Searched full:initiates (Results 1 – 25 of 252) sorted by relevance
1234567891011
26 * Initiates power on and shutdown sequence27 * Initiates suspend and resume power management operations of the device.58 * Initiates data transfer by calling mhi_queue_transfer.
49 Opening and reading this file initiates the CONVERT_T (temperature conversion)58 Opening and reading this file initiates the CONVERT_V (voltage conversion)
20 read sequence of w1_slave file initiates the read of counters and ram
66 Opening and reading this file initiates the CONVERT_T (temperature conversion)75 Opening and reading this file initiates the CONVERT_V (voltage conversion)
156 * this register initiates the transfer. A value of 1 initiates a157 * readback while writing a value of 0 initiates a configuration.
27 Description: Initiates a SoC reset on the MHI controller. A SoC reset is
6 Initiates a FSI master scan for all connected slave devices
26 Initiates the system calibration procedure. This is done on a
68 "reset" Initiates device reset.69 "shutdown" Initiates card OS shutdown.
107 than 128MB. Writing to this value initiates the DMA transfer.251 must be 1. Triggering the monitor dump operation initiates dump of
31 Initiates configuration sequence.
83 * tegra_ivc_reset - initiates a reset of the shared memory state
85 * tegra_ivc_reset - initiates a reset of the shared memory state
150 * Initiates the required SystemPower transition without involving userspace:202 * Initiates the required SystemPower transition, requesting userspace
41 0x1: Direct mode: each DMA request immediately initiates a transfer
34 …truction encounters a fault, trap, or microcode assist of any sort that initiates a flow of uops. …
77 #define WM9712_MASK_SYNC 0x00c0 /* rising/falling edge on mask initiates sample */95 #define WM9705_MASK_SYNC 0x0030 /* rising/falling edge on mask initiates sample */
40 …truction encounters a fault, trap, or microcode assist of any sort that initiates a flow of uops. …