Lines Matching +full:entry +full:- +full:latency
3 Contact: linux-scsi@vger.kernel.org
5 This file contains the auto-hibernate idle timer setting of a
6 UFS host controller. A value of '0' means auto-hibernate is not
10 expense of increased latency. Note that the hardware supports
11 10-bit values with a power-of-ten multiplier which allows a
147 latency. This is one of the UFS device descriptor parameters.
273 written during the pre-soldering phase of the PSA flow.
307 Description: This file shows the MIPI M-PHY version number in BCD format.
395 Description: This file shows the maximum data-in buffer size. This
406 Description: This file shows the maximum data-out buffer size. This
439 Description: This file shows support for out-of-order data transfer.
507 enhanced type 1-4). This is one of the UFS geometry
519 enhanced type 1-4). This is one of the UFS geometry
927 read-write persistent attribute and is equal to two after device
978 load to all logical units in pre-soldering state.
1000 Description: This entry could be used to set or show the UFS device
1027 Description: This entry shows the target power mode of an UFS device
1036 Description: This entry shows the target state of an UFS UIC link
1045 Description: This entry could be used to set or show the UFS device
1072 Description: This entry shows the target power mode of an UFS device
1081 Description: This entry shows the target state of an UFS UIC link
1133 Description: This file shows the maximum latency (in micro seconds) of
1142 Description: This file shows the minimum latency (in micro seconds) of
1151 Description: This file shows the average latency (in micro seconds) of
1160 Description: This file shows the total latency (in micro seconds) of
1196 Description: This file shows the maximum latency (in micro seconds) of write
1205 Description: This file shows the minimum latency (in micro seconds) of write
1214 Description: This file shows the average latency (in micro seconds) of write
1223 Description: This file shows the total latency (in micro seconds) of write
1281 Description: This entry shows if preserve user-space was configured
1289 Description: This entry shows the shared allocated units of WB buffer
1297 Description: This entry shows the configured WB type.
1306 Description: This entry shows the total user-space decrease in shared
1317 Description: This entry shows the Maximum total WriteBooster Buffer size
1326 Description: This entry shows the maximum number of luns that can support
1365 Description: This entry shows the status of WriteBooster.
1378 Description: This entry shows if flush is enabled.
1406 Description: This entry shows the amount of unused WriteBooster buffer
1415 Description: This entry shows the amount of unused current buffer.
1423 Description: This entry shows the flush operation status.
1440 Description: This entry shows an indication of the WriteBooster Buffer
1444 01h 0% - 10% WriteBooster Buffer life time used
1446 0Ah 90% - 100% WriteBooster Buffer life time used
1454 Description: This entry shows the configured size of WriteBooster buffer.
1465 enable it. The WriteBooster is enabled after power-on/reset,
1474 Contact: Jinyoung Choi <j-young.choi@samsung.com>
1475 Description: This entry shows the status of WriteBooster buffer flushing
1496 host-device pair. i.e. the capabilities which are enabled in the
1541 Symbol - VER. This file shows the UFSHCD version.
1550 Symbol - HCPID. This file shows the UFSHCD product id.
1559 Symbol - HCMID. This file shows the UFSHCD manufacturer id.
1560 The Manufacturer ID is defined by JEDEC in JEDEC-JEP106.