Searched +full:0 +full:x29 (Results 1 – 25 of 34) sorted by relevance
12
| /Documentation/hwmon/ |
| D | lm90.rst | 10 Addresses scanned: I2C 0x18 - 0x1a, 0x29 - 0x2b, 0x4c - 0x4e
18 Addresses scanned: I2C 0x4c
28 Addresses scanned: I2C 0x4c and 0x4d
38 Addresses scanned: I2C 0x4c and 0x4d
48 Addresses scanned: I2C 0x4c
58 Addresses scanned: I2C 0x4c - 0x4e
66 Addresses scanned: I2C 0x18 - 0x1a, 0x29 - 0x2b, 0x4c - 0x4e
74 Addresses scanned: I2C 0x18 - 0x1a, 0x29 - 0x2b, 0x4c - 0x4e
82 Addresses scanned: I2C 0x4c and 0x4d
92 Addresses scanned: I2C 0x4c and 0x4d
[all …]
|
| D | lm95245.rst | 8 Addresses scanned: I2C 0x18, 0x29, 0x4c
16 Addresses scanned: I2C 0x18, 0x19, 0x29, 0x4c, 0x4d
|
| D | emc1403.rst | 8 Addresses scanned: I2C 0x18, 0x1c, 0x29, 0x4c, 0x4d, 0x5c
19 Addresses scanned: I2C 0x18, 0x29, 0x4c, 0x4d
30 Addresses scanned: I2C 0x4c
40 Addresses scanned: I2C 0x4c
50 Addresses scanned: I2C 0x18, 0x4c, 0x4d
|
| D | max1619.rst | 10 Addresses scanned: I2C 0x18-0x1a, 0x29-0x2b, 0x4c-0x4e
|
| D | lm83.rst | 10 Addresses scanned: I2C 0x18 - 0x1a, 0x29 - 0x2b, 0x4c - 0x4e
18 Addresses scanned: I2C 0x18 - 0x1a, 0x29 - 0x2b, 0x4c - 0x4e
86 is given within a range of 0 to +85 degrees. Remote temperatures are
87 given within a range of 0 to +125 degrees. Resolution is 1.0 degree,
|
| D | smsc47b397.rst | 40 pair is located at the HWM Base Address + 0 and the HWM Base Address + 1. The
41 HWM Base address can be obtained from Logical Device 8, registers 0x60 (MSB)
42 and 0x61 (LSB). Currently we are using 0x480 for the HWM Base Address and
43 0x480 and 0x481 for the index/data pair.
49 Temp1 0x25 (Currently, this reflects the CPU temp on all systems).
50 Temp2 0x26
51 Temp3 0x27
52 Temp4 0x80
67 Ex: If AL contains 0x2A, the temperature is 42 degrees C.
74 Tach1 0x28 0x29 (Currently, this reflects the CPU
[all …]
|
| D | max1668.rst | 10 Addresses scanned: I2C 0x18, 0x19, 0x1a, 0x29, 0x2a, 0x2b, 0x4c, 0x4d, 0x4e
|
| /Documentation/devicetree/bindings/iio/light/ |
| D | tsl2583.yaml | 41 #size-cells = <0>;
45 reg = <0x29>;
|
| D | amstaos,tsl2563.yaml | 42 #size-cells = <0>;
46 reg = <0x29>;
|
| D | st,vl6180.yaml | 38 #size-cells = <0>;
42 reg = <0x29>;
|
| D | amstaos,tsl2591.yaml | 42 #size-cells = <0>;
46 reg = <0x29>;
|
| /Documentation/devicetree/bindings/iio/proximity/ |
| D | st,vl53l0x.yaml | 38 #size-cells = <0>;
42 reg = <0x29>;
|
| /Documentation/devicetree/bindings/iio/pressure/ |
| D | asc,dlhl60d.yaml | 44 #size-cells = <0>;
48 reg = <0x29>;
|
| /Documentation/devicetree/bindings/net/nfc/ |
| D | nxp,nci.yaml | 49 #size-cells = <0>;
54 reg = <0x29>;
|
| /Documentation/RCU/ |
| D | lockdep-splat.rst | 30 rcu_scheduler_active = 1, debug_locks = 0
32 #0: (&shost->scan_mutex){+.+.}, at: [<ffffffff8145efca>]
33 scsi_scan_host_selected+0x5a/0x150
35 elevator_exit+0x22/0x60
37 cfq_exit_queue+0x43/0x190
40 Pid: 1552, comm: scsi_scan_6 Not tainted 3.0.0-rc5 #17
42 [<ffffffff810abb9b>] lockdep_rcu_dereference+0xbb/0xc0
43 [<ffffffff812b6139>] __cfq_exit_single_io_context+0xe9/0x120
44 [<ffffffff812b626c>] cfq_exit_queue+0x7c/0x190
45 [<ffffffff812a5046>] elevator_exit+0x36/0x60
[all …]
|
| /Documentation/devicetree/bindings/serial/ |
| D | renesas,scif.yaml | 49 - renesas,scif-r8a774a3 # RZ/G2M v3.0
262 reg = <0xe6e60000 64>;
267 dmas = <&dmac0 0x29>, <&dmac0 0x2a>, <&dmac1 0x29>, <&dmac1 0x2a>;
|
| /Documentation/devicetree/bindings/power/supply/ |
| D | cw2015_battery.yaml | 61 #size-cells = <0>;
65 reg = <0x62>;
67 0x17 0x67 0x80 0x73 0x6E 0x6C 0x6B 0x63
68 0x77 0x51 0x5C 0x58 0x50 0x4C 0x48 0x36
69 0x15 0x0C 0x0C 0x19 0x5B 0x7D 0x6F 0x69
70 0x69 0x5B 0x0C 0x29 0x20 0x40 0x52 0x59
71 0x57 0x56 0x54 0x4F 0x3B 0x1F 0x7F 0x17
72 0x06 0x1A 0x30 0x5A 0x85 0x93 0x96 0x2D
73 0x48 0x77 0x9C 0xB3 0x80 0x52 0x94 0xCB
74 0x2F 0x00 0x64 0xA5 0xB5 0x11 0xF0 0x11
|
| /Documentation/devicetree/bindings/ata/ |
| D | ceva,ahci-1v84.yaml | 44 OOB timing value for COMINIT parameter for port 0.
56 OOB timing value for COMWAKE parameter for port 0.
68 Burst timing value for COM parameter for port 0.
80 Retry interval timing value for port 0.
175 reg = <0xfd0c0000 0x200>;
177 interrupts = <0 133 IRQ_TYPE_LEVEL_HIGH>;
179 ceva,p0-cominit-params = /bits/ 8 <0x0F 0x25 0x18 0x29>;
180 ceva,p0-comwake-params = /bits/ 8 <0x04 0x0B 0x08 0x0F>;
181 ceva,p0-burst-params = /bits/ 8 <0x0A 0x08 0x4A 0x06>;
182 ceva,p0-retry-params = /bits/ 16 <0x0216 0x7F06>;
[all …]
|
| /Documentation/devicetree/bindings/mfd/ |
| D | ti-lmu.txt | 21 0x11 for LM3632
22 0x29 for LM3631
23 0x36 for LM3633
24 0x63 for LM3695
25 0x11 for LM36274
67 reg = <0x29>;
110 led-sources = <0 1>;
118 reg = <0x11>;
125 enable-gpios = <&pioC 0 GPIO_ACTIVE_HIGH>,
151 pwms = <&pwm0 0 10000 0>; /* pwm number, period, polarity */
[all …]
|
| /Documentation/devicetree/bindings/regulator/ |
| D | lm363x-regulator.txt | 35 reg = <0x29>;
77 reg = <0x11>;
|
| /Documentation/devicetree/bindings/gpio/ |
| D | gpio-xgene-sb.txt | 25 0 = active high
30 - first cell is 0-N corresponding for EXT_INT_0 to EXT_INT_N.
40 reg = <0x0 0x17001000 0x0 0x400>;
43 interrupts = <0x0 0x28 0x1>,
44 <0x0 0x29 0x1>,
45 <0x0 0x2a 0x1>,
46 <0x0 0x2b 0x1>,
47 <0x0 0x2c 0x1>,
48 <0x0 0x2d 0x1>;
|
| /Documentation/usb/ |
| D | gadget_hid.rst | 29 .subclass = 0, /* No subclass */
34 0x05, 0x01, /* USAGE_PAGE (Generic Desktop) */
35 0x09, 0x06, /* USAGE (Keyboard) */
36 0xa1, 0x01, /* COLLECTION (Application) */
37 0x05, 0x07, /* USAGE_PAGE (Keyboard) */
38 0x19, 0xe0, /* USAGE_MINIMUM (Keyboard LeftControl) */
39 0x29, 0xe7, /* USAGE_MAXIMUM (Keyboard Right GUI) */
40 0x15, 0x00, /* LOGICAL_MINIMUM (0) */
41 0x25, 0x01, /* LOGICAL_MAXIMUM (1) */
42 0x75, 0x01, /* REPORT_SIZE (1) */
[all …]
|
| /Documentation/devicetree/bindings/media/ |
| D | qcom,msm8996-venus.yaml | 114 reg = <0x00c00000 0xff000>;
122 iommus = <&venus_smmu 0x00>,
123 <&venus_smmu 0x01>,
124 <&venus_smmu 0x0a>,
125 <&venus_smmu 0x07>,
126 <&venus_smmu 0x0e>,
127 <&venus_smmu 0x0f>,
128 <&venus_smmu 0x08>,
129 <&venus_smmu 0x09>,
130 <&venus_smmu 0x0b>,
[all …]
|
| /Documentation/devicetree/bindings/leds/ |
| D | leds-lp50xx.yaml | 38 lp5009/12 - 0x14, 0x15, 0x16, 0x17
39 lp5018/24 - 0x28, 0x29, 0x2a, 0x2b
40 lp5030/36 - 0x30, 0x31, 0x32, 0x33
53 const: 0
56 '^multi-led@[0-9a-f]$':
74 const: 0
77 "^led@[0-9a-f]+$":
102 #size-cells = <0>;
106 reg = <0x14>;
108 #size-cells = <0>;
[all …]
|
| /Documentation/arch/arm64/ |
| D | tagged-pointers.rst | 23 an address tag of 0x00, unless the application enables the AArch64
35 - the frame pointer (x29) and frame records, e.g. when interpreting
|
12