Lines Matching +full:eee +full:- +full:pcs
21 MLO_AN_FIXED, /* Fixed-link mode */
22 MLO_AN_INBAND, /* In-band protocol */
31 * struct phylink_link_state - link state structure
61 * struct phylink_config - PHYLINK configuration structure
64 * @pcs_poll: MAC PCS cannot provide link change interrupt
80 * struct phylink_mac_ops - MAC operations structure.
113 #if 0 /* For kernel-doc purposes only. */
115 * validate - Validate and update the link configuration
120 * Clear bits in the @supported and @state->advertising masks that
129 * If the @state->interface mode is %PHY_INTERFACE_MODE_1000BASEX
131 * based on @state->advertising and/or @state->speed and update
132 * @state->interface accordingly. See phylink_helper_basex_speed().
134 * When @state->interface is %PHY_INTERFACE_MODE_NA, phylink expects the
137 * If the @state->interface mode is not supported, then the @supported
144 * mac_pcs_get_state() - Read the current inband link state from the hardware
148 * Read the current inband link state from the MAC PCS, reporting the
149 * current speed in @state->speed, duplex mode in @state->duplex, pause
150 * mode in @state->pause using the %MLO_PAUSE_RX and %MLO_PAUSE_TX bits,
151 * negotiation completion state in @state->an_complete, and link up state
152 * in @state->link. If possible, @state->lp_advertising should also be
159 * mac_prepare() - prepare to change the PHY interface mode
171 * - mac_prepare()
172 * - mac_config()
173 * - pcs_config()
174 * - possible pcs_an_restart()
175 * - mac_finish()
184 * mac_config() - configure the MAC for the selected mode and state
189 * Note - not all members of @state are valid. In particular,
190 * @state->lp_advertising, @state->link, @state->an_complete are never
194 * (this requires a rewrite - please refer to mac_link_up() for situations
195 * where the PCS and MAC are not tightly integrated.)
197 * In all negotiation modes, as defined by @mode, @state->pause indicates the
201 * the results of in-band negotiation/status from the MAC PCS should be used
207 * Configure for non-inband negotiation mode, where the link settings
209 * protocol from the MAC is specified by @state->interface.
211 * @state->advertising may be used, but is not required.
213 * Older drivers (prior to the mac_link_up() change) may use @state->speed,
214 * @state->duplex and @state->pause to configure the MAC, but this is
224 * 1000base-X or Cisco SGMII mode depending on the @state->interface
233 * @state->interface. Duplex and pause modes are negotiated via
234 * the in-band configuration word. Advertised pause modes are set
235 * according to the @state->an_enabled and @state->advertising
240 * in the serial bitstream 16-bit configuration word, and the MAC
249 * requested settings - i.o.w., if nothing has changed between two
259 * mac_finish() - finish a to change the PHY interface mode
265 * complete any necessary steps after the MAC and PCS have been configured
266 * for the @mode and @iface. E.g. a MAC driver may wish to re-enable the
276 * mac_an_restart() - restart 802.3z BaseX autonegotiation
282 * mac_link_down() - take the link down
287 * If @mode is not an in-band negotiation mode (as defined by
296 * mac_link_up() - allow the link to come up
310 * where these settings are not automatically conveyed from the PCS block,
311 * or if in-band negotiation (as defined by phylink_autoneg_inband(@mode))
314 * Note that when 802.3z in-band negotiation is in use, it is possible
318 * If in-band negotiation mode is disabled, allow the link to come up. If
319 * @phy is non-%NULL, configure Energy Efficient Ethernet by calling
320 * phy_init_eee() and perform appropriate MAC configuration for EEE.
331 * struct phylink_pcs - PHYLINK PCS instance
333 * @poll: poll the PCS for link changes
335 * This structure is designed to be embedded within the PCS private data,
336 * and will be passed between phylink and the PCS.
344 * struct phylink_pcs_ops - MAC PCS operations structure.
345 * @pcs_get_state: read the current MAC PCS link state from the hardware.
346 * @pcs_config: configure the MAC PCS for the selected mode and state.
348 * @pcs_link_up: program the PCS for the resolved link configuration
352 void (*pcs_get_state)(struct phylink_pcs *pcs,
354 int (*pcs_config)(struct phylink_pcs *pcs, unsigned int mode,
358 void (*pcs_an_restart)(struct phylink_pcs *pcs);
359 void (*pcs_link_up)(struct phylink_pcs *pcs, unsigned int mode,
363 #if 0 /* For kernel-doc purposes only. */
365 * pcs_get_state() - Read the current inband link state from the hardware
366 * @pcs: a pointer to a &struct phylink_pcs.
369 * Read the current inband link state from the MAC PCS, reporting the
370 * current speed in @state->speed, duplex mode in @state->duplex, pause
371 * mode in @state->pause using the %MLO_PAUSE_RX and %MLO_PAUSE_TX bits,
372 * negotiation completion state in @state->an_complete, and link up state
373 * in @state->link. If possible, @state->lp_advertising should also be
379 void pcs_get_state(struct phylink_pcs *pcs,
383 * pcs_config() - Configure the PCS mode and advertisement
384 * @pcs: a pointer to a &struct phylink_pcs.
390 * Configure the PCS for the operating mode, the interface mode, and set
397 * For SGMII, there is no advertisement from the MAC side, the PCS should
400 * For 1000BASE-X, the advertisement should be programmed into the PCS.
402 * For most 10GBASE-R, there is no advertisement.
404 int pcs_config(struct phylink_pcs *pcs, unsigned int mode,
409 * pcs_an_restart() - restart 802.3z BaseX autonegotiation
410 * @pcs: a pointer to a &struct phylink_pcs.
412 * When PCS ops are present, this overrides mac_an_restart() in &struct
415 void pcs_an_restart(struct phylink_pcs *pcs);
418 * pcs_link_up() - program the PCS for the resolved link configuration
419 * @pcs: a pointer to a &struct phylink_pcs.
425 * This call will be made just before mac_link_up() to inform the PCS of
426 * the resolved link parameters. For example, a PCS operating in SGMII
427 * mode without in-band AN needs to be manually configured for the link
428 * and duplex setting. Otherwise, this should be a no-op.
430 void pcs_link_up(struct phylink_pcs *pcs, unsigned int mode,
437 void phylink_set_pcs(struct phylink *, struct phylink_pcs *pcs);
481 void phylink_mii_c22_pcs_get_state(struct mdio_device *pcs,
483 int phylink_mii_c22_pcs_set_advertisement(struct mdio_device *pcs,
486 int phylink_mii_c22_pcs_config(struct mdio_device *pcs, unsigned int mode,
489 void phylink_mii_c22_pcs_an_restart(struct mdio_device *pcs);
491 void phylink_mii_c45_pcs_get_state(struct mdio_device *pcs,