Home
last modified time | relevance | path

Searched +full:vcp +full:- +full:supply (Results 1 – 13 of 13) sorted by relevance

/kernel/linux/linux-5.10/Documentation/devicetree/bindings/sound/
Dcs42l56.txt5 - compatible : "cirrus,cs42l56"
7 - reg : the I2C address of the device for I2C
9 - VA-supply, VCP-supply, VLDO-supply : power supplies for the device,
14 - cirrus,gpio-nreset : GPIO controller's phandle and the number
17 - cirrus,chgfreq-divisor : Values used to set the Charge Pump Frequency.
24 - cirrus,ain1a-ref-cfg, ain1b-ref-cfg : boolean, If present, AIN1A or AIN1B are configured
25 as a pseudo-differential input referenced to AIN1REF/AIN3A.
27 - cirrus,ain2a-ref-cfg, ain2b-ref-cfg : boolean, If present, AIN2A or AIN2B are configured
28 as a pseudo-differential input referenced to AIN2REF/AIN3B.
30 - cirrus,micbias-lvl: Set the output voltage level on the MICBIAS Pin.
[all …]
Dcs43130.txt5 - compatible : "cirrus,cs43130", "cirrus,cs4399", "cirrus,cs43131",
8 - reg : the I2C address of the device for I2C
10 - VA-supply, VP-supply, VL-supply, VCP-supply, VD-supply:
17 - reset-gpios : Active low GPIO used to reset the device
19 - cirrus,xtal-ibias:
28 - cirrus,dc-measure:
31 - cirrus,ac-measure:
35 - cirrus,dc-threshold:
39 - cirrus,ac-freq:
41 Only used if "cirrus,dc-measure" is defined.
[all …]
Dcs42l42.txt5 - compatible : "cirrus,cs42l42"
7 - reg : the I2C address of the device for I2C.
9 - VP-supply, VCP-supply, VD_FILT-supply, VL-supply, VA-supply :
15 - reset-gpios : a GPIO spec for the reset pin. If specified, it will be
18 - interrupts : IRQ line info CS42L42.
19 (See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
22 - cirrus,ts-inv : Boolean property. For jacks that invert the tip sense
27 0 = (Default) Non-inverted
30 - cirrus,ts-dbnc-rise : Debounce the rising edge of TIP_SENSE_PLUG. With no
33 0 - 0ms,
[all …]
/kernel/linux/linux-6.6/Documentation/devicetree/bindings/sound/
Dcs42l56.txt5 - compatible : "cirrus,cs42l56"
7 - reg : the I2C address of the device for I2C
9 - VA-supply, VCP-supply, VLDO-supply : power supplies for the device,
14 - cirrus,gpio-nreset : GPIO controller's phandle and the number
17 - cirrus,chgfreq-divisor : Values used to set the Charge Pump Frequency.
24 - cirrus,ain1a-ref-cfg, ain1b-ref-cfg : boolean, If present, AIN1A or AIN1B are configured
25 as a pseudo-differential input referenced to AIN1REF/AIN3A.
27 - cirrus,ain2a-ref-cfg, ain2b-ref-cfg : boolean, If present, AIN2A or AIN2B are configured
28 as a pseudo-differential input referenced to AIN2REF/AIN3B.
30 - cirrus,micbias-lvl: Set the output voltage level on the MICBIAS Pin.
[all …]
Dcs43130.txt5 - compatible : "cirrus,cs43130", "cirrus,cs4399", "cirrus,cs43131",
8 - reg : the I2C address of the device for I2C
10 - VA-supply, VP-supply, VL-supply, VCP-supply, VD-supply:
17 - reset-gpios : Active low GPIO used to reset the device
19 - cirrus,xtal-ibias:
28 - cirrus,dc-measure:
31 - cirrus,ac-measure:
35 - cirrus,dc-threshold:
39 - cirrus,ac-freq:
41 Only used if "cirrus,dc-measure" is defined.
[all …]
Dcirrus,cs42l42.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - patches@opensource.cirrus.com
13 The CS42L42 is a low-power audio codec designed for portable applications.
14 It provides a high-dynamic range, stereo DAC for audio playback and a mono
15 high-dynamic-range ADC for audio capture. There is an integrated headset
21 - cirrus,cs42l42
22 - cirrus,cs42l83
29 VP-supply:
[all …]
/kernel/linux/linux-6.6/drivers/usb/serial/
Dcp210x.c1 // SPDX-License-Identifier: GPL-2.0
6 * Copyright (C) 2010-2021 Johan Hovold (johan@kernel.org)
10 * control thanks to Munir Nassar nassarmu@real-time.com
55 { USB_DEVICE(0x045B, 0x0053) }, /* Renesas RX610 RX-Stick */
56 { USB_DEVICE(0x0471, 0x066A) }, /* AKTAKOM ACE-1001 cable */
57 { USB_DEVICE(0x0489, 0xE000) }, /* Pirelli Broadband S.p.A, DP-L10 SIP/GSM Mobile */
58 { USB_DEVICE(0x0489, 0xE003) }, /* Pirelli Broadband S.p.A, DP-L10 SIP/GSM Mobile */
61 { USB_DEVICE(0x08e6, 0x5501) }, /* Gemalto Prox-PU/CU contactless smartcard reader */
63 { USB_DEVICE(0x0908, 0x0070) }, /* Siemens SCALANCE LPE-9000 USB Serial Console */
67 { USB_DEVICE(0x0BED, 0x1100) }, /* MEI (TM) Cashflow-SC Bill/Voucher Acceptor */
[all …]
Dftdi_sio_ids.h1 /* SPDX-License-Identifier: GPL-2.0 */
6 * Philipp Gühring - pg@futureware.at - added the Device ID of the USB relais
25 #define FTDI_4232H_PID 0x6011 /* Quad channel hi-speed device */
26 #define FTDI_232H_PID 0x6014 /* Single channel hi-speed device */
27 #define FTDI_FTX_PID 0x6015 /* FT-X series (FT201X, FT230X, FT231X, etc) */
28 #define FTDI_FT2233HP_PID 0x6040 /* Dual channel hi-speed device with PD */
29 #define FTDI_FT4233HP_PID 0x6041 /* Quad channel hi-speed device with PD */
30 #define FTDI_FT2232HP_PID 0x6042 /* Dual channel hi-speed device with PD */
31 #define FTDI_FT4232HP_PID 0x6043 /* Quad channel hi-speed device with PD */
32 #define FTDI_FT233HP_PID 0x6044 /* Dual channel hi-speed device with PD */
[all …]
/kernel/linux/linux-5.10/drivers/usb/serial/
Dcp210x.c1 // SPDX-License-Identifier: GPL-2.0
9 * control thanks to Munir Nassar nassarmu@real-time.com
59 { USB_DEVICE(0x045B, 0x0053) }, /* Renesas RX610 RX-Stick */
60 { USB_DEVICE(0x0471, 0x066A) }, /* AKTAKOM ACE-1001 cable */
61 { USB_DEVICE(0x0489, 0xE000) }, /* Pirelli Broadband S.p.A, DP-L10 SIP/GSM Mobile */
62 { USB_DEVICE(0x0489, 0xE003) }, /* Pirelli Broadband S.p.A, DP-L10 SIP/GSM Mobile */
65 { USB_DEVICE(0x08e6, 0x5501) }, /* Gemalto Prox-PU/CU contactless smartcard reader */
67 { USB_DEVICE(0x0908, 0x0070) }, /* Siemens SCALANCE LPE-9000 USB Serial Console */
71 { USB_DEVICE(0x0BED, 0x1100) }, /* MEI (TM) Cashflow-SC Bill/Voucher Acceptor */
76 { USB_DEVICE(0x0FDE, 0xCA05) }, /* OWL Wireless Electricity Monitor CM-160 */
[all …]
Dftdi_sio_ids.h1 /* SPDX-License-Identifier: GPL-2.0 */
6 * Philipp Gühring - pg@futureware.at - added the Device ID of the USB relais
25 #define FTDI_4232H_PID 0x6011 /* Quad channel hi-speed device */
26 #define FTDI_232H_PID 0x6014 /* Single channel hi-speed device */
27 #define FTDI_FTX_PID 0x6015 /* FT-X series (FT201X, FT230X, FT231X, etc) */
32 /*** third-party PIDs (using FTDI_VID) ***/
57 * http://www.open-rd.org
92 #define FTDI_TURTELIZER_PID 0xBDC8 /* JTAG/RS-232 adapter by egnite GmbH */
103 #define FTDI_NZR_SEM_USB_PID 0xC1E0 /* NZR SEM-LOG16+ */
106 * RR-CirKits LocoBuffer USB (http://www.rr-cirkits.com)
[all …]
/kernel/linux/linux-6.6/sound/soc/codecs/
Dcs42l56.c1 // SPDX-License-Identifier: GPL-2.0-only
3 * cs42l56.c -- CS42L56 ALSA SoC audio driver
29 #include <sound/soc-dapm.h>
38 "VCP",
63 { 3, 0x7f }, /* r03 - Power Ctl 1 */
64 { 4, 0xff }, /* r04 - Power Ctl 2 */
65 { 5, 0x00 }, /* ro5 - Clocking Ctl 1 */
66 { 6, 0x0b }, /* r06 - Clocking Ctl 2 */
67 { 7, 0x00 }, /* r07 - Serial Format */
68 { 8, 0x05 }, /* r08 - Class H Ctl */
[all …]
Dcs42l42.c1 // SPDX-License-Identifier: GPL-2.0-only
3 * cs42l42.c -- CS42L42 ALSA SoC audio driver
32 #include <sound/soc-dapm.h>
35 #include <dt-bindings/sound/cs42l42.h>
43 "VCP",
403 static DECLARE_TLV_DB_SCALE(adc_tlv, -9700, 100, true);
404 static DECLARE_TLV_DB_SCALE(mixer_tlv, -6300, 100, true);
413 switch (ucontrol->value.integer.value[0]) { in cs42l42_slow_start_put()
421 return -EINVAL; in cs42l42_slow_start_put()
455 SOC_SINGLE_S8_TLV("ADC Volume", CS42L42_ADC_VOLUME, -97, 12, adc_tlv),
[all …]
/kernel/linux/linux-5.10/sound/soc/codecs/
Dcs42l56.c1 // SPDX-License-Identifier: GPL-2.0-only
3 * cs42l56.c -- CS42L56 ALSA SoC audio driver
29 #include <sound/soc-dapm.h>
38 "VCP",
63 { 3, 0x7f }, /* r03 - Power Ctl 1 */
64 { 4, 0xff }, /* r04 - Power Ctl 2 */
65 { 5, 0x00 }, /* ro5 - Clocking Ctl 1 */
66 { 6, 0x0b }, /* r06 - Clocking Ctl 2 */
67 { 7, 0x00 }, /* r07 - Serial Format */
68 { 8, 0x05 }, /* r08 - Class H Ctl */
[all …]