Searched full:als (Results 1 – 21 of 21) sorted by relevance
| /Documentation/devicetree/bindings/leds/ |
| D | leds-lm3532.txt | 31 Optional properties if ALS mode is used:
32 - ti,als-vmin - Minimum ALS voltage defined in Volts
33 - ti,als-vmax - Maximum ALS voltage defined in Volts
34 Per the data sheet the max ALS voltage is 2V and the min is 0V
41 - ti,als-avrg-time-us - Determines the length of time the device needs to
42 average the two ALS inputs. This is only used if
45 - ti,als-input-mode - Determines how the device uses the attached ALS
56 if the LED strings are controlled by the ALS.
59 0x01 - LED strings are ALS controlled
80 ti,als-vmin = <0>;
[all …]
|
| /Documentation/misc-devices/ |
| D | bh1770glc.rst | 21 ALS and proximity parts operates on their own, but they shares common I2C
23 but ALS side results are used to estimate reliability of the proximity sensor.
25 ALS produces 16 bit lux values. The chip contains interrupt logic to produce
30 8 bit. Driver supports only one channel. Driver uses ALS results to estimate
31 reliability of the proximity results. Thus ALS is always running while
|
| D | apds990x.rst | 19 APDS990x is a combined ambient light and proximity sensor. ALS and proximity
20 functionality are highly connected. ALS measurement path must be running
23 ALS produces raw measurement values for two channels: Clear channel
34 ALS contains 4 different gain steps. Driver automatically
|
| /Documentation/ABI/testing/ |
| D | sysfs-class-backlight-driver-lm3533 | 6 Get the ALS output channel used as input in
7 ALS-current-control mode (0, 1), where:
19 Enable ALS-current-control mode (0, 1).
|
| D | sysfs-class-led-driver-lm3533 | 6 Set the ALS output channel to use as input in
7 ALS-current-control mode (1, 2), where:
19 Enable ALS-current-control mode (0, 1).
|
| D | sysfs-bus-iio-light-lm3533-als | 52 These values correspond to the ALS-mapper target registers for
53 ALS-mapper Y + 1.
|
| D | sysfs-bus-iio-light-tsl2772 | 5 Causes an internal calibration of the als gain trim
|
| D | sysfs-bus-iio-light-tsl2583 | 5 This property causes an internal calibration of the als gain trim
|
| /Documentation/devicetree/bindings/iio/light/ |
| D | liteon,ltr390.yaml | 7 title: Lite-On LTR390 ALS and UV Sensor
10 The Lite-On LTR390 is an ALS (Ambient Light Sensor) and a UV sensor in a
|
| D | veml6030.yaml | 7 title: VEML6030 Ambient Light Sensor (ALS)
17 can get the ALS and White channel reading from IIO raw interface.
|
| D | capella,cm3605.yaml | 18 This ALS and proximity sensor was one of the very first deployed in mobile
29 ASET line (drive low to activate the ALS, should be flagged
|
| D | tsl2583.yaml | 7 title: AMS/TAOS Ambient Light Sensor (ALS)
|
| D | sharp,gp2ap020a00f.yaml | 7 title: Sharp GP2AP020A00F I2C Proximity/ALS sensor
|
| D | st,vl6180.yaml | 7 title: STMicro VL6180 ALS, range and proximity sensor
|
| D | amstaos,tsl2591.yaml | 7 title: AMS/TAOS TSL2591 Ambient Light Sensor (ALS)
|
| D | avago,apds9300.yaml | 7 title: Avago Gesture/RGB/ALS/Proximity sensors
|
| D | tsl2772.yaml | 7 title: AMS/TAOS Ambient Light Sensor (ALS) and Proximity Detector
|
| D | upisemi,us5182.yaml | 7 title: UPISEMI us5182d I2C ALS and Proximity sensor
|
| /Documentation/filesystems/ |
| D | afs.rst | 211 111416553 --als--v 0 0 \_ rxrpc: afs@CAMBRIDGE.REDHAT.COM
|
| /Documentation/admin-guide/media/ |
| D | bttv.rst | 623 - LR50 rev. Q ("PARTS: 7031505116), Tuner wurde als Nr. 5 erkannt, Eingänge
|
| /Documentation/sound/ |
| D | alsa-configuration.rst | 685 Module for Diamond Technologies DT-019X / Avance Logic ALS-007 (PnP
|