Searched +full:imx +full:- +full:sc +full:- +full:wdt (Results 1 – 13 of 13) sorted by relevance
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/watchdog/ |
| D | fsl,scu-wdt.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 4 $id: http://devicetree.org/schemas/watchdog/fsl,scu-wdt.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 7 title: i.MX SCU Client Device Node - Watchdog Based on SCU Message Protocol 10 - Dong Aisheng <aisheng.dong@nxp.com> 13 Client nodes are maintained as children of the relevant IMX-SCU device node. 16 - $ref: watchdog.yaml# 21 - const: fsl,imx8qxp-sc-wdt 22 - const: fsl,imx-sc-wdt [all …]
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/arm/freescale/ |
| D | fsl,scu.txt | 2 -------------------------------------------------------------------- 4 The System Controller Firmware (SCFW) is a low-level system function 5 which runs on a dedicated Cortex-M core to provide power, clock, and 9 The AP communicates with the SC using a multi-ported MU module found 11 5 remote AP connections to the SC to support up to 5 execution environments 12 (TZ, HV, standard Linux, etc.). The SC side of this MU module interfaces 13 with the LSIO DSC IP bus. The SC firmware will communicate with this MU 22 ------------------- 23 - compatible: should be "fsl,imx-scu". 24 - mbox-names: should include "tx0", "tx1", "tx2", "tx3", [all …]
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/firmware/ |
| D | fsl,scu.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Dong Aisheng <aisheng.dong@nxp.com> 13 The System Controller Firmware (SCFW) is a low-level system function 14 which runs on a dedicated Cortex-M core to provide power, clock, and 17 The AP communicates with the SC using a multi-ported MU module found 19 5 remote AP connections to the SC to support up to 5 execution environments 20 (TZ, HV, standard Linux, etc.). The SC side of this MU module interfaces 21 with the LSIO DSC IP bus. The SC firmware will communicate with this MU [all …]
|
| /kernel/linux/linux-6.6/arch/arm64/boot/dts/freescale/ |
| D | imx8qxp.dtsi | 1 // SPDX-License-Identifier: GPL-2.0+ 4 * Copyright 2017-2020 NXP 8 #include <dt-bindings/clock/imx8-clock.h> 9 #include <dt-bindings/clock/imx8-lpcg.h> 10 #include <dt-bindings/firmware/imx/rsrc.h> 11 #include <dt-bindings/gpio/gpio.h> 12 #include <dt-bindings/input/input.h> 13 #include <dt-bindings/interrupt-controller/arm-gic.h> 14 #include <dt-bindings/pinctrl/pads-imx8qxp.h> 15 #include <dt-bindings/thermal/thermal.h> [all …]
|
| D | imx8dxl.dtsi | 1 // SPDX-License-Identifier: GPL-2.0+ 6 #include <dt-bindings/clock/imx8-clock.h> 7 #include <dt-bindings/firmware/imx/rsrc.h> 8 #include <dt-bindings/gpio/gpio.h> 9 #include <dt-bindings/interrupt-controller/arm-gic.h> 10 #include <dt-bindings/input/input.h> 11 #include <dt-bindings/pinctrl/pads-imx8dxl.h> 12 #include <dt-bindings/thermal/thermal.h> 15 interrupt-parent = <&gic>; 16 #address-cells = <2>; [all …]
|
| /kernel/linux/linux-5.10/drivers/watchdog/ |
| D | imx_sc_wdt.c | 1 // SPDX-License-Identifier: GPL-2.0 3 * Copyright 2018-2019 NXP. 6 #include <linux/arm-smccc.h> 7 #include <linux/firmware/imx/sci.h> 65 return -EACCES; in imx_sc_wdt_start() 70 return res.a0 ? -EACCES : 0; in imx_sc_wdt_start() 80 return res.a0 ? -EACCES : 0; in imx_sc_wdt_stop() 88 wdog->timeout = timeout; in imx_sc_wdt_set_timeout() 92 return res.a0 ? -EACCES : 0; in imx_sc_wdt_set_timeout() 106 (wdog->timeout - pretimeout) * 1000, 0, 0, 0, in imx_sc_wdt_set_pretimeout() [all …]
|
| D | Kconfig | 1 # SPDX-License-Identifier: GPL-2.0-only 16 on-line as fast as possible after a lock-up. There's both a watchdog 21 <file:Documentation/watchdog/watchdog-api.rst> in the kernel source. 51 bool "Update boot-enabled watchdog until userspace takes over" 218 tristate "Watchdog device controlled through GPIO-line" 223 controlled through GPIO-line. 341 module will be called mlx-wdt. 375 More details: ARM DEN0029B - Server Base System Architecture (SBSA) 444 The Intel Footbridge chip contains a built-in watchdog circuit. Say Y 452 "If in doubt, leave it out" - say N. [all …]
|
| /kernel/linux/linux-6.6/drivers/watchdog/ |
| D | imx_sc_wdt.c | 1 // SPDX-License-Identifier: GPL-2.0 3 * Copyright 2018-2019 NXP. 6 #include <linux/arm-smccc.h> 7 #include <linux/firmware/imx/sci.h> 65 return -EACCES; in imx_sc_wdt_start() 70 return res.a0 ? -EACCES : 0; in imx_sc_wdt_start() 80 return res.a0 ? -EACCES : 0; in imx_sc_wdt_stop() 88 wdog->timeout = timeout; in imx_sc_wdt_set_timeout() 92 return res.a0 ? -EACCES : 0; in imx_sc_wdt_set_timeout() 106 (wdog->timeout - pretimeout) * 1000, 0, 0, 0, in imx_sc_wdt_set_pretimeout() [all …]
|
| D | Kconfig | 1 # SPDX-License-Identifier: GPL-2.0-only 16 on-line as fast as possible after a lock-up. There's both a watchdog 21 <file:Documentation/watchdog/watchdog-api.rst> in the kernel source. 51 bool "Update boot-enabled watchdog until userspace takes over" 77 bool "Enable watchdog hrtimer-based pretimeouts" 228 tristate "Watchdog device controlled through GPIO-line" 233 controlled through GPIO-line. 358 module will be called mlx-wdt. 392 More details: ARM DEN0029B - Server Base System Architecture (SBSA) 461 The Intel Footbridge chip contains a built-in watchdog circuit. Say Y [all …]
|
| /kernel/linux/linux-5.10/arch/arm64/boot/dts/freescale/ |
| D | imx8qxp.dtsi | 1 // SPDX-License-Identifier: GPL-2.0+ 4 * Copyright 2017-2018 NXP 8 #include <dt-bindings/clock/imx8-clock.h> 9 #include <dt-bindings/firmware/imx/rsrc.h> 10 #include <dt-bindings/gpio/gpio.h> 11 #include <dt-bindings/input/input.h> 12 #include <dt-bindings/interrupt-controller/arm-gic.h> 13 #include <dt-bindings/pinctrl/pads-imx8qxp.h> 14 #include <dt-bindings/thermal/thermal.h> 17 interrupt-parent = <&gic>; [all …]
|
| /kernel/linux/patches/linux-5.10/imx8mm_patch/patches/ |
| D | 0001_linux_arch.patch | 7 Change-Id: I8c7b42f8858212fb4b2d56a871d3f4d5afc73954 9 diff --git a/arch/arm64/Kconfig b/arch/arm64/Kconfig 11 --- a/arch/arm64/Kconfig 13 @@ -183,7 +183,6 @@ config ARM64 17 - select HOLES_IN_ZONE 21 @@ -1023,6 +1022,9 @@ config NEED_PER_CPU_EMBED_FIRST_CHUNK 31 @@ -1148,7 +1150,7 @@ config XEN 35 - int 40 @@ -1182,15 +1184,6 @@ config UNMAP_KERNEL_AT_EL0 44 -config MITIGATE_SPECTRE_BRANCH_HISTORY [all …]
|
| /kernel/linux/linux-6.6/ |
| D | MAINTAINERS | 5 --------------------------------------------------- 21 W: *Web-page* with status/info 23 B: URI for where to file *bugs*. A web-page with detailed bug 28 patches to the given subsystem. This is either an in-tree file, 29 or a URI. See Documentation/maintainer/maintainer-entry-profile.rst 46 N: [^a-z]tegra all files whose path contains tegra 64 ---------------- 83 3WARE SAS/SATA-RAID SCSI DRIVERS (3W-XXXX, 3W-9XXX, 3W-SAS) 85 L: linux-scsi@vger.kernel.org 88 F: drivers/scsi/3w-* [all …]
|
| /kernel/linux/linux-5.10/ |
| D | MAINTAINERS | 9 ------------------------- 30 ``diff -u`` to make the patch easy to merge. Be prepared to get your 40 See Documentation/process/coding-style.rst for guidance here. 46 See Documentation/process/submitting-patches.rst for details. 57 include a Signed-off-by: line. The current version of this 59 Documentation/process/submitting-patches.rst. 70 that the bug would present a short-term risk to other users if it 76 Documentation/admin-guide/security-bugs.rst for details. 81 --------------------------------------------------- 97 W: *Web-page* with status/info [all …]
|