Lines Matching +full:boot +full:- +full:nand

3 Contact:	linux-scsi@vger.kernel.org
5 		This file contains the auto-hibernate idle timer setting of a
6 		UFS host controller. A value of '0' means auto-hibernate is not
11 		10-bit values with a power-of-ten multiplier which allows a
82 		enabled for boot. This is one of the UFS device descriptor
94 		of the boot sequence. This is one of the UFS device descriptor
273 		written during the pre-soldering phase of the PSA flow.
307 Description:	This file shows the MIPI M-PHY version number in BCD format.
395 Description:	This file shows the maximum data-in buffer size. This
406 Description:	This file shows the maximum data-out buffer size. This
439 Description:	This file shows support for out-of-order data transfer.
507 		enhanced type 1-4). This is one of the UFS geometry
519 		enhanced type 1-4). This is one of the UFS geometry
624 Description:	This file shows boot LUN information. This is one of
827 Description:	This file provides the boot lun enabled UFS device attribute.
927 		read-write persistent attribute and is equal to two after device
978 		load to all logical units in pre-soldering state.
1281 Description:	This entry shows if preserve user-space was configured
1306 Description:	This entry shows the total user-space decrease in shared
1308 		The value of this parameter is 3 for TLC NAND when SLC mode
1309 		is used as WriteBooster Buffer. 2 for MLC NAND.
1444 		01h  0% - 10% WriteBooster Buffer life time used
1446 		0Ah  90% - 100% WriteBooster Buffer life time used
1465 		enable it. The WriteBooster is enabled after power-on/reset,
1474 Contact:	Jinyoung Choi <j-young.choi@samsung.com>
1496 		host-device pair. i.e. the capabilities which are enabled in the
1541 		Symbol - VER.  This file shows the UFSHCD version.
1550 		Symbol - HCPID.  This file shows the UFSHCD product id.
1559 		Symbol - HCMID. This file shows the UFSHCD manufacturer id.
1560 		The Manufacturer ID is defined by JEDEC in JEDEC-JEP106.