Lines Matching +full:bcm6328 +full:- +full:power +full:- +full:controller
1 # SPDX-License-Identifier: GPL-2.0-only
50 See Documentation/ABI/testing/sysfs-class-led for details.
59 This option enables support for on-chip LED drivers found on Marvell
66 This option enables support for the AN30259A 3-channel
70 will be called leds-an30259a.
80 If you're looking for APU2/3, use the pcengines-apu2 driver.
84 module will be called leds-apu.
93 Controller.
108 will be called leds-aw200xx.
115 This option enables support for the AW2013 3-channel
119 will be called leds-aw2013.
122 tristate "LED Support for Broadcom BCM6328"
127 This option enables support for LEDs connected to the BCM6328
128 LED HW controller accessed via MMIO registers.
137 LED HW controller accessed via MMIO registers.
148 will be called leds-cht-wcove.
170 will be called leds-cr0014114.
183 will be called leds-el15203000.
223 TI LM3533 Lighting Power chips.
226 ambient-light-sensor interface. The chip supports
227 hardware-accelerated blinking with maximum on and off periods of 9.8
236 The LM3642 is a 4MHz fixed-frequency synchronous boost
237 converter plus 1.5A constant current driver for a high-current
254 Zaurus models SL-5500 and SL-5600.
269 This option enables support for on-chip LED drivers found on
332 LED controller. It is generally only useful
366 module will be called leds-lp3944.
379 module will be called leds-lp3952.
390 module will be called leds-lp50xx.
444 It is similar as LP5523, but output power selection is available.
474 The driver supports two kinds of interface: using ledtrig-timer
494 module will be called leds-clevo-mail.
555 This option enables support for on-chip LED drivers found
563 This option enables support for on-chip LED drivers found
564 on Dialog Semiconductor DA9052-BC and DA9053-AA/Bx PMICs.
600 be called leds-bd2606mvv.
618 drive or power LEDs on the front panel. Using this driver
627 LT3593 controller. This controller uses a special one-wire pulse
635 This option enables support for on-chip LED drivers found
639 be called leds-adp5520.
646 This option enables support for on-chip LED drivers found
655 This option enables support for the dual-GPIO LEDs found on the
661 n090401 (Seagate NAS 4-Bay)
680 Driver support brightness control and hardware-assisted blinking.
700 This option enables support for on-chip LED drivers on
725 will be called leds-menf21bmc.
728 tristate "LED Support for ISSI IS31FL319x I2C LED controller family"
737 called leds-is31fl319x.
740 tristate "LED support for ISSI IS31FL32XX I2C LED controller family"
743 Say Y here to include support for ISSI IS31FL32XX and Si-En SN32xx
744 LED controllers. They are I2C devices with multiple constant-current
745 channels, each with independent 256-level PWM control.
748 tristate "LED support for the SC27xx breathing light controller"
752 Say Y here to include support for the SC27xx breathing light controller
756 called leds-sc27xx-bltc.
777 will be called leds-powernv.
812 module, choose 'M' here: the module will be called leds-mlxreg.
831 will be called leds-nic78bx.
834 tristate "LED support for SPI LED controller with a single byte"
839 This option enables support for LED controller which use a single byte
840 for controlling the brightness. Currently the following controller is
841 supported: Ubiquiti airCube ISP microcontroller based LED controller.
886 will be called leds-ip30.
889 tristate "Power button LED support for Acer Iconia Tab A500"
892 This option enables support for the Power Button LED of