Searched full:shut (Results 1 – 25 of 1293) sorted by relevance
12345678910>>...52
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/power/reset/ |
| D | ltc2952-poweroff.txt | 3 This chip is used to externally trigger a system shut down. Once the trigger has
4 been sent, the chip's watchdog has to be reset to gracefully shut down.
21 assertion before executing shut down procedure.
|
| /kernel/linux/linux-5.10/Documentation/ABI/stable/ |
| D | sysfs-driver-firmware-zynqmp | 71 shut down. This may result in the FPD power
72 domain being shut down provided that no other
75 The complete PS will be shut down, including the
79 The complete system/device is shut down.
|
| /kernel/linux/linux-5.10/drivers/power/reset/ |
| D | ltc2952-poweroff.c | 13 * Its function is to determine when a external shut down is triggered
24 * A level change indicates the shut-down trigger. If it's state reverts
25 * within the time-out defined by trigger_delay, the shut down is not
31 * Once a shut down is triggered, the driver will toggle this signal,
32 * with an internal (wde_interval) to stall the hardware shut down.
35 * The last action during shut down is triggering this signalling, such
131 * time-out (timer_trigger). Once the time-out is actually reached the shut
|
| D | at91-poweroff.c | 23 #define AT91_SHDW_CR 0x00 /* Shut Down Control Register */
24 #define AT91_SHDW_SHDW BIT(0) /* Shut Down command */
27 #define AT91_SHDW_MR 0x04 /* Shut Down Mode Register */
35 #define AT91_SHDW_SR 0x08 /* Shut Down Status Register */
|
| D | at91-sama5d2_shdwc.c | 34 #define AT91_SHDW_CR 0x00 /* Shut Down Control Register */
35 #define AT91_SHDW_SHDW BIT(0) /* Shut Down command */
38 #define AT91_SHDW_MR 0x04 /* Shut Down Mode Register */
44 #define AT91_SHDW_SR 0x08 /* Shut Down Status Register */
|
| /kernel/linux/linux-6.6/drivers/power/reset/ |
| D | ltc2952-poweroff.c | 13 * Its function is to determine when a external shut down is triggered
24 * A level change indicates the shut-down trigger. If it's state reverts
25 * within the time-out defined by trigger_delay, the shut down is not
31 * Once a shut down is triggered, the driver will toggle this signal,
32 * with an internal (wde_interval) to stall the hardware shut down.
35 * The last action during shut down is triggering this signalling, such
131 * time-out (timer_trigger). Once the time-out is actually reached the shut
|
| D | at91-poweroff.c | 23 #define AT91_SHDW_CR 0x00 /* Shut Down Control Register */
24 #define AT91_SHDW_SHDW BIT(0) /* Shut Down command */
27 #define AT91_SHDW_MR 0x04 /* Shut Down Mode Register */
35 #define AT91_SHDW_SR 0x08 /* Shut Down Status Register */
|
| D | at91-sama5d2_shdwc.c | 34 #define AT91_SHDW_CR 0x00 /* Shut Down Control Register */
35 #define AT91_SHDW_SHDW BIT(0) /* Shut Down command */
38 #define AT91_SHDW_MR 0x04 /* Shut Down Mode Register */
44 #define AT91_SHDW_SR 0x08 /* Shut Down Status Register */
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/power/reset/ |
| D | ltc2952-poweroff.txt | 3 This chip is used to externally trigger a system shut down. Once the trigger has
4 been sent, the chip's watchdog has to be reset to gracefully shut down.
|
| /kernel/linux/linux-5.10/arch/arm/mach-u300/ |
| D | regulator.c | 34 * This function is used from pm.h to shut down the system by
44 /* Disable LDO D to shut down the system */ in u300_pm_poweroff()
48 pr_err("regulator not available to shut down system\n"); in u300_pm_poweroff()
|
| /kernel/linux/linux-5.10/Documentation/hwmon/ |
| D | tmp108.rst | 35 the TMP108 has a one-shot mode where the device is normally shut-down. When a
37 and then the device is shut down automatically. (This driver only supports
|
| /kernel/linux/linux-6.6/Documentation/hwmon/ |
| D | tmp108.rst | 35 the TMP108 has a one-shot mode where the device is normally shut-down. When a
37 and then the device is shut down automatically. (This driver only supports
|
| /kernel/linux/linux-5.10/drivers/accessibility/speakup/ |
| D | DefaultKeyAssignments | 36 KeyPad-Enter Shut Up (until another key is hit) and sync reading cursor
37 InsKeyPad-Enter Shut Up (until toggled back on).
|
| /kernel/linux/linux-6.6/drivers/accessibility/speakup/ |
| D | DefaultKeyAssignments | 36 KeyPad-Enter Shut Up (until another key is hit) and sync reading cursor
37 InsKeyPad-Enter Shut Up (until toggled back on).
|
| /kernel/linux/linux-6.6/Documentation/ABI/stable/ |
| D | sysfs-driver-firmware-zynqmp | 71 shut down. This may result in the FPD power
72 domain being shut down provided that no other
75 The complete PS will be shut down, including the
79 The complete system/device is shut down.
|
| /kernel/linux/linux-6.6/drivers/platform/surface/aggregator/ |
| D | ssh_packet_layer.h | 28 * Indicates that the packet transport layer has been shut down or is
29 * being shut down and should not accept any new packets/data.
174 * transport layer has been shut down, calls to this function will be ignored.
|
| D | ssh_request_layer.h | 26 * Indicates that the request transport layer has been shut down or is
27 * being shut down and should not accept any new requests.
|
| /kernel/linux/linux-6.6/tools/arch/arm64/include/asm/ |
| D | barrier.h | 58 /* Only to shut up gcc ... */ \
91 /* Only to shut up gcc ... */ \
|
| /kernel/linux/linux-5.10/tools/arch/arm64/include/asm/ |
| D | barrier.h | 58 /* Only to shut up gcc ... */ \
91 /* Only to shut up gcc ... */ \
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/clock/ |
| D | idt,versaclock5.yaml | 88 shut down if the SD/OE pin is driven high. If 0, this disables the
89 shutdown functionality: the chip will never be shut down based on
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/sound/ |
| D | ti,tas6424.txt | 9 - standby-gpios: GPIO used to shut the TAS6424 down.
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/sound/ |
| D | ti,tas6424.txt | 9 - standby-gpios: GPIO used to shut the TAS6424 down.
|
| D | realtek,rt1015p.yaml | 23 0 means shut down; 1 means power on.
|
| /kernel/linux/linux-5.10/arch/arm/mach-pxa/include/mach/ |
| D | regs-ac97.h | 34 #define GCR_ACLINK_OFF (1 << 3) /* AC-link Shut Off */
67 #define GSR_ACOFFD (1 << 3) /* AC-link Shut Off Done */
|
| /kernel/linux/linux-6.6/sound/arm/ |
| D | pxa2xx-ac97-regs.h | 32 #define GCR_ACLINK_OFF (1 << 3) /* AC-link Shut Off */
65 #define GSR_ACOFFD (1 << 3) /* AC-link Shut Off Done */
|
12345678910>>...52