Searched full:ac (Results 1 – 25 of 101) sorted by relevance
12345
| /Documentation/devicetree/bindings/power/supply/ |
| D | x-powers,axp20x-ac-power-supply.yaml | 4 $id: http://devicetree.org/schemas/power/supply/x-powers,axp20x-ac-power-supply.yaml#
7 title: AXP20x AC power-supply
10 The AXP20X can read the current current and voltage supplied by AC by
12 tell if an AC power supply is present and usable. AXP813/AXP803 are
25 - const: x-powers,axp202-ac-power-supply
26 - const: x-powers,axp221-ac-power-supply
28 - const: x-powers,axp803-ac-power-supply
29 - const: x-powers,axp813-ac-power-supply
30 - const: x-powers,axp813-ac-power-supply
|
| D | bq24735.yaml | 24 description: AC adapter plug event interrupt
27 ti,ac-detect-gpios:
30 This GPIO is optionally used to read the AC adapter status. This is a Host GPIO
32 Note: for backwards compatibility reasons, the GPIO must be active on AC adapter
33 absence despite ACOK being active (high) on AC adapter presence.
68 If 'interrupts' is not specified, poll AC adapter presence with this interval (milliseconds).
87 ti,ac-detect-gpios = <&gpio 72 0x1>;
|
| D | ti,lp8727.yaml | 29 '^(ac|usb)$':
32 description: USB/AC charging parameters
36 - ac
76 /* AC charger: 5% EOC and 500mA charging current */
77 ac {
78 charger-type = "ac";
|
| D | tps65217-charger.yaml | 26 - const: AC
41 interrupt-names = "USB", "AC";
|
| D | bq2515x.yaml | 33 ac-detect-gpios:
35 GPIO used for connecting the bq2515x device PG (AC Detect)
86 ac-detect-gpios = <&gpio1 28 GPIO_ACTIVE_HIGH>;
|
| /Documentation/ABI/testing/ |
| D | sysfs-devices-platform-ACPI-TAD | 11 BIT(0): AC wakeup implemented if set
16 BIT(5): The AC timer wakes up from S4 if set
17 BIT(6): The AC timer wakes up from S5 if set
28 (RW) The AC alarm timer value.
30 Reads return the current AC alarm timer value in seconds or
31 "disabled", if the AC alarm is not set to wake up the system.
33 Write a new AC alarm timer value in seconds or "disabled" to it
34 to set the AC alarm timer or to disable it, respectively.
36 If the AC alarm timer is set through this attribute and it
45 (RW) The AC alarm expired timer wake policy (see ACPI 6.2,
[all …]
|
| D | sysfs-platform-wilco-ec | 5 Boot on AC is a policy which makes the device boot from S5
6 when AC power is connected. This is useful for users who
45 supplied to the port when on AC or if battery is > 50%.
48 to the port when on AC. Else no power is supplied.
|
| D | sysfs-bus-iio-adc-ad7192 | 5 This attribute, if available, is used to enable the AC
6 excitation mode found on some converters. In ac excitation mode,
|
| D | sysfs-class-power-wilco | 16 primarily use their Chromebook while connected to AC.
|
| D | sysfs-class-power-twl4030 | 24 Changing mode for 'ac' port.
|
| /Documentation/devicetree/bindings/sound/ |
| D | cs43130.txt | 31 - cirrus,ac-measure:
32 Boolean, define to enable headphone AC impedance measurement.
33 DC impedance must also be enabled for AC impedance measurement.
39 - cirrus,ac-freq:
40 Define the frequencies at which to measure HP AC impedance.
64 cirrus,ac-measure;
66 cirrus,ac-freq = /bits/ 16 <24 43 93 200 431 928 2000 4309 9283 20000>;
|
| D | arm,pl041.yaml | 14 peripheral that provides communication with an audio CODEC using the AC-link
|
| /Documentation/admin-guide/media/ |
| D | cx88-cardlist.rst | 79 - 18ac:db00
87 - 18ac:d810, 18ac:d800
103 - 18ac:db10, 18ac:db11
131 - 18ac:d820
143 - 18ac:d500
195 - 18ac:db50, 18ac:db54
203 - 18ac:db40, 18ac:db44
255 - 18ac:d530
275 - 18ac:db30
279 - 18ac:d610
[all …]
|
| D | cx23885-cardlist.rst | 35 - 18ac:d500
59 - 18ac:d618
63 - 18ac:db78
195 - 18ac:db98
|
| D | dvb-usb-az6027-cardlist.rst | 22 - 0ccd:10ac
|
| /Documentation/devicetree/bindings/display/tilcdc/ |
| D | panel.txt | 6 - ac-bias: AC Bias Pin Frequency
7 - ac-bias-intrpt: AC Bias Pin Transitions per Interrupt
40 ac-bias = <255>;
41 ac-bias-intrpt = <0>;
|
| /Documentation/devicetree/bindings/display/ |
| D | cirrus,clps711x-fb.txt | 12 - ac-prescale : LCD AC bias frequency. This frequency is the required
13 AC bias frequency for a given manufacturer's LCD plate.
31 ac-prescale = <17>;
|
| /Documentation/arch/x86/ |
| D | buslock.rst | 31 #AC exception for split lock detection
35 Alignment Check (#AC) exception when a split lock operation is attempted.
47 The kernel #AC and #DB handlers handle bus lock based on the kernel
51 |split_lock_detect=|#AC for split lock |#DB for bus lock |
65 | |supported, warn in #AC | |
70 | |supported, fatal in #AC | |
|
| /Documentation/driver-api/memory-devices/ |
| D | ti-emif.rst | 32 functions of the driver includes re-configuring AC timing
42 - Device AC timings: 'struct lpddr2_timings' and 'struct lpddr2_min_tck'
|
| /Documentation/devicetree/bindings/clock/ |
| D | brcm,bcm63268-timer-clocks.yaml | 35 timer_clk: clock-controller@100000ac {
|
| D | qcom,gcc-msm8974.yaml | 30 - qcom,gcc-msm8974pro-ac
|
| /Documentation/devicetree/bindings/regulator/ |
| D | richtek,rt5190a-regulator.yaml | 17 It also supports mute AC OFF depop sound and quick setting storage while
50 noise during AC power turned off in the modern TV system design.
|
| /Documentation/hwmon/ |
| D | bel-pfe.rst | 33 1100 Watt AC to DC power-factor-corrected (PFC) power supply.
38 3000 Watt AC/DC power-factor-corrected (PFC) and DC-DC power supply.
|
| /Documentation/devicetree/bindings/mfd/ |
| D | x-powers,axp152.yaml | 258 ac-power:
259 $ref: /schemas/power/supply/x-powers,axp20x-ac-power-supply.yaml#
344 ac_power_supply: ac-power {
345 compatible = "x-powers,axp202-ac-power-supply";
|
| D | ene-kb930.yaml | 44 mains: ac-adapter {
|
12345