| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/gpio/ |
| D | gpio-mm-lantiq.txt | 3 By attaching hardware latches to the EBU it is possible to create output
5 written to outputs 16 bit to the latches.
|
| D | netxbig-gpio-ext.txt | 8 - enable-gpio: latches the new configuration (address, data) on raising edge.
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/gpio/ |
| D | gpio-mm-lantiq.txt | 3 By attaching hardware latches to the EBU it is possible to create output
5 written to outputs 16 bit to the latches.
|
| D | gpio-latch.yaml | 13 This binding describes a GPIO multiplexer based on latches connected to
43 of number of latches and the number of inputs per latch is derived from
|
| D | netxbig-gpio-ext.txt | 8 - enable-gpio: latches the new configuration (address, data) on raising edge.
|
| /kernel/linux/linux-5.10/drivers/gpio/ |
| D | gpio-mm-lantiq.c | 21 * By attaching hardware latches to the EBU it is possible to create output
23 * written to outputs 16 bit to the latches.
31 u16 shadow; /* shadow the latches state */
|
| /kernel/linux/linux-6.6/drivers/gpio/ |
| D | gpio-mm-lantiq.c | 21 * By attaching hardware latches to the EBU it is possible to create output
23 * written to outputs 16 bit to the latches.
31 u16 shadow; /* shadow the latches state */
|
| D | gpio-latch.c | 8 * multiplexer based on latches like this:
36 * The above is just an example. The actual number of number of latches and
|
| /kernel/linux/linux-5.10/sound/isa/gus/ |
| D | gus_main.c | 23 static int snd_gus_init_dma_irq(struct snd_gus_card * gus, int latches);
256 static int snd_gus_init_dma_irq(struct snd_gus_card * gus, int latches) in snd_gus_init_dma_irq() argument
314 if (latches) { in snd_gus_init_dma_irq()
325 if (latches) { in snd_gus_init_dma_irq()
333 if (latches) in snd_gus_init_dma_irq()
334 gus->mix_cntrl_reg |= 0x08; /* enable latches */ in snd_gus_init_dma_irq()
336 gus->mix_cntrl_reg &= ~0x08; /* disable latches */ in snd_gus_init_dma_irq()
|
| /kernel/linux/linux-6.6/sound/isa/gus/ |
| D | gus_main.c | 23 static int snd_gus_init_dma_irq(struct snd_gus_card * gus, int latches);
259 static int snd_gus_init_dma_irq(struct snd_gus_card * gus, int latches) in snd_gus_init_dma_irq() argument
317 if (latches) { in snd_gus_init_dma_irq()
328 if (latches) { in snd_gus_init_dma_irq()
336 if (latches) in snd_gus_init_dma_irq()
337 gus->mix_cntrl_reg |= 0x08; /* enable latches */ in snd_gus_init_dma_irq()
339 gus->mix_cntrl_reg &= ~0x08; /* disable latches */ in snd_gus_init_dma_irq()
|
| /kernel/linux/linux-5.10/drivers/staging/comedi/drivers/ |
| D | amplc_dio200_pci.c | 133 * 9. "Pattern occurred" latched signal, latches HIGH when pattern
135 * 10. "Pattern gone away" latched signal, latches LOW when pattern
139 * 12. Negated "pattern occurred" latched signal, latches LOW when
141 * 13. Negated "pattern gone away" latched signal, latches LOW when
192 * register, a rising edge on the source signal latches the corresponding
|
| /kernel/linux/linux-6.6/drivers/comedi/drivers/ |
| D | amplc_dio200_pci.c | 133 * 9. "Pattern occurred" latched signal, latches HIGH when pattern
135 * 10. "Pattern gone away" latched signal, latches LOW when pattern
139 * 12. Negated "pattern occurred" latched signal, latches LOW when
141 * 13. Negated "pattern gone away" latched signal, latches LOW when
192 * register, a rising edge on the source signal latches the corresponding
|
| /kernel/linux/linux-5.10/arch/arm/mach-omap2/ |
| D | prm3xxx.c | 394 * omap3_prm_reconfigure_io_chain - clear latches and reconfigure I/O chain
425 * omap3xxx_prm_enable_io_wakeup - enable wakeup events from I/O wakeup latches
427 * Activates the I/O wakeup event latches and allows events logged by
428 * those latches to signal a wakeup event to the PRCM. For I/O
|
| D | prm44xx.c | 297 * omap44xx_prm_reconfigure_io_chain - clear latches and reconfigure I/O chain
344 * omap44xx_prm_enable_io_wakeup - enable wakeup events from I/O wakeup latches
346 * Activates the I/O wakeup event latches and allows events logged by
347 * those latches to signal a wakeup event to the PRCM. For I/O wakeups
|
| /kernel/linux/linux-6.6/arch/arm/mach-omap2/ |
| D | prm3xxx.c | 395 * omap3_prm_reconfigure_io_chain - clear latches and reconfigure I/O chain
426 * omap3xxx_prm_enable_io_wakeup - enable wakeup events from I/O wakeup latches
428 * Activates the I/O wakeup event latches and allows events logged by
429 * those latches to signal a wakeup event to the PRCM. For I/O
|
| D | prm44xx.c | 297 * omap44xx_prm_reconfigure_io_chain - clear latches and reconfigure I/O chain
344 * omap44xx_prm_enable_io_wakeup - enable wakeup events from I/O wakeup latches
346 * Activates the I/O wakeup event latches and allows events logged by
347 * those latches to signal a wakeup event to the PRCM. For I/O wakeups
|
| /kernel/linux/linux-5.10/arch/mips/generic/ |
| D | board-ranchu.c | 24 * Reading the low address latches the high value in read_rtc_time()
|
| /kernel/linux/linux-6.6/arch/mips/generic/ |
| D | board-ranchu.c | 24 * Reading the low address latches the high value in read_rtc_time()
|
| /kernel/linux/linux-5.10/arch/arm/mach-pxa/ |
| D | pcm990-baseboard.c | 85 /* enable LCD-Latches in pcm990_lcd_power()
91 /* disable LCD-Latches in pcm990_lcd_power()
|
| /kernel/linux/linux-5.10/drivers/gpu/drm/msm/disp/mdp4/ |
| D | mdp4_dsi_encoder.c | 107 * before the disable latches, which results that some of in mdp4_dsi_encoder_disable()
|
| D | mdp4_dtv_encoder.c | 111 * before the disable latches, which results that some of in mdp4_dtv_encoder_disable()
|
| /kernel/linux/linux-6.6/arch/m68k/include/asm/ |
| D | mac_via.h | 203 #define vT1LL 0x0c00 /* [VIA only] Timer one latches low. */
204 #define vT1LH 0x0e00 /* [VIA only] Timer one latches high. */
|
| /kernel/linux/linux-5.10/arch/m68k/include/asm/ |
| D | mac_via.h | 203 #define vT1LL 0x0c00 /* [VIA only] Timer one latches low. */
204 #define vT1LH 0x0e00 /* [VIA only] Timer one latches high. */
|
| /kernel/linux/linux-6.6/drivers/gpu/drm/msm/disp/mdp4/ |
| D | mdp4_dsi_encoder.c | 109 * before the disable latches, which results that some of in mdp4_dsi_encoder_disable()
|
| D | mdp4_dtv_encoder.c | 111 * before the disable latches, which results that some of in mdp4_dtv_encoder_disable()
|