Lines Matching +full:nand +full:- +full:enable +full:- +full:arbiter

1 # SPDX-License-Identifier: GPL-2.0-only
9 	  This option allows to enable specific memory controller drivers,
34 	bool "Atmel (Multi-port DDR-)SDRAM Controller"
39 	  This driver is for Atmel SDRAM Controller or Atmel Multi-port
40 	  DDR-SDRAM Controller available on Atmel AT91SAM9 and SAMA5 SoCs.
42 	  LP-DDR memories.
53 	  Used to configure the EBI (external bus interface) when the device-
70 	bool "Baikal-T1 CM2 L2-RAM Cache Control Block"
74 	  Baikal-T1 CPU is based on the MIPS P5600 Warrior IP-core. The CPU
75 	  resides Coherency Manager v2 with embedded 1MB L2-cache. It's
77 	  tags and way-select latencies of RAM access. This driver provides a
78 	  dt properties-based and sysfs interface for it.
87 	  is intended to provide a glue-less interface to a variety of
88 	  asynchronuous memory devices like ASRAM, NOR and NAND memory. A total
101 	  functions of the driver includes re-configuring AC timing
113 	  memory drives like NOR, NAND, OneNAND, SRAM.
116 	bool "Enable GPMC debug output and skip reset of GPMC during init"
121 	  of GPMC is skipped during init. Enable this during development to
136 	  the EMIF PM code must run from on-chip SRAM late in the suspend
149 	  devices such as NOR, NAND, SRAM, and FPGA.
171 	  This driver is for the NAND/External Memory Controller (NEMC) in
173 	  memory devices such as NAND and SRAM.
180 	  mainly help enable/disable iommu and control the power domain and
181 	  clocks for each local arbiter.
201 	tristate "Renesas RPC-IF driver"
205 	  This supports Renesas R-Car Gen3 RPC-IF which provides either SPI
214 	  Select this option to enable the STM32 FMC2 External Bus Interface