Searched +full:0 +full:x04000000 (Results 1 – 15 of 15) sorted by relevance
| /Documentation/devicetree/bindings/memory-controllers/ |
| D | st,stm32-fmc2-ebi.yaml | 51 <bank-number> 0 <address of the bank> <size> 58 "^.*@[0-4],[a-f0-9]+$": 82 reg = <0x58002000 0x1000>; 86 ranges = <0 0 0x60000000 0x04000000>, /* EBI CS 1 */ 87 <1 0 0x64000000 0x04000000>, /* EBI CS 2 */ 88 <2 0 0x68000000 0x04000000>, /* EBI CS 3 */ 89 <3 0 0x6c000000 0x04000000>, /* EBI CS 4 */ 90 <4 0 0x80000000 0x10000000>; /* NAND */ 92 psram@0,0 { 94 reg = <0 0x00000000 0x100000>; [all …]
|
| D | exynos-srom.yaml | 35 <bank-number> 0 <parent address of bank> <size> 39 "^.*@[0-3],[a-f0-9]+$": 53 typically 0 as this is the start of the bank. 77 Tacp: Page mode access cycle at Page mode (0 - 15) 78 Tcah: Address holding time after CSn (0 - 15) 79 Tcoh: Chip selection hold on OEn (0 - 15) 80 Tacc: Access cycle (0 - 31, the actual time is N + 1) 81 Tcos: Chip selection set-up before OEn (0 - 15) 82 Tacs: Address set-up before CSn (0 - 15) 99 reg = <0x12560000 0x14>; [all …]
|
| /Documentation/devicetree/bindings/mtd/ |
| D | mtd-physmap.yaml | 154 reg = <0xff000000 0x01000000>; 160 ranges = <0 0xff000000 0x01000000>; 162 fs@0 { 164 reg = <0 0xf80000>; 168 reg = <0xf80000 0x80000>; 176 flash@0 { 178 reg = <0x00000000 0x02000000>, 179 <0x02000000 0x02000000>; 184 ranges = <0 0 0x04000000>; 186 partition@0 { [all …]
|
| D | ti,am654-hbmc.yaml | 31 "^flash@[0-1],[0-9a-f]+$": 54 reg = <0x0 0x47034000 0x0 0x100>, 55 <0x5 0x00000000 0x1 0x0000000>; 56 ranges = <0x0 0x0 0x5 0x00000000 0x4000000>, /* CS0 - 64MB */ 57 <0x1 0x0 0x5 0x04000000 0x4000000>; /* CS1 - 64MB */ 58 clocks = <&k3_clks 102 0>; 62 mux-controls = <&hbmc_mux 0>; 64 flash@0,0 { 66 reg = <0x0 0x0 0x4000000>;
|
| /Documentation/devicetree/bindings/pci/ |
| D | intel,ixp4xx-pci.yaml | 54 - const: 0xf800 55 - const: 0 56 - const: 0 73 reg = <0xc0000000 0x1000>; 77 bus-range = <0x00 0xff>; 80 <0x02000000 0 0x48000000 0x48000000 0 0x04000000>, 81 <0x01000000 0 0x00000000 0x4c000000 0 0x00010000>; 83 <0x02000000 0 0x00000000 0x00000000 0 0x04000000>; 86 interrupt-map-mask = <0xf800 0 0 7>; 88 <0x0800 0 0 1 &gpio0 11 3>, /* INT A on slot 1 is irq 11 */ [all …]
|
| D | brcm,iproc-pcie.yaml | 117 reg = <0x18012000 0x1000>; 120 interrupt-map-mask = <0 0 0 0>; 121 interrupt-map = <0 0 0 0 &gic GIC_SPI 100 IRQ_TYPE_NONE>; 123 linux,pci-domain = <0>; 125 bus-range = <0x00 0xff>; 130 ranges = <0x81000000 0 0 0x28000000 0 0x00010000>, 131 <0x82000000 0 0x20000000 0x20000000 0 0x04000000>; 133 phys = <&phy 0 5>; 137 brcm,pcie-ob-axi-offset = <0x00000000>; 155 reg = <0x18013000 0x1000>; [all …]
|
| D | faraday,ftpci100.yaml | 18 The host controller appear on the PCI bus with vendor ID 0x159b (Faraday 19 Technology) and product ID 0x4321. 34 interrupt-map-mask = <0xf800 0 0 7>; 36 <0x4800 0 0 1 &pci_intc 0>, /* Slot 9 */ 37 <0x4800 0 0 2 &pci_intc 1>, 38 <0x4800 0 0 3 &pci_intc 2>, 39 <0x4800 0 0 4 &pci_intc 3>, 40 <0x5000 0 0 1 &pci_intc 1>, /* Slot 10 */ 41 <0x5000 0 0 2 &pci_intc 2>, 42 <0x5000 0 0 3 &pci_intc 3>, [all …]
|
| D | intel-gw-pcie.yaml | 96 reg = <0xd0e00000 0x1000>, 97 <0xd2000000 0x800000>, 98 <0xd0a41000 0x1000>; 100 linux,pci-domain = <0>; 102 bus-range = <0x00 0x08>; 104 interrupt-map-mask = <0 0 0 0x7>; 105 interrupt-map = <0 0 0 1 &ioapic1 27 1>, 106 <0 0 0 2 &ioapic1 28 1>, 107 <0 0 0 3 &ioapic1 29 1>, 108 <0 0 0 4 &ioapic1 30 1>; [all …]
|
| D | microchip,pcie-host.yaml | 41 0-3 45 pattern: '^fic[0-3]$' 64 reg = <0x0 0x70000000 0x0 0x08000000>, 65 <0x0 0x43000000 0x0 0x00010000>; 72 interrupt-map-mask = <0x0 0x0 0x0 0x7>; 73 interrupt-map = <0 0 0 1 &pcie_intc0 0>, 74 <0 0 0 2 &pcie_intc0 1>, 75 <0 0 0 3 &pcie_intc0 2>, 76 <0 0 0 4 &pcie_intc0 3>; 80 bus-range = <0x00 0x7f>; [all …]
|
| D | brcm,stb-pcie.yaml | 190 reg = <0x0 0x7d500000 0x9310>; 198 interrupt-map-mask = <0x0 0x0 0x0 0x7>; 199 interrupt-map = <0 0 0 1 &gicv2 GIC_SPI 143 IRQ_TYPE_LEVEL_HIGH 200 0 0 0 2 &gicv2 GIC_SPI 144 IRQ_TYPE_LEVEL_HIGH 201 0 0 0 3 &gicv2 GIC_SPI 145 IRQ_TYPE_LEVEL_HIGH 202 0 0 0 4 &gicv2 GIC_SPI 146 IRQ_TYPE_LEVEL_HIGH>; 206 ranges = <0x02000000 0x0 0xf8000000 0x6 0x00000000 0x0 0x04000000>; 207 dma-ranges = <0x42000000 0x1 0x00000000 0x0 0x40000000 0x0 0x80000000>, 208 <0x42000000 0x1 0x80000000 0x3 0x00000000 0x0 0x80000000>; 210 brcm,scb-sizes = <0x0000000080000000 0x0000000080000000>; [all …]
|
| /Documentation/firmware-guide/acpi/ |
| D | debug.rst | 40 ACPI_UTILITIES 0x00000001 41 ACPI_HARDWARE 0x00000002 42 ACPI_EVENTS 0x00000004 43 ACPI_TABLES 0x00000008 44 ACPI_NAMESPACE 0x00000010 45 ACPI_PARSER 0x00000020 46 ACPI_DISPATCHER 0x00000040 47 ACPI_EXECUTER 0x00000080 48 ACPI_RESOURCES 0x00000100 49 ACPI_CA_DEBUGGER 0x00000200 [all …]
|
| /Documentation/userspace-api/media/v4l/ |
| D | vidioc-enuminput.rst | 46 :header-rows: 0 47 :stub-columns: 0 66 corresponds to audio input 0, the MSB to input 31. Any number of 109 :header-rows: 0 110 :stub-columns: 0 131 :header-rows: 0 132 :stub-columns: 0 136 - 0x00000001 139 - 0x00000002 142 - 0x00000004 [all …]
|
| D | vidioc-querycap.rst | 48 :header-rows: 0 49 :stub-columns: 0 101 ``__u32 version = KERNEL_VERSION(4, 14, 0);`` 105 ``(version >> 16) & 0xFF, (version >> 8) & 0xFF, version & 0xFF);`` 142 :header-rows: 0 143 :stub-columns: 0 147 - 0x00000001 151 - 0x00001000 155 - 0x00000002 159 - 0x00002000 [all …]
|
| /Documentation/devicetree/bindings/display/tegra/ |
| D | nvidia,tegra20-host1x.yaml | 175 use. Should be a mapping of IDs 0..n to IOMMU entries corresponding to 211 - description: host1x syncpoint interrupt 0 235 use. Should be a mapping of IDs 0..n to IOMMU entries corresponding to 251 reg = <0x50000000 0x00024000>; 252 interrupts = <0 65 0x04>, /* mpcore syncpt */ 253 <0 67 0x04>; /* mpcore general */ 263 ranges = <0x54000000 0x54000000 0x04000000>; 267 reg = <0x54040000 0x00040000>; 268 interrupts = <0 68 0x04>; 276 reg = <0x54080000 0x00040000>; [all …]
|
| /Documentation/filesystems/ext4/ |
| D | inodes.rst | 24 is no inode 0. 40 * - 0x0 44 * - 0x2 48 * - 0x4 52 * - 0x8 58 * - 0xC 65 * - 0x10 72 * - 0x14 76 * - 0x18 80 * - 0x1A [all …]
|