| /kernel/linux/linux-5.10/Documentation/admin-guide/cgroup-v1/ |
| D | blkio-controller.rst | 147 are further divided by the type of operation - read or write, sync
154 are further divided by the type of operation - read or write, sync
167 io_service_time > actual time elapsed. This time is further divided by
183 devices too. This time is further divided by the type of operation -
190 cgroup. This is further divided by the type of operation - read or
195 cgroup. This is further divided by the type of operation - read or
280 are further divided by the type of operation - read or write, sync
287 are further divided by the type of operation - read or write, sync
|
| /kernel/linux/linux-6.6/Documentation/admin-guide/cgroup-v1/ |
| D | blkio-controller.rst | 152 are further divided by the type of operation - read or write, sync
159 are further divided by the type of operation - read or write, sync
172 io_service_time > actual time elapsed. This time is further divided by
188 devices too. This time is further divided by the type of operation -
195 cgroup. This is further divided by the type of operation - read or
200 cgroup. This is further divided by the type of operation - read or
285 are further divided by the type of operation - read or write, sync
292 are further divided by the type of operation - read or write, sync
|
| /kernel/linux/linux-5.10/include/uapi/linux/ |
| D | cramfs_fs.h | 34 /* NAMELEN is the length of the file name, divided by 4 and
37 contains the offset (divided by 4) of the file data in
40 (divided by 4) of the inode of the first file in that
|
| /kernel/linux/linux-6.6/include/uapi/linux/ |
| D | cramfs_fs.h | 34 /* NAMELEN is the length of the file name, divided by 4 and
37 contains the offset (divided by 4) of the file data in
40 (divided by 4) of the inode of the first file in that
|
| /kernel/linux/linux-5.10/drivers/gpu/drm/amd/display/dc/clk_mgr/dcn10/ |
| D | rv1_clk_mgr.c | 51 /* already divided by 2, no need to reach target clk with 2 steps*/ in rv1_determine_dppclk_threshold()
61 /* target dpp clk not request divided by 2, still within threshold */ in rv1_determine_dppclk_threshold()
66 /* decrease clock, looking for current dppclk divided by 2, in rv1_determine_dppclk_threshold()
67 * request dppclk not divided by 2. in rv1_determine_dppclk_threshold()
70 /* current dpp clk not divided by 2, no need to ramp*/ in rv1_determine_dppclk_threshold()
80 /* request dpp clk need to be divided by 2 */ in rv1_determine_dppclk_threshold()
|
| /kernel/linux/linux-6.6/drivers/gpu/drm/amd/display/dc/clk_mgr/dcn10/ |
| D | rv1_clk_mgr.c | 51 /* already divided by 2, no need to reach target clk with 2 steps*/ in rv1_determine_dppclk_threshold()
61 /* target dpp clk not request divided by 2, still within threshold */ in rv1_determine_dppclk_threshold()
66 /* decrease clock, looking for current dppclk divided by 2, in rv1_determine_dppclk_threshold()
67 * request dppclk not divided by 2. in rv1_determine_dppclk_threshold()
70 /* current dpp clk not divided by 2, no need to ramp*/ in rv1_determine_dppclk_threshold()
80 /* request dpp clk need to be divided by 2 */ in rv1_determine_dppclk_threshold()
|
| /kernel/linux/linux-6.6/Documentation/userspace-api/media/drivers/ |
| D | cx2341x-uapi.rst | 18 The Y plane is divided into blocks of 16x16 pixels from left to right
26 The UV plane is divided into blocks of 16x8 UV values going from left
65 // The Y plane is divided into blocks of 16x16 pixels
84 // Again, the UV plane is divided into blocks of 16x16 UV values.
|
| /kernel/linux/linux-5.10/Documentation/userspace-api/media/v4l/ |
| D | ext-ctrls-detect.rst | 37 - The image is divided into a grid, each cell with its own motion
41 - The image is divided into a grid, each cell with its own region
|
| /kernel/linux/linux-6.6/Documentation/userspace-api/media/v4l/ |
| D | ext-ctrls-detect.rst | 37 - The image is divided into a grid, each cell with its own motion
41 - The image is divided into a grid, each cell with its own region
|
| /kernel/linux/linux-5.10/Documentation/userspace-api/media/drivers/ |
| D | cx2341x-uapi.rst | 20 The Y plane is divided into blocks of 16x16 pixels from left to right
28 The UV plane is divided into blocks of 16x8 UV values going from left
67 // The Y plane is divided into blocks of 16x16 pixels
86 // Again, the UV plane is divided into blocks of 16x16 UV values.
|
| /kernel/linux/linux-6.6/arch/arm/boot/dts/arm/ |
| D | integratorcp.dts | 56 /* The chrystal is divided by 2 by the codec for the AACI bit clock */
72 /* The UART clock is 14.74 MHz divided from 25MHz by an ICS525 */
124 /* The KMI clock is the 24 MHz oscillator divided to 8MHz */
133 /* The timer clock is the 24 MHz oscillator divided to 1MHz */
|
| /kernel/linux/linux-5.10/arch/arm/boot/dts/ |
| D | integratorcp.dts | 56 /* The chrystal is divided by 2 by the codec for the AACI bit clock */
72 /* The UART clock is 14.74 MHz divided from 25MHz by an ICS525 */
121 /* The KMI clock is the 24 MHz oscillator divided to 8MHz */
130 /* The timer clock is the 24 MHz oscillator divided to 1MHz */
|
| /kernel/linux/linux-6.6/arch/powerpc/platforms/8xx/ |
| D | m8xx_setup.c | 61 /* The decrementer counts at the system (internal) clock frequency divided by
62 * sixteen, or external oscillator divided by four. We force the processor
63 * to use system clock divided by sixteen.
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/soc/rockchip/ |
| D | grf.txt | 6 From RK3368 SoCs, the GRF is divided into two sections,
13 ON RK3308 SoC, the GRF is divided into four sections:
|
| /kernel/linux/linux-5.10/Documentation/w1/slaves/ |
| D | w1_ds2438.rst | 53 Important: The returned value has to be divided by 256 to get a real
69 Note: To get a volts the value has to be divided by 100.
|
| /kernel/linux/linux-6.6/drivers/powercap/ |
| D | Kconfig | 33 In RAPL, the platform level settings are divided into domains for
48 In RAPL, the platform level settings are divided into domains for
|
| /kernel/linux/linux-6.6/drivers/clk/ingenic/ |
| D | jz4760-cgu.c | 201 /* Divided clocks */
212 /* Those divided clocks can connect to PLL0 or PLL1 */
254 /* Those divided clocks can connect to EXT, PLL0 or PLL1 */
280 /* Those divided clocks can connect to EXT or PLL0 */
294 /* These divided clock can connect to PLL0 only */
|
| /kernel/linux/linux-6.6/tools/perf/pmu-events/arch/x86/silvermont/ |
| D | virtual-memory.json | 23 …-side (walks due to a load) page walk is in progress. Page walk duration divided by number of page…
40 …ue to an instruction fetch) page walk is in progress. Page walk duration divided by number of page…
|
| /kernel/linux/linux-5.10/tools/perf/pmu-events/arch/x86/silvermont/ |
| D | virtual-memory.json | 23 …-side (walks due to a load) page walk is in progress. Page walk duration divided by number of page…
42 …ue to an instruction fetch) page walk is in progress. Page walk duration divided by number of page…
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/sound/ |
| D | nvidia,tegra210-admaif.yaml | 50 DMA channel specifiers, equally divided for Tx and Rx.
66 DMA channel specifiers, equally divided for Tx and Rx.
|
| /kernel/linux/linux-5.10/arch/powerpc/platforms/8xx/ |
| D | m8xx_setup.c | 78 /* The decrementer counts at the system (internal) clock frequency divided by
79 * sixteen, or external oscillator divided by four. We force the processor
80 * to use system clock divided by sixteen.
|
| /kernel/linux/linux-5.10/drivers/clk/mvebu/ |
| D | ap806-system-controller.c | 200 /* MSS Clock is fixed clock divided by 6 */ in ap806_syscon_common_probe()
209 /* SDIO(/eMMC) Clock is fixed clock divided by 3 */ in ap806_syscon_common_probe()
219 /* AP-DCLK(HCLK) Clock is DDR clock divided by 2 */ in ap806_syscon_common_probe()
|
| /kernel/linux/linux-6.6/drivers/clk/mvebu/ |
| D | ap806-system-controller.c | 200 /* MSS Clock is fixed clock divided by 6 */ in ap806_syscon_common_probe()
209 /* SDIO(/eMMC) Clock is fixed clock divided by 3 */ in ap806_syscon_common_probe()
219 /* AP-DCLK(HCLK) Clock is DDR clock divided by 2 */ in ap806_syscon_common_probe()
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/sound/ |
| D | nvidia,tegra210-admaif.yaml | 66 DMA channel specifiers, equally divided for Tx and Rx.
82 DMA channel specifiers, equally divided for Tx and Rx.
|
| /kernel/linux/linux-6.6/Documentation/w1/slaves/ |
| D | w1_ds2438.rst | 70 Important: The returned value has to be divided by 256 to get a real
86 Note: To get a volts the value has to be divided by 100.
|