Searched +full:0 +full:x58000000 (Results 1 – 5 of 5) sorted by relevance
| /Documentation/devicetree/bindings/gpu/ |
| D | nvidia,gk20a.txt | 46 reg = <0x0 0x57000000 0x0 0x01000000>, 47 <0x0 0x58000000 0x0 0x01000000>; 64 reg = <0x0 0x57000000 0x0 0x01000000>, 65 <0x0 0x58000000 0x0 0x01000000>; 82 reg = <0x0 0x17000000 0x0 0x1000000>, 83 <0x0 0x18000000 0x0 0x1000000>; 100 reg = <0x17000000 0x1000000>, 101 <0x18000000 0x1000000>;
|
| /Documentation/devicetree/bindings/pci/ |
| D | faraday,ftpci100.yaml | 18 The host controller appear on the PCI bus with vendor ID 0x159b (Faraday 19 Technology) and product ID 0x4321. 34 interrupt-map-mask = <0xf800 0 0 7>; 36 <0x4800 0 0 1 &pci_intc 0>, /* Slot 9 */ 37 <0x4800 0 0 2 &pci_intc 1>, 38 <0x4800 0 0 3 &pci_intc 2>, 39 <0x4800 0 0 4 &pci_intc 3>, 40 <0x5000 0 0 1 &pci_intc 1>, /* Slot 10 */ 41 <0x5000 0 0 2 &pci_intc 2>, 42 <0x5000 0 0 3 &pci_intc 3>, [all …]
|
| D | nvidia,tegra20-pcie.txt | 27 - cell 0 specifies the bus and device numbers of the root port: 30 - cell 1 denotes the upper 32 address bits and should be 0 45 - 0x81000000: I/O memory region 46 - 0x82000000: non-prefetchable memory region 47 - 0xc2000000: prefetchable memory region 73 - pinctrl-0: phandle for the default/active state of pin configurations. 104 - If lanes 0 to 3 are used: 150 - Root port 0 uses 4 lanes, root port 1 is unused. 158 "pcie-N": where N ranges from 0 to the value specified in nvidia,num-lanes. 171 reg = <0x80003000 0x00000800 /* PADS registers */ [all …]
|
| /Documentation/devicetree/bindings/memory-controllers/ |
| D | nvidia,tegra20-mc.yaml | 48 const: 0 69 reg = <0x7000f000 0x400>, /* Controller registers */ 70 <0x58000000 0x02000000>; /* GART aperture */ 74 interrupts = <0 77 4>; 76 #iommu-cells = <0>;
|
| /Documentation/devicetree/bindings/display/ti/ |
| D | ti,omap-dss.txt | 50 reg = <0x58000000 0x80>; 61 reg = <0x58001000 0x1000>; 70 reg = <0x58006000 0x200>, 71 <0x58006200 0x100>, 72 <0x58006300 0x100>, 73 <0x58006400 0x1000>; 99 tfp410: encoder@0 { 101 gpios = <&gpio1 0 GPIO_ACTIVE_LOW>; /* 0, power-down */ 104 pinctrl-0 = <&tfp410_pins>; 108 #size-cells = <0>; [all …]
|