Searched +full:0 +full:x48 (Results 1 – 25 of 94) sorted by relevance
1234
| /Documentation/devicetree/bindings/iio/proximity/ |
| D | murata,irsd200.yaml | 22 - 0x48
23 - 0x49
25 When the AD pin is connected to GND, the slave address is 0x48.
26 When the AD pin is connected to VDD, the slave address is 0x49.
51 #size-cells = <0>;
55 reg = <0x48>;
|
| /Documentation/devicetree/bindings/input/touchscreen/ |
| D | melfas_mip4.txt | 5 - reg: I2C slave address of the chip (0x48 or 0x34)
15 reg = <0x48>;
17 interrupts = <0 IRQ_TYPE_EDGE_FALLING>;
18 ce-gpios = <&gpio 0 GPIO_ACTIVE_HIGH>;
|
| D | max11801-ts.txt | 13 reg = <0x48>;
|
| D | sx8654.txt | 19 reg = <0x48>;
|
| D | samsung,s6sy761.yaml | 42 #size-cells = <0>;
46 reg = <0x48>;
|
| /Documentation/devicetree/bindings/reset/ |
| D | zynq-reset.txt | 9 - reg: SLCR offset and size taken via syscon <0x200 0x48>
19 reg = <0x200 0x48>;
25 0 : soft reset
65 544: a9 reset 0
|
| /Documentation/hwmon/ |
| D | tmp464.rst | 12 Addresses scanned: I2C 0x48, 0x49, 0x4a and 0x4b
20 Addresses scanned: I2C 0x48, 0x49, 0x4a and 0x4b
|
| D | lm92.rst | 10 Addresses scanned: I2C 0x48 - 0x4b
|
| /Documentation/devicetree/bindings/regulator/ |
| D | pv88090.txt | 5 - reg: I2C slave address, usually 0x48.
20 reg = <0x48>;
|
| /Documentation/devicetree/bindings/hwmon/ |
| D | lm75.yaml | 81 #size-cells = <0>;
85 reg = <0x48>;
93 #size-cells = <0>;
97 reg = <0x48>;
|
| D | adi,ltc2991.yaml | 33 const: 0
38 "^channel@[0-3]$":
48 minimum: 0
86 #size-cells = <0>;
90 reg = <0x48>;
97 #size-cells = <0>;
101 #size-cells = <0>;
104 reg = <0x48>;
107 channel@0 {
108 reg = <0x0>;
[all …]
|
| D | st,stts751.yaml | 34 #size-cells = <0>;
38 reg = <0x48>;
|
| D | ti,tmp102.yaml | 38 #size-cells = <0>;
42 reg = <0x48>;
|
| D | ti,tmp108.yaml | 33 const: 0
50 #size-cells = <0>;
54 reg = <0x48>;
58 pinctrl-0 = <&tmp_alrt>;
60 #thermal-sensor-cells = <0>;
|
| /Documentation/devicetree/bindings/power/supply/ |
| D | cw2015_battery.yaml | 61 #size-cells = <0>;
65 reg = <0x62>;
67 0x17 0x67 0x80 0x73 0x6E 0x6C 0x6B 0x63
68 0x77 0x51 0x5C 0x58 0x50 0x4C 0x48 0x36
69 0x15 0x0C 0x0C 0x19 0x5B 0x7D 0x6F 0x69
70 0x69 0x5B 0x0C 0x29 0x20 0x40 0x52 0x59
71 0x57 0x56 0x54 0x4F 0x3B 0x1F 0x7F 0x17
72 0x06 0x1A 0x30 0x5A 0x85 0x93 0x96 0x2D
73 0x48 0x77 0x9C 0xB3 0x80 0x52 0x94 0xCB
74 0x2F 0x00 0x64 0xA5 0xB5 0x11 0xF0 0x11
|
| /Documentation/devicetree/bindings/sound/ |
| D | cs4349.txt | 17 reg = <0x48>;
18 reset-gpios = <&gpio 54 0>;
|
| D | cirrus,cs4270.yaml | 27 const: 0
53 #size-cells = <0>;
57 reg = <0x48>;
|
| /Documentation/devicetree/bindings/media/i2c/ |
| D | onnn,mt9m114.yaml | 25 - 0x48
26 - 0x5d
91 #size-cells = <0>;
95 reg = <0x48>;
97 clocks = <&clk24m 0>;
|
| /Documentation/devicetree/bindings/timer/ |
| D | jcore,pit.txt | 22 reg = < 0x200 0x30 0x500 0x30 >;
23 interrupts = < 0x48 >;
|
| /Documentation/translations/zh_CN/dev-tools/ |
| D | ubsan.rst | 28 CPU: 0 PID: 0 Comm: swapper Not tainted 4.4.0-rc1+ #26
33 [<ffffffff815e6cd6>] dump_stack+0x45/0x5f
34 [<ffffffff8163a5ed>] ubsan_epilogue+0xd/0x40
35 [<ffffffff8163ac2b>] __ubsan_handle_shift_out_of_bounds+0xeb/0x130
36 [<ffffffff815f0001>] ? radix_tree_gang_lookup_slot+0x51/0x150
37 [<ffffffff8173c586>] _mix_pool_bytes+0x1e6/0x480
38 [<ffffffff83105653>] ? dmi_walk_early+0x48/0x5c
39 [<ffffffff8173c881>] add_device_randomness+0x61/0x130
40 [<ffffffff83105b35>] ? dmi_save_one_device+0xaa/0xaa
41 [<ffffffff83105653>] dmi_walk_early+0x48/0x5c
[all …]
|
| /Documentation/dev-tools/ |
| D | ubsan.rst | 24 CPU: 0 PID: 0 Comm: swapper Not tainted 4.4.0-rc1+ #26
29 [<ffffffff815e6cd6>] dump_stack+0x45/0x5f
30 [<ffffffff8163a5ed>] ubsan_epilogue+0xd/0x40
31 [<ffffffff8163ac2b>] __ubsan_handle_shift_out_of_bounds+0xeb/0x130
32 [<ffffffff815f0001>] ? radix_tree_gang_lookup_slot+0x51/0x150
33 [<ffffffff8173c586>] _mix_pool_bytes+0x1e6/0x480
34 [<ffffffff83105653>] ? dmi_walk_early+0x48/0x5c
35 [<ffffffff8173c881>] add_device_randomness+0x61/0x130
36 [<ffffffff83105b35>] ? dmi_save_one_device+0xaa/0xaa
37 [<ffffffff83105653>] dmi_walk_early+0x48/0x5c
[all …]
|
| /Documentation/devicetree/bindings/iio/cdc/ |
| D | adi,ad7150.yaml | 60 #size-cells = <0>;
64 reg = <0x48>;
|
| /Documentation/devicetree/bindings/iio/temperature/ |
| D | ti,tmp117.yaml | 44 #size-cells = <0>;
48 reg = <0x48>;
|
| /Documentation/devicetree/bindings/mfd/ |
| D | palmas.txt | 37 reg = <0x48>
42 ti,mux-pad1 = <0>;
43 ti,mux-pad2 = <0>;
46 #size-cells = <0>;
|
| /Documentation/devicetree/bindings/display/ |
| D | repaper.txt | 27 reg = <0x48>;
28 #thermal-sensor-cells = <0>;
33 polling-delay-passive = <0>;
34 polling-delay = <0>;
39 papirus27@0{
41 reg = <0>;
45 panel-on-gpios = <&gpio 23 0>;
46 border-gpios = <&gpio 14 0>;
47 discharge-gpios = <&gpio 15 0>;
48 reset-gpios = <&gpio 24 0>;
[all …]
|
1234