Searched full:capacitors (Results 1 – 23 of 23) sorted by relevance
| /kernel/linux/linux-5.10/include/linux/platform_data/ |
| D | adp8860.h | 141 * This feature must be used when utilizing small fly capacitors
146 * Additionally, the charge pump fly capacitors should be low ESR
|
| /kernel/linux/linux-6.6/include/linux/platform_data/ |
| D | adp8860.h | 141 * This feature must be used when utilizing small fly capacitors
146 * Additionally, the charge pump fly capacitors should be low ESR
|
| /kernel/linux/linux-6.6/drivers/media/dvb-frontends/ |
| D | lnbh29.h | 14 /* Using very low E.S.R. capacitors or ceramic caps */
|
| /kernel/linux/linux-5.10/drivers/media/dvb-frontends/ |
| D | lnbh29.h | 14 /* Using very low E.S.R. capacitors or ceramic caps */
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/regulator/ |
| D | sprd,sc2731-regulator.txt | 6 ceramic capacitors are recommended to use with these LDOs.
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/regulator/ |
| D | sprd,sc2731-regulator.txt | 6 ceramic capacitors are recommended to use with these LDOs.
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/iio/adc/ |
| D | adi,ad7280a.yaml | 42 Additional time may be needed to charge the sampling capacitors depending
|
| /kernel/linux/linux-5.10/Documentation/userspace-api/media/v4l/ |
| D | ext-ctrls-flash.rst | 182 Is the flash ready to strobe? Xenon flashes require their capacitors
|
| /kernel/linux/linux-6.6/Documentation/userspace-api/media/v4l/ |
| D | ext-ctrls-flash.rst | 185 Is the flash ready to strobe? Xenon flashes require their capacitors
|
| /kernel/linux/linux-6.6/arch/arm/boot/dts/nxp/imx/ |
| D | imx6ull-dhcor-som.dtsi | 29 * Due to the design as a solderable SOM, there are no capacitors
|
| /kernel/linux/linux-6.6/sound/soc/codecs/ |
| D | wm8900.c | 613 * externally to LINEOUT2 via DC blocking capacitors. Other
1043 /* Charge capacitors if initial power up */ in wm8900_set_bias_level()
1058 /* Allow capacitors to charge */ in wm8900_set_bias_level()
|
| /kernel/linux/linux-5.10/sound/soc/codecs/ |
| D | wm8900.c | 613 * externally to LINEOUT2 via DC blocking capacitors. Other
1043 /* Charge capacitors if initial power up */ in wm8900_set_bias_level()
1058 /* Allow capacitors to charge */ in wm8900_set_bias_level()
|
| /kernel/linux/linux-6.6/Documentation/driver-api/nvdimm/ |
| D | btt.rst | 14 using stored energy in capacitors to complete in-flight block writes, or perhaps
|
| /kernel/linux/linux-5.10/Documentation/driver-api/nvdimm/ |
| D | btt.rst | 14 using stored energy in capacitors to complete in-flight block writes, or perhaps
|
| /kernel/linux/linux-5.10/Documentation/input/devices/ |
| D | amijoy.rst | 262 | 00 | START | Start pots (dump capacitors,start counters) |
|
| /kernel/linux/linux-6.6/Documentation/input/devices/ |
| D | amijoy.rst | 262 | 00 | START | Start pots (dump capacitors,start counters) |
|
| /kernel/linux/linux-5.10/drivers/mfd/ |
| D | axp20x.c | 822 /* Give capacitors etc. time to drain to avoid kernel panic msg. */ in axp20x_power_off()
|
| /kernel/linux/linux-6.6/drivers/net/ieee802154/ |
| D | at86rf230.c | 1369 * CX = connected capacitors at xtal pins in at86rf230_hw_init()
|
| /kernel/linux/linux-6.6/drivers/mfd/ |
| D | axp20x.c | 1125 /* Give capacitors etc. time to drain to avoid kernel panic msg. */ in axp20x_power_off()
|
| /kernel/linux/linux-5.10/drivers/net/ieee802154/ |
| D | at86rf230.c | 1439 * CX = connected capacitors at xtal pins in at86rf230_hw_init()
|
| /kernel/linux/linux-6.6/drivers/net/ethernet/aquantia/atlantic/hw_atl/ |
| D | hw_atl_b0.c | 1636 // Reset internal capacitors, biasing, and counters in hw_atl_b0_get_mac_temp()
|
| /kernel/linux/linux-5.10/drivers/net/ethernet/aquantia/atlantic/hw_atl/ |
| D | hw_atl_b0.c | 1636 // Reset internal capacitors, biasing, and counters in hw_atl_b0_get_mac_temp()
|
| /kernel/linux/linux-5.10/sound/pci/ac97/ |
| D | ac97_patch.c | 3902 capacitors */
|