Searched full:atf (Results 1 – 25 of 57) sorted by relevance
123
| /kernel/linux/linux-5.10/drivers/net/ethernet/marvell/octeontx2/af/ |
| D | cgx_fw_if.h | 116 /* scratchx(0) CSR used for ATF->non-secure SW communication.
182 /* scratchx(1) CSR used for non-secure SW->ATF communication
|
| /kernel/linux/linux-6.6/drivers/net/ethernet/marvell/octeontx2/af/ |
| D | lmac_common.h | 63 /* For ATF to send events to kernel, there is no dedicated interrupt
65 * SW_INT so that ATF triggers this interrupt after processing of
|
| D | cgx_fw_if.h | 163 /* scratchx(0) CSR used for ATF->non-secure SW communication.
236 /* scratchx(1) CSR used for non-secure SW->ATF communication
|
| /kernel/linux/linux-5.10/drivers/soc/amlogic/ |
| D | meson-secure-pwrc.c | 97 /* UART should keep working in ATF after suspend and before resume */
109 /* SRAMB is used as ATF runtime memory, and should be always on */
|
| /kernel/linux/linux-6.6/arch/arm/boot/dts/airoha/ |
| D | en7523-evb.dts | 4 /* Bootloader installs ATF here */
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/watchdog/ |
| D | arm-smc-wdt.yaml | 22 The ATF smc function id used by the firmware.
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/watchdog/ |
| D | arm-smc-wdt.yaml | 23 The ATF smc function id used by the firmware.
|
| /kernel/linux/linux-6.6/drivers/pmdomain/amlogic/ |
| D | meson-secure-pwrc.c | 100 /* UART should keep working in ATF after suspend and before resume */
112 /* SRAMB is used as ATF runtime memory, and should be always on */
|
| /kernel/linux/linux-5.10/include/dt-bindings/clock/ |
| D | rk3399-ddr.h | 53 /* DDR3 ATF default */
|
| /kernel/linux/linux-6.6/include/dt-bindings/clock/ |
| D | rk3399-ddr.h | 53 /* DDR3 ATF default */
|
| /kernel/linux/linux-6.6/drivers/clk/zynqmp/ |
| D | pll.c | 17 * @set_pll_mode: Whether an IOCTL_SET_PLL_FRAC_MODE request be sent to ATF
258 * that has been sent to ATF. in zynqmp_pll_enable()
|
| /kernel/linux/linux-5.10/drivers/clk/zynqmp/ |
| D | pll.c | 17 * @set_pll_mode: Whether an IOCTL_SET_PLL_FRAC_MODE request be sent to ATF
248 * that has been sent to ATF. in zynqmp_pll_enable()
|
| /kernel/linux/linux-5.10/arch/arm/boot/dts/ |
| D | stm32mp157c-odyssey.dts | 35 assigned-clock-rates = <125000000>; /* Clock PLL4 to 750Mhz in ATF/U-Boot */
|
| /kernel/linux/linux-6.6/arch/arm/boot/dts/st/ |
| D | stm32mp157c-odyssey.dts | 41 assigned-clock-rates = <125000000>; /* Clock PLL4 to 750Mhz in ATF/U-Boot */
|
| /kernel/linux/linux-6.6/arch/arm64/boot/dts/xilinx/ |
| D | zynqmp-sm-k26-revA.dts | 172 label = "Image A (FSBL, PMU, ATF, U-Boot)";
182 label = "Image B (FSBL, PMU, ATF, U-Boot)";
|
| /kernel/linux/linux-5.10/drivers/soc/imx/ |
| D | soc-imx8m.c | 69 * the value from ATF instead. in imx8mq_soc_revision()
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/mailbox/ |
| D | xlnx,zynqmp-ipi-mailbox.txt | 12 ATF | |
|
| /kernel/linux/linux-6.6/drivers/soc/imx/ |
| D | soc-imx8m.c | 78 * the value from ATF instead. in imx8mq_soc_revision()
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/firmware/ |
| D | fsl,scu.yaml | 58 execution environments such as ATF.
|
| /kernel/linux/linux-5.10/arch/arm64/boot/dts/ti/ |
| D | k3-j7200-common-proc-board.dts | 86 /* Shared with ATF on this platform */
|
| /kernel/linux/linux-6.6/include/linux/firmware/ |
| D | xlnx-zynqmp.h | 50 /* ATF only commands */
181 /* Register SGI to ATF */
|
| /kernel/linux/linux-5.10/drivers/net/ethernet/broadcom/ |
| D | bgmac-platform.c | 87 /* Some bits of BCMA_IOCTL set by HW/ATF and should not change */ in platform_bgmac_clk_enable()
|
| /kernel/linux/linux-6.6/drivers/net/ethernet/broadcom/ |
| D | bgmac-platform.c | 87 /* Some bits of BCMA_IOCTL set by HW/ATF and should not change */ in platform_bgmac_clk_enable()
|
| /kernel/linux/linux-6.6/drivers/clk/mediatek/ |
| D | clk-mt8195-infra_ao.c | 143 /* pwrmcu is used by ATF for platform PM: clocks must never be disabled by the kernel */
|
| /kernel/linux/linux-6.6/drivers/clocksource/ |
| D | timer-mediatek.c | 265 * or for example ATF will prevent a suspend from completing. in mtk_gpt_suspend()
|
123