Lines Matching +full:1 +full:gbps

85   # ip link set dev eth0 vf 1 trust [on|off]
156   192.168.10.2 src-port 2000 dst-port 2001 action 2 [loc 1]
161   192.168.10.2 action 2 [loc 1]
199   <queue> - the queue to direct traffic towards (-1 discards matching traffic)
281 Note that 0 is the PF, so the VF identifier is offset by 1. For example::
285 specifies to direct traffic to Virtual Function 7 (8 minus 1) into queue 2 of
364 f Hash on bytes 0 and 1 of the Layer 4 header of the Rx packet.
379 duplex mode. Your link partner must match the setting you choose. 1 Gbps speeds
381 manually set devices for 1 Gbps and higher.
451   f	Hash on bytes 0 and 1 of the Layer 4 header of the Rx packet.
514 1 to ((100 minus # of partitions on the physical port) plus 1)
516 1 to ((100 - 4) + 1 = 97)
520 speed. The accepted range of values is 1-100. The value is used as a limiter,
596 1. Disable XPS on both ends by using the included virt_perf_default script
607 the default setting of 1.
664 1. Create traffic classes (TCs). Maximum of 8 TCs can be created per interface.
668 to 1Gbit for tc0 and 3Gbit for tc1.
672   # tc qdisc add dev <interface> root mqprio num_tc 2 map 0 0 0 0 1 1 1 1
673   queues 16@0 16@16 hw 1 mode channel shaper bw_rlimit min_rate 1Gbit 2Gbit
674   max_rate 1Gbit 3Gbit
676 map: priority mapping for up to 16 priorities to tcs (e.g. map 0 0 0 0 1 1 1 1
683 hw 1 mode channel: ‘channel’ with ‘hw’ set to 1 is a new new hardware
690 For example: min_rate 1Gbit 3Gbit: Verify bandwidth limit using network
731 NOTE: 1 Gb devices based on the Intel(R) Ethernet Network Connection X722 do