子连接J10的VCC到3V3
9- 将电机的U、V、W三相和J4端子按照正确的线序相连
10- 将电机的信号线插入J14插座
11- 将24V电源接入J3端子
12
13- **NOTE:**
14 1. **请注意电源正负极方向**
15 2. **插接电路板时不要带电操作**
16 3. **单独给电机驱动板上电，观察电流是否异常。如果异常请检查线路连接**
17 4. **进行下一步前，请确保已经给电机驱动板断电**
18
19- 核心板和电机驱动板的连接
20
21 - **HPM6750EVK**核心板和**DRV-LV50A-MP1907**电机驱动板
22
23 - 核心板的J8和电机驱动板的J12相连。**注意对照丝印，不要插反**
24 - 下图是连接完成后的整体效果图，红色方框标出了可能需要操作的器件的位置：
25
26 
27
28## **HPM6750EVKMINI-TO-Motor**电机扩展板
29
30(lab_board_hpm6750evkmini-to-motor-220530RevA)=
31
32 - 需要配合[DRV-LV50A-MP1907电机驱动板](lab_drv_lv50a_mp1907)使用
33 - j2和j3插件相连
34 - **HPM6750EVKMINI-TO-Motor**电机扩展板、**HPM6750EVKMINI**核心板和**DRV-LV50A-MP1907**电机驱动板连接如下图所示：
35
36 
37## **LCD-800480W070TC** 显示屏
38
39 (lab_lcd_800480w070tc)=
40- 七寸显示屏480*800分辨率
41- 支持触摸操作，GT911五点触摸控制器
42
