Lines Matching +full:i +full:- +full:cache +full:- +full:sets

19 Example: If your kernel is called linux-2.6.9, type the following line
22  linux-2.6.9 floppy=thinkpad
25 of linux-2.6.9::
31  linux-2.6.9 floppy=daring floppy=two_fdc
62 	Sets the bit mask to allow only units 0 and 1. (default)
96 	and is thus harder to find, whereas non-dma buffers may be
97 	allocated in virtual memory. However, I advise against this if
100 	If you use nodma mode, I suggest you also set the FIFO
104 	If you have a FIFO-able FDC, the floppy driver automatically
105 	falls back on non DMA mode if no DMA-able memory can be found.
121 	Sets the FIFO threshold. This is mostly relevant in DMA
123 	interrupt latency, but it triggers more interrupts (i.e. it
130 	using 'floppycontrol --messages'. Then access a floppy
131 	disk. If you get a huge amount of "Over/Underrun - retrying"
137 	that you need to do 'floppycontrol --messages' every time you
138 	re-insert the module.
144 	Sets the CMOS type of <drive> to <type>. This is mandatory if
147 	non-standard CMOS types. The CMOS types are:
180 	floppy operation less efficient due to unneeded cache
199 	Sets the floppy IRQ to <nr> instead of 6.
202 	Sets the floppy DMA channel to <nr> instead of 2.
231  ftp://metalab.unc.edu/pub/Linux/utils/disk-management/
250 10-30-2004 :
254 6-3-2000 :